GPS接收機射頻前端模組之研製; GPS Receiver RF Front-end Module

NCUIR > College of Electrical Engineering & Computer Science > Graduate Institute of Communication Engineering > Electronic Thesis & Dissertation > Item 987654321/8110

Please use this identifier to cite or link to this item: http://ir.lib.ncu.edu.tw/handle/987654321/8110

Title:	GPS接收機射頻前端模組之研製;GPS Receiver RF Front-end Module
Authors:	涂曜麟;Yo-Lin Tuo
Contributors:	通訊工程研究所
Keywords:	接收機;射頻前端;RF Front-end;receiver
Date:	2005-06-16
Issue Date:	2009-09-22 11:18:23 (UTC+8)
Publisher:	國立中央大學圖書館
Abstract:	本論文主要是探討利用共平面波導結構來實現GPS射頻前端接收機模組，其中包含三個部份，分別為天線、帶通濾波器以及低雜訊放大器。天線部分以多頻共振的原理，在不影響增益及方向性前提下，使頻寬由1.5%提升至3%；帶通濾波器則利用慢波（slow wave）結構，使得在頻寬及插入損失之間取得平衡時，尺寸能夠大幅縮小；最後低雜訊放大器則以型共平面波導不連續結構來完成，使得匹配網路更加穩定，並提供16.5dB的增益值。在設計過程中，皆針對結構中每一個重要參數對S參數的影響以及實作的可行性來加以討論，尋找簡易設計的程序，並且對設計時可能遭遇到的問題，以理論的方式分析並提供可行的解決辦法。 In the thesis, a RF front end for GPS receiver is designed using coplanar-waveguide structure. Three parts of the receiver are mainly considered：antenna, band pass filter, and low noise amplifier. Based on the principle of the multi-band resonance, the bandwidth of the antenna is increased for 1.5% to 3%, compared to single patch antenna. Moreover, it is done without sacrificing antenna gain. The filter is designed using slow-wave structure, and therefore the size is reduced significantly. The noise filter is designed using the -type CPW discontinuities, 16.5dB of gain of LNA is obtained. Every effects of important parameters on S-parameter and experiment feasibility are investigated. At the end simple design procedures are presented.
Appears in Collections:	[Graduate Institute of Communication Engineering] Electronic Thesis & Dissertation

Files in This Item:

File	Size	Format

社群 sharing

Loading...