冷媒R-134a與潤滑油混合流體於蒸發器含油濃度量測分析; Analysis Lubricant Concentration of R-134a and Lubricant Mixture in Evaporator

NCU Institutional Repository > 工學院 > 機械工程研究所 > 博碩士論文 > Item 987654321/2161

請使用永久網址來引用或連結此文件: http://ir.lib.ncu.edu.tw/handle/987654321/2161

題名:	冷媒R-134a與潤滑油混合流體於蒸發器含油濃度量測分析;Analysis Lubricant Concentration of R-134a and Lubricant Mixture in Evaporator
作者:	劉奕堂;I-Tang Liu
貢獻者:	機械工程研究所
關鍵詞:	冷媒含油濃度;潤滑油;lubricant concentration;lubricant
日期:	2003-07-17
上傳時間:	2009-09-21 11:39:46 (UTC+8)
出版者:	國立中央大學圖書館
摘要:	本文主要以實驗方法分析冷媒R-134a與不同濃度潤滑油混合後，在管徑1.1mm及0.8mm混合物流經蒸發器之含油量變化，分析其冷媒流量與含油濃度之關係，實驗量測含油濃度由1 ~ 5%，質量速度為200 ~ 600 kg/m2s，熱通量為10 kw/m2。本實驗入出口的含油濃度幾乎都會高於計算的局部油含量表示式，其改變的大小主要受到乾度和質量速度的影響，而質量速度愈小增加的量就愈大。本實驗在出口處的局部含油濃度並無預期中的減少，反而有增加的趨勢。造成這樣的結果，可能是本實驗系統的取樣裝置設計不良，由於本實驗所有的潤滑油皆會溶解於液態冷媒中，而取樣時只取到液態的混合物，並沒有取樣到上方的氣態冷媒，才會造成潤滑油濃度增加。 This paper used experimental analysis to R-134a mixture with different concentration of lubricant pass by evaporator in diameter 1.1mm and 0.8mm micro tubes. We analyzed the relation between flow rate of refrigerant and lubricant concentration. We measured lubricant concentration from 1 ~ 5%, mass velocity from 200 ~ 600 kg/m2s and fixed heat flux in 10 kW/m2 . The lubricant concentration of inlet and exit of test section were almost higher than calculated local lubricant concentration correlation. Local lubricant concentration influenced of vapor quality and mass velocity. When we decreased mass velocity, the local lubricant concentration increased. The local lubricant concentration of exit did not satisfy with our expect and trend to increase. To cause this experimental result, it maybe not design optimum of sample device. Due to all of lubricant dissolved in liquid refrigerant and we got the sample of lubricant only included the liquid mixture of refrigerant not included the gas mixture of refrigerant, therefore the lubricant concentration increase.
顯示於類別:	[機械工程研究所] 博碩士論文

文件中的檔案:

檔案	大小	格式	瀏覽次數

在NCUIR中所有的資料項目都受到原著作權保護.

社群 sharing

資料載入中.....