English  |  正體中文  |  简体中文  |  Items with full text/Total items : 65317/65317 (100%)
Visitors : 21373520      Online Users : 240
RC Version 7.0 © Powered By DSPACE, MIT. Enhanced by NTU Library IR team.
Scope Tips:
  • please add "double quotation mark" for query phrases to get precise results
  • please goto advance search for comprehansive author search
  • Adv. Search
    HomeLoginUploadHelpAboutAdminister Goto mobile version


    Please use this identifier to cite or link to this item: http://ir.lib.ncu.edu.tw/handle/987654321/2386


    Title: Sn-3Ag-(0~0.9)Cu銲料迴銲於銅基板後之電化學遷移行為
    Authors: 蘇茂華;Mau-Hwa Su
    Contributors: 機械工程研究所
    Keywords: 錫銀銅銲料;循環;無鉛銲料;陽極動態極化;電化學遷移;electrochemical migration;lead-free solders;SnAgCu solder
    Date: 2004-07-12
    Issue Date: 2009-09-21 11:45:28 (UTC+8)
    Publisher: 國立中央大學圖書館
    Abstract: 摘 要 本研究探討錫-3 銀-X 銅(X=0.0~0.9)銲料迴銲於銅墊上之電化學 遷移行為,將其完全浸泡於不同溶液中,兩銲球間施以2V~3V 直流 偏壓,結果顯示:在去離子水中與硫酸氨溶液中,增加銲料中銅含量 與提高施加偏壓,皆會造成銲料抗電化學遷移能力下降;在松香型助 銲劑、酒精及異丙醇中不發生電化學遷移現象。 在去離子水中的陽極動態極化研究結果顯示:本系統銲料之開路 電位隨著銅含量增加而升高,在1.5VSCE 以上,其陽極電流隨銲料中 的銅含量增加而提高。X 光光電子譜儀分析顯示:迴銲後銲錫表面有 一層SnO2 覆蓋,若銲料中銅含量越高,兩極間析出物中銅的比例隨 之提高;此析出物中銅與銀的含量比例隨遷移時間增長而減少。 錫-3 銀-X 銅(X=0.0~0.9)銲錫在(NH4)2SO4溶液中之電化學遷移比 在去離子水中更嚴重。循環極化分析的第一圈掃描未見Sn-3Ag-0.9Cu 銲錫的鈍化現象,然而在第二圈以上發現銲錫的鈍化現象,且越低的 掃描速率,銲料的鈍化情況越明顯。 Abstract Electrochemical migration behaviors of the Sn-3Ag-XCu(X=0.0~0.9) solders reflowed on Cu pads have been studied. The electrochemical migration resistance of the Sn-3Ag-XCu(X=0.0~0.9) solders at a bias of 2V~3V in DI water or (NH4)2SO4 decreased with increasing Cu content from 0.0 to 0.9 wt% and electrical bias from 2 to 3 V. Sn-3Ag-XCu(X=0.0~0.9) solders displayed no electrochemical migration in rosin mildly activated flux, ethanol or isopropyl alcohol solutions. The anodic potentiodynamic polarization in DI water showed that OCP of Sn-3Ag-XCu(X=0.0~0.9) increased with increasing Cu content. The anodic current of solders increased with increasing Cu content at the same potential above 1.5VSCE. XPS spectra showed that SnO2 oxide covered on the solder balls after reflow. The copper content in the precipitate increased with Cu content in the Sn-3Ag-XCu(X=0.0~0.9) solders. The ratio of Ag and Cu content in precipitate decreased with migration time. The electrochemical migration of Sn-3Ag-XCu(X=0.0~0.9) is faster in 0.01M (NH4)2SO4 than in DI water. Passivation was absent on the first cycle of the cyclic voltammorgrace, however, it was present on the cycle higher than the second. The lower scanning rate, the more pronounced is the passivation.
    Appears in Collections:[機械工程研究所] 博碩士論文

    Files in This Item:

    File SizeFormat
    0KbUnknown406View/Open


    All items in NCUIR are protected by copyright, with all rights reserved.

    社群 sharing

    ::: Copyright National Central University. | 國立中央大學圖書館版權所有 | 收藏本站 | 設為首頁 | 最佳瀏覽畫面: 1024*768 | 建站日期:8-24-2009 :::
    DSpace Software Copyright © 2002-2004  MIT &  Hewlett-Packard  /   Enhanced by   NTU Library IR team Copyright ©   - Feedback  - 隱私權政策聲明