中大機構典藏-NCU Institutional Repository-提供博碩士論文、考古題、期刊論文、研究計畫等下載:Item 987654321/71235
English  |  正體中文  |  简体中文  |  全文筆數/總筆數 : 76645/76646 (100%)
造訪人次 : 39760269      線上人數 : 570
RC Version 7.0 © Powered By DSPACE, MIT. Enhanced by NTU Library IR team.
搜尋範圍 查詢小技巧:
  • 您可在西文檢索詞彙前後加上"雙引號",以獲取較精準的檢索結果
  • 若欲以作者姓名搜尋,建議至進階搜尋限定作者欄位,可獲得較完整資料
  • 進階搜尋


    請使用永久網址來引用或連結此文件: http://ir.lib.ncu.edu.tw/handle/987654321/71235


    題名: 以離心模型模擬離岸風機單樁於飽和砂土 受單向反覆水平側推行為
    作者: 陳亭璁;Chen,Ting-Tsung
    貢獻者: 土木工程學系
    關鍵詞: 地工離心機;風機單樁;單向側推;最小二乘法;Geotechnical centrifuge;Mono-pole foundation;Lateral loading;Least squares method
    日期: 2016-08-29
    上傳時間: 2016-10-13 12:14:02 (UTC+8)
    出版者: 國立中央大學
    摘要: 近年來環保意識崛起,但由於台灣的能源短缺,必須仰賴火力、核能等非再生的發電方法,因此開發再生能源是現今的主要目標。更由於台灣四面環海,所以相當適合發展風力發電。所以如何去評估離岸風機的水平極限承載力,跟多循環載重下,估計單樁基礎的累計傾斜角度與累計水平位移,為本研究的目的。本研究將現地樁基礎進行離心縮尺,於80 g離心重力場下,進行單樁基礎受反覆側向水平力之離心模型試驗,所有側推的高程皆位於地表上34 m處。
    本研究施作PP系列試驗,於飽和砂試體中對於風機模型單樁施加不同大小之單向反覆水平推力並以改變不同施力速度,藉以觀察受反覆水平力下的單樁之樁身位移、樁身旋轉角、樁身彎矩沿深度的分布狀態,並討論不同循環數與水平力大小對單樁基礎的影響,最後並透過使用最小二乘法回歸出樁身彎矩回歸曲線後與實驗量測值比較,並透過古典梁理論推求出樁之土壤反力(p)、樁身剪力(V)、樁身變位(d)以及旋轉角(θ)等方程式。
    試驗結果顯示: (1) 透過將樁身所量測到之樁身殘餘變位、旋轉角便可回歸出一回歸公式,便可利用此回歸式模擬未來行為。(2)古典彈性梁理論及最小二乘法可有效反應出實驗樁身彎矩量的結果。(3)使用人機控制程式時,使用較慢加載速率(0.0015-0.0007)便可以達到較佳的控制效果。(4)最大側推力實驗中發現樁身最大彎矩位置(Z/D_p=1.6)隨側向力的增加,而逐漸下降,而當進行多循環側推時驗後,樁身最大彎矩發生於固定位置(Z/D_p=1.6)。最後利用上述所得到之參數便可對於未來風機單樁設計時作為參考之依據。
    ;Recently, the environmental concerns is rising; due to the energy shortage in Taiwan, we must rely on some power generation methods like firepower, nuclear and other none renewable power generation methods, so the development of renewable energy is the main goal today. Because Taiwan is an island state surrounded by the sea, it′s suitable for the development of wind power. Therefore, it is very important to estimate the ultimate lateral bearing capacity of monopole foundation, and to predict the inclination and permanent horizontal displacement of pile under cyclic lateral loadings.
    In this study, the models were conducted in an acceleration of 80 g by using the NCU geotechnical centrifuge and the model is contained in the rigid container. The lateral load for each test was applied at the elevation of 34 m above the ground surface. PP-series tests were saturation sand models and the pile was subjected to different amplitudes of cyclic lateral load. Then use least squares method to regress moment of the pile. From the theory of beam on elastic foundation can get the formula about physical property of pile.
    From the test results, the following conclusions can be drawn: (1) By use of the measurement pile head displacement and pile head rotation angle can regress the equations. These equations are useful for simulating future pile behavior; (2) the theory of beam on elastic foundation and the least squares method are useful; (3) When doing the test using slowly load speed (120-300 sec/cycle) can have best control; (4) The maximum bending moment occurred at the depth of 1.6 m under the ground surface while the lateral load was 968 kN. The place of maximum bending moment would move downward along the pile with increasing lateral loads.
    顯示於類別:[土木工程研究所] 博碩士論文

    文件中的檔案:

    檔案 描述 大小格式瀏覽次數
    index.html0KbHTML457檢視/開啟


    在NCUIR中所有的資料項目都受到原著作權保護.

    社群 sharing

    ::: Copyright National Central University. | 國立中央大學圖書館版權所有 | 收藏本站 | 設為首頁 | 最佳瀏覽畫面: 1024*768 | 建站日期:8-24-2009 :::
    DSpace Software Copyright © 2002-2004  MIT &  Hewlett-Packard  /   Enhanced by   NTU Library IR team Copyright ©   - 隱私權政策聲明