中大機構典藏-NCU Institutional Repository-提供博碩士論文、考古題、期刊論文、研究計畫等下載:Item 987654321/86891
English  |  正體中文  |  简体中文  |  全文筆數/總筆數 : 80990/80990 (100%)
造訪人次 : 41661374      線上人數 : 1782
RC Version 7.0 © Powered By DSPACE, MIT. Enhanced by NTU Library IR team.
搜尋範圍 查詢小技巧:
  • 您可在西文檢索詞彙前後加上"雙引號",以獲取較精準的檢索結果
  • 若欲以作者姓名搜尋,建議至進階搜尋限定作者欄位,可獲得較完整資料
  • 進階搜尋


    請使用永久網址來引用或連結此文件: http://ir.lib.ncu.edu.tw/handle/987654321/86891


    題名: The relationship of kaolinite friction characteristics and temperature changing in submerged conditions
    作者: 陳玉秀;Tu, Tran Ngoc
    貢獻者: 應用地質研究所
    關鍵詞: 旋轉剪切試驗;高嶺土;速度相依性;Rotary shear test;kaolinite;velocity dependency
    日期: 2021-03-05
    上傳時間: 2021-12-07 13:24:01 (UTC+8)
    出版者: 國立中央大學
    摘要: 摘要
    過往研究表明,滑移速度會顯著影響滑山崩滑移帶的強度,而且水對滑
    移帶的影響也被認為是一個關鍵因素。然而,關於此影響的文獻討論仍不足
    夠,且仍在爭論之中。為了更深入地研究滑移速度和排水條件對山崩滑移帶
    強度的影響,本研究以在正向應力為 1 MPa 及較大滑移速度範圍(從 10-7
    m/s
    到 1 m/s)的實驗條件對純高嶺土上進行了一系列旋剪試驗。在徑向排水條件
    下,將試體夾在兩個不透水的圍岩之間以鐵氟龍環包覆,然後將其放入浸水
    容器中。本研究還評估了浸水條件下摩擦特性與溫度變化之間的相關性。結
    果表明,穩態摩擦係數在滑移速度從 10-7
    m/s 到 10-5
    m/s 時到達 0.2,然後在
    10-4
    m/s 時略微上升到 0.26、在 10-3
    m/s 時上升到 0.3、並在 10-2
    m/s 時到達 0.4、
    接下來在 10-1
    m/s 下降至 0.3。而在 1 m/s 的實驗條件下摩擦係數為滑移弱化
    且穩態摩擦係數等於 0.14,這顯示了在浸水條件下之結果不同於先前研究的
    氣乾且飽和條件下的實驗結果。另外在實驗過程中的溫度紀錄為在低滑移速
    度(從 10-7
    m/s 到 10-3
    m/s)下保持在攝氏 25 – 26 度左右,然後在 10-2
    m/s 時
    逐漸增加到攝氏 32 度,接下來在 10-1
    m/s 的速度顯著地升至攝氏 60 度,最後
    以 1 m/s 的速度升至攝氏 75 度。然而,這項研究表明了高嶺土的線性熱膨脹
    是在剪切過程產生的,與軸向位移的變化無關。
    關鍵詞:旋轉剪切試驗、高嶺土、速度相依性、排水條件、溫度測量。;ABSTRACT
    Researches have suggested that slip rates can significantly influence the
    strength of the slip zones of landslides, and the effect of water on the slip zones is
    also proposed as a crucial factor. Nevertheless, efficient reports on this process
    are still limited and are continue being debated. In order to dig deeper into the
    roles of slip rate and drainage condition on the strength of the slip zones of the
    landslides, a series of rotary shear tests were conducted on a wide range of shear
    velocity (from 10-7
    to 1 m/s) with normal stress of 1 MPa on kaolinite clay. For
    the control of radial drainage condition, samples were sandwiched by two
    impermeable-holders and covered by a Teflon ring. The system then being
    submerged into water tank. This research also assesses the correlation between
    the friction characteristics and the temperature changes in the submerged
    condition. The results illustrated that the steady-state friction coefficient reached
    0.2 at a slip rate from 10-7 m/s to 10-5 m/s and followed by a slightly raised to 0.26
    at 10-4 m/s, 0.3 at 10-3 m/s, and reached 0.4 at 10-2 m/s before dropping to 0.3 at
    10-1
    . The friction coefficient at 1 m/s shown the slip-weakening behavior with
    steady-state friction equal 0.14, indicated that the submerged condition is different
    to the dry and saturated conditions from previous studies. Temperature
    measurement results during the tests were maintained at around 25 – 26 degrees
    Celsius at a low slip rate (from 10-7 m/s to 10-3 m/s), then gradually increased to
    32 degrees Celsius at 10-2 m/s, and significantly raised to 60 degrees Celsius at
    10-1 m/s and 75 degrees Celsius at 1 m/s. However, this study proved that the
    linear thermal expansion of kaolinite clay had been created by the shearing
    process, not related to the changing of axial displacement.
    Keywords: Rotary shear test, kaolinite, velocity dependency, drainage
    condition, temperature measurement.
    顯示於類別:[應用地質研究所] 博碩士論文

    文件中的檔案:

    檔案 描述 大小格式瀏覽次數
    index.html0KbHTML73檢視/開啟


    在NCUIR中所有的資料項目都受到原著作權保護.

    社群 sharing

    ::: Copyright National Central University. | 國立中央大學圖書館版權所有 | 收藏本站 | 設為首頁 | 最佳瀏覽畫面: 1024*768 | 建站日期:8-24-2009 :::
    DSpace Software Copyright © 2002-2004  MIT &  Hewlett-Packard  /   Enhanced by   NTU Library IR team Copyright ©   - 隱私權政策聲明