提出設計一款40mm口徑十六倍的狙擊鏡，在狙擊鏡系統中可分為物鏡系統、反轉鏡系統與目鏡系統，將三者分開做設計，設計完成後再將三系統組合成狙擊鏡系統，物鏡系統由0.7度半視角為最大入射角度，焦距為176 mm，入瞳口徑為40 mm，目鏡系統由11.0609度為最大出射半視角角度，焦距為22 mm，出瞳為2.5mm，良視距離為50 mm，其中使用反轉鏡系統以利於人眼做觀察。 我們將對這三系統做波前像差、光學畸變、橫向色差的分析與校正是否達到設計要求，三系統各別設計完成後將三系統組合成狙擊鏡系統其放大倍率為16 X，在完成後，我們再進行一次分析，以驗證成像品質是否符合要求。接著我們將進行公差分析，以確保設計可以進行量產，設計即完成。設計完成後對狙擊鏡瞄準目標物進行修正，根據仰角與風偏影響對目標物的誤差進行修正計算。 ;A design is proposed for a 16x sniper scope with a 40mm objective diameter. The sniper scope system consists of the objective system, the erecting system, and the eyepiece system, which are designed separately and then combined into the sniper scope system. The objective system has a maximum entrance angle of 0.7 degrees (half field of view), a focal length of 176mm, and an entrance pupil diameter of 40mm. The eyepiece system has a maximum exit angle of 11.0609 degrees (half field of view), a focal length of 22mm, an exit pupil diameter of 2.5mm, and a Eye-Relief of 50mm. The use of the erecting system facilitates observation by the human eye. Each system is analyzed and corrected for wavefront aberrations, optical distortion, and lateral chromatic aberration to meet the design requirements. After completing the individual designs of the three systems, they are combined into the sniper scope system with a magnification of 16x. A final analysis is performed to confirm that the imaging quality meets the requirements. Lastly, tolerance analysis is conducted to ensure that the design is suitable for mass production. The design is considered complete. After the design is completed, adjustments are made to the sniper scope to compensate for errors caused by elevation angle and wind deflection when aiming at a target.
