基於散佈式耦合饋入架構之可開關式帶通濾波器

以作者查詢圖書館館藏

、以作者查詢臺灣博碩士

、以作者查詢全國書目

、勘誤回報

、線上人數：57

、訪客IP：18.191.176.81

姓名

吳紹輔(Shao-Fu Wu) 查詢紙本館藏

畢業系所

電機工程學系

論文名稱

基於散佈式耦合饋入架構之可開關式帶通濾波器

相關論文

★ 應用於微波之多頻帶通濾波器之設計	★ 使用可開關式帶通濾波器之低相位雜訊雙頻振盪器研製
★ 共平面波導饋入槽孔偶極天線之寬頻與多頻應用	★ 可具任意通帶之可調式多工器
★ 利用非對稱步階式阻抗設計寬通帶寬止帶雙工器	★ 共平面波導饋入之寬頻雙圓極化天線
★ 基於多共振路徑所設計之印刷式多頻帶天線	★ 四通道可切換式帶通濾波器之研究
★ 雙模態寬阻帶之基板合成波導濾波器	★ 微小化倍頻壓抑直交分合波器之研製
★ 可繞式小型偶極天線之研製	★ 使用多重模態共振器實現多功能帶通濾波器
★ 應用於Radio-over-Fiber系統之超高速微波光子發射器	★ 使用長饋入線架構研製小型且具有高隔絕度的多工器
★ 具有寬截止頻帶的帶通濾波器之研製	★ 可調式雙模態帶通濾波器之研究

檔案

[Endnote RIS 格式]

[Bibtex 格式]

[相關文章]

[文章引用]

[完整記錄]

[館藏目錄]

至系統瀏覽論文 ( 永不開放)

摘要(中)

本論文主要為達到在通帶中產生可開關之衰減之目的，並提出兩種電路架構來實現。第一種架構結合了步階式阻抗共振器(Stepped-Impedance resonator, SIR)來縮小電路面積，散佈式耦合饋入架構(Distributing coupling technique)降低負載效應，再加上因為共振器之間電耦合(electrical coupling)架構和磁耦合(magnetic coupling)架構之相位相差大約180度耦合能量大小幾近相等可以產生訊號相消之特性，而置入二極體於共振器上可以達到開關之功能。綜合以上，設計出了第一種滿足設計初衷目的之電路。
第二種架構則利用開路殘段(open stub)可以增加電路選擇度(selectivity)之特性，並結合帶阻濾波器來實現設計目的。其中，帶阻濾波器使用了四分之波長共振器來取代二分之波長共振器，並彎折開路殘段之走線，以讓整體電路可以有較小的尺寸，最後，同樣在帶阻濾波器之共振器上置入二極體，使其有可開關之功能。
在本論文中所設計之電路，由散步式耦合饋入線、電耦合磁耦合架構之帶通濾波器、開路殘段和帶阻濾波器以及二極體結構組成，於本文中將有其電路所有的設計原理、模擬結果與實作結果的探討。

摘要(英)

This thesis presents two circuits to fulfill the purpose of creating a switchable attenuation in the passband. First circuit used stepped impedance resonator to minimize the size and distributing coupling technique to reduce loaded effect. While the phase difference between electrical coupling structure and magnetic coupling structure is 180 degrees and the magnitude of the two structures are almost the same, the signal may be cancelled. Placed pin-diodes on the resonators to let the circuits have the capability of switchable attenuation at the passband.
The second circuit used open stub tapped at the center of λ/2 line resonator to increase the selectivity. And used bandstop filter to create the attenuation at the passband. To minimize the size of bandstop filter, a λ/4 is designed to replace the λ/2 bandstop filter. Finally, placed pin-diodes on the resonators to let the circuits have the capability of switchable attenuation at the passband.
All of the designs, simulations, and measurements are presented and discussed in this thesis. Finally, good agreement is also achieved between simulation and measurement.

關鍵字(中)

★ 帶通濾波器
★ 可開關式
★ 散佈式耦合饋入架構

關鍵字(英)

★ bandpass filter
★ Switchable
★ distributed coupling technique

論文目次

目錄
摘要 ……………………………………………………………………..ii
Abstract ………………………………………………………………...iii
目錄 …………………………………………………………………….iv
圖目錄 …………………………………………………………………vii
表目錄 ………………………………………………………………….xi
第一章緒論 ……………………………………………………………1
1-1 研究動機 …………………………………………………….1
1-2 文獻參考 …………………………………………………….2
1-3 論文架構 …………………………………………………….4
第二章利用電耦合和磁耦合之訊號相消於通帶中產生衰減之可開關式帶通濾波器 …………………………………………………………..5
2-1 利用步階式阻抗共振器架構設計之電耦合與磁耦合帶通濾波器 ……………………………………………………………5
2-1.1 步階式阻抗共振器其基本原理 ……………………...5
2-1.2 耦合饋入結構分析 …………………………………...8
2-1.3 電耦合與磁耦合設計之帶通濾波器 ………………...9
2-2 利用電耦合和磁耦合訊號相消之特性於通帶中產生衰減之帶通濾波器 …………………………………………………..15
2-2.1 電耦合與磁耦合訊號相消之特性 ………………….15
2-2.2 基於此特性設計之帶通濾波器 …………………….16
2-3 利用電耦合和磁耦合訊號相消之特性於通帶中產生衰減之可開關式帶通濾波器 …………………………………………….19
2-3.1 可開關之帶通濾波器架構 ………………………….19
2-3.2 可開關之帶通濾波器其響應分析 ………………….21
2-3.3 於通帶中產生衰減之可開關式帶通濾波器 ……….23
2-3.4 此電路之實作與量測結果 ………………………….25
第三章利用開路殘段和帶阻濾波器所設計之高選擇度可開關式帶通濾波器 …………………………………………………………………28
3-1 利用開路殘段所設計之高選擇度帶通濾波器 ……………28
3-1.1開路殘斷之基本原理 ………………………………...28
3-1.2 利用此架構所設計之高選擇度帶通濾波器 ………..32
3-2 利用開路殘斷和帶阻濾波器設計之帶通濾波器 ………..35
3-2.1 帶阻濾波器之設計原理 …………………………….36
3-2.2 利用開路殘斷和帶阻濾波器設計之帶通濾波器 ….40
3-3 利用開路殘斷和帶阻濾波器設計之可開關式帶通濾波 45
3-3.1 可開關之帶阻濾波器架構 ………………………….46
3-3.2 可開關之帶阻濾波器其響應分析 ………………….47
3-3.3 可開關之帶阻濾波器合併高選擇度帶通濾波器 ….48
3-3.4 此電路之實作與量測結果 ………………………….50
第四章結論 …………………………………………………………..52
參考文獻 ………………………………………………………………53

參考文獻

[1] Y.-L. Lu, C.-X. Hua, and T.-J. Liu, “A novel dual-band filter C-section loaded resonators,” in Proc. Asia-Pacific Microwave Conf., vol. 2, 2015, pp. 1-3.
[2] Y.-C. chang, C.-H. Kao, M.-H. Weng, R.-Y. Yang, “Design of the compact dual-band bandpass filter with high isolation for GPS/WLAN applications,” IEEE Microw. Wireless Compon. Lett., vol. 19, no. 12, pp. 780-782, Dec. 2009
[3] L. Gao, X. Y. Zhang, K. X. Wang, and B.-J. Hu, “Miniaturized dual-band bandpass filter using quarter-wavelength stepped impedance resonators,” in Proc. Asia-Pacific Microwave Conf., 2012, pp. 238-240.
[4] S. Sun, “A dual-band bandpass filter using a single dual-mode ring resonator,” IEEE Microw. Wireless Compon. Lett., vol. 21, no. 6, pp. 298-300, Jun. 2011.
[5] M. Doan, W. Che, and W. Feng, “Novel compact dual-band bandpass filter with multiple transmission zeros and good selectivity,” in Proc. International Conference on Microwave and Millineter Wave Technology(ICMMT), 2012, pp. 1-4.
[6] P.-Y. Chang, Y.-S. Lin, “Electronically switchable microstrip bandpass filter with good selectivity,” in Proc. Asia-Pacific Microwave Conf., 2011, pp. 1158-1574.
[7] J. Xu, “A microstrip switchable filter with four operating modes,” IEEE Microw. Wireless Compon. Lett., vol. 26, no. 2, pp. 101-103, Feb. 2016.

[8] S.-F. Chao, C.-Y. Kuo, W.-C. Lin, and W.-R. Li, “A dual-band switchable bandpass filter using connected-coupling mechanisms,” in Proc. 44th Eur. Microw. Conf., 2014, pp. 941-944.
[9] Z. Brito-Brito, I. Llamas-Garro, G. Navarro-Munoz, J. Perruisseau-Carrier, and Lluis Pradell, “UMS-Wifi switchable bandpass filter,” in Proc. 39th Eur. Microw. Conf., 2009, pp. 125-128.
[10] B. Lui, F. Wei, and X. Shi, “Switchable bandpass filter with two-state with two-state frequency responses,” Electron. Lett., vol. 47, no. 1, pp. 40-41, Jan 2011.
[11] J. Xu, “Compact swithable bandpass filter and its application to switchable diplexer design,” IEEE Microw. Wireless Compon. Lett., vol. 26, no. 1, pp. 13-15, Jan. 2016.
[12] J.-S Hong and M. J. Lancaster, Microstrip Filter for RF/Microwave Application. New York: Wiley, 2001.
[13] J.-R. Lee, J.-H. Cho, and S.-W.S.-Won Yun, “New compact bandpass filter using microstrip λ/4 resonators with open stub inverter,” IEEE Microwave Guided Wave Lett., vol. 10, pp. 526–527, Dec. 2000.
[14] K.Wada, Y. Noguchi, H. Fujumoto, and J. Ishii, “A tapped-line coplanar waveguide bandpass filter with finite attenuation poles,” in Proc. Asia-Pacific Microwave Conf., Dec. 1994, pp. 763–766.
[15] K.Wada and I. Awai, “Realization of tap-feed λ/42 CPW resonator BPF with double attenuation poles,” in Proc. Asia-Pacific Microwave Conf., Dec. 1996, pp. 1127–1131.

[16] K. Wada, Y. Yamamoto, O. Hashimoto, and H. Harada, “A design method of a 2-pole tapped resonator BPF with multiple attenuation poles and its miniaturization,” in Proc. Asia-Pacific Microwave Conf., Nov. 2001, pp. 1111–1114.
[17] L. Zhu and W. Menzel, ‘‘Compact microstrip bandpass filter with two transmission zeros using a stub-tapped half-wavelength line resonator,’’ IEEE Microw. Wireless Compon. Lett., vol. 13, no. 1, pp. 16–18, Jan. 2003.
[18] J. S. Hong and M. J. Lancaster, Microstrip Filter For RF/Microwave Applications. New York, NY, USA: Wiley, 2001.

指導教授

凃文化(Wen-Hua Tu)

審核日期

2019-1-15

推文