使用化學沉澱法合成新式導質子型固態氧 化物燃料電池陰極材料Ba0.5Sr0.5Fe1-xCuxO3-δ;Synthesis of Novel Cathode Materials Ba0.5Sr0.5Fe1-xCuxO3-δ for P-SOFC by Chemical Precipitation Method

NCU Institutional Repository > 工學院 > 材料科學與工程研究所 > 博碩士論文 > Item 987654321/65330

jsp.display-item.identifier=請使用永久網址來引用或連結此文件: http://ir.lib.ncu.edu.tw/handle/987654321/65330

题名:	使用化學沉澱法合成新式導質子型固態氧化物燃料電池陰極材料Ba0.5Sr0.5Fe1-xCuxO3-δ;Synthesis of Novel Cathode Materials Ba0.5Sr0.5Fe1-xCuxO3-δ for P-SOFC by Chemical Precipitation Method
作者:	陳儀安;Chen,Yi-an
贡献者:	材料科學與工程研究所
关键词:	固態氧化物燃料電池;化學沉澱法;陰極;SOFC;Chemical precipitation;cathode
日期:	2014-08-21
上传时间:	2014-10-15 15:06:28 (UTC+8)
出版者:	國立中央大學
摘要:	本研究利用化學沉澱法，製作適用於導氫型固態燃料電池陰極材料Ba0.5Sr0.5Fe1-XCuXO3-δ的先驅物，進而煆燒獲得氧化物粉體，實驗時，經由調配藥品比例，經由調整滴定pH值，前驅粉體的煆燒溫度等因素，研究其結晶性質、表面形貌、熱性質分析、電化學性質等，以評估其作為導質子型固態氧化物燃料電池陰極的可行性。實驗結果顯示唯有在特定之pH值下，其煆燒過後之產物才會形成特定化學劑量比之Ba0.5Sr0.5Fe1-XCuXO3-δ鈣鈦礦型結構，由X光繞射分析儀（XRD）得知，當銅的添加量為0.3以下時，煆燒過後之XRD繞射圖顯示其產物為純的鈣鈦礦結構，但當銅的添加量大於0.4時則開始出現二次相;而隨著Cu添加量增加，氧化物各個繞射訊號皆往低角度偏移，此乃Cu的原子尺寸較Fe大所造成，利用掃描式電子顯微鏡（SEM）觀察其形貌為多孔性結構，隨著煆燒溫度的增加，固體顆粒明顯增大，部分顆粒間介面消失，孔隙度減少，在材料導電度方面銅的添加量為0.2的條件下導電度達最高94.3 S/cm。;Precipitation of carbonates was used to prepare the precursor of Ba0.5Sr0.5Fe1-xCuxO3-δ, which was the potential material for making of the cathode used in the proton-conducting solid oxide fuel cells. In the precipitation process, a solution of nitrates was reacted with the saturated solution of ammonium carbonate by controlling the pH, After filtration,the precipitate was dried and calcined in a furnace controlled at 800, 850, 900, 950, 1000˚C 2 hr to form the oxide. The effects of stoichiometric ratio between Fe/Cu and calcination temperature on the morphology, crystalline structure of the catalysts and cathodic behavior used in P-SOFC were of interest. Examination through field emission scanning electron microscope (FE-SEM) equipped with energy dispersive x-ray analysis (EDS), we could compare the morphology and composition for the powders. Analysis by x-ray diffraction (XRD), we could distinguish the crystal structures. The gravimetrical and thermal properties of various precursors in calcination process were determined by thermal gravimetrical analysis (TGA) and Differential Scanning Calorimeter (DSC). After making the calcined oxides as the cathode catalysts in a single cell, I-V polarization test were conducted to evaluate the electrochemical performance. The result showed that Pure perovskite structure were observed in X-ray diffraction (XRD) measurement with Cu-dopping at X = 0.1 to 0.3. The porosity was determined to be 36.4% by means of Archimedes method.The electrical conductivity of Ba0.5Sr0.5Fe0.8Cu0.2O3-δ reaches the maximum value of 94.3 S/cm at 450 °C, Preliminary results demonstrate that the cobalt-free oxide Ba0.5Sr0.5Fe1-XCuXO3-δ is a very promising cathode material for application in P -SOFC.
显示于类别:	[材料科學與工程研究所 ] 博碩士論文

文件中的档案:

档案	描述	大小	格式	浏览次数
index.html		0Kb	HTML	588	检视/开启

在NCUIR中所有的数据项都受到原著作权保护.

社群 sharing

数据加载中.....