於劇烈震動環境下DVD光碟機聚焦和尋軌誤差的控制

以作者查詢圖書館館藏

、以作者查詢臺灣博碩士

、以作者查詢全國書目

、勘誤回報

、線上人數：72

、訪客IP：3.144.243.25

姓名

蔡依霖(Yi-lin Tsai) 查詢紙本館藏

畢業系所

機械工程學系

論文名稱

於劇烈震動環境下DVD光碟機聚焦和尋軌誤差的控制
(Effective Suppression of Focusing and Tracking Errors for DVD drives in Severe Vibratory Environment)

相關論文

★ TFT-LCD前框卡勾設計之衝擊模擬分析與驗證研究	★ TFT-LCD 導光板衝擊模擬分析及驗證研究
★ 數位機上盒掉落模擬分析及驗證研究	★ 旋轉機械狀態監測-以傳動系統測試平台為例
★ 發射室空腔模態分析在噪音控制之應用暨結構聲輻射效能探討	★ 時頻分析於機械動態訊號之應用
★ VKF階次追蹤之探討與應用	★ 火箭發射多通道主動噪音控制暨三種線上鑑別方式
★ TFT-LCD衝擊模擬分析及驗證研究	★ TFT-LCD掉落模擬分析及驗證研究
★ TFT-LCD螢幕掉落破壞分析驗證與包裝系統設計	★ 主動式火箭發射噪音控制使用可變因子演算法
★ 醫學/動態訊號處理於ECG之應用	★ 光碟機之動態研究與適應性尋軌誤差改善
★ 具新型菲涅爾透鏡之超音波微噴墨器分析與設計	★ 醫用近紅外光光電量測系統之設計與驗証

檔案

[Endnote RIS 格式]

[Bibtex 格式]

[相關文章]

[文章引用]

[完整記錄]

[館藏目錄]

[檢視]

[下載]

本電子論文使用權限為同意立即開放。
已達開放權限電子全文僅授權使用者為學術研究之目的，進行個人非營利性質之檢索、閱讀、列印。
請遵守中華民國著作權法之相關規定，切勿任意重製、散佈、改作、轉貼、播送，以免觸法。

摘要(中)

摘要
在一般情況下，光碟機本身的伺服控制器可以減少些許聚焦及尋軌誤差，然而在車用光碟機上，常受到外在環境的衝擊或振動等干擾，使得光碟機本身的平衡滾珠產生振動，造成光碟機受到外在環境的振動以及平衡滾珠的振動干擾，此時，光碟機的伺服控制器無法抑制這些外界振動的低頻誤差和平衡滾珠振動的高頻誤差，使得光碟機的讀取的性能下降甚至無法讀取資料。有鑑於此，本論文應
用修正型適應性複合伺服控制器(MAHC)和被動式的吸振海綿於車用光碟機之伺服系統來消除低頻和高頻的誤差，進而改善聚焦及尋軌性能，MAHC 包含前饋式及回饋式主動式干擾消除。本研究採用RVSS-FXLMS 架構，此架構由濾波型最小均方（FXLMS）為基礎，並搭配可變收斂因子（RVSS）演算法，依據控制狀態增加FXLMS 之收斂速度及穩定性。實驗結果顯示， MAHC 和被動式的吸振海綿能有效的消除車用光碟機上經由振動干擾產生之聚焦及尋軌誤差。

摘要(英)

ABSTRACT
In a vehicular or portable environment, the DVD drives are apt to be influenced by severe external vibration and vibration caused by the balancing balls of spindle to an extent that the focusing and tracking servo errors increase dramatically. This cause the data reading of DVD drives bad or even failed. In this circumstance, the external vibration may usually cause errors of low frequency, and high-frequency errors result from balancing-ball disturbance. To solve this problem, a modified adaptive hybrid servo control (MAHC), an evolution version from the adaptive hybrid control (AHC), was implemented to aid the original servo control system of DVD drive for error cancellation of low frequency, and the balancing-ball disturbance was absorbed by partition dampers. The MAHC structure, based on the FXLMS with robust variable step-size (RVSS-FXLMS) algorithm, was designed and realized with a DSP board. The experimental results demonstrate that the MAHC and dampers can successfully eliminate focusing and tracking errors and improve the reading performance of DVD drive upon the existing architecture of DVD drive in a vehicular environment.

關鍵字(中)

★ 適應性濾波
★ 光碟機
★ 尋軌誤差
★ 聚焦誤差

關鍵字(英)

★ adaptive filter
★ focusing error
★ tracking error.
★ DVD drives

論文目次

CONTENT
ABSTRACT..................................................I
CONTENT..................................................II
LIST OF FIGURES .........................................IV
Chapter 1 INTRODUCTION ...................................1
1.1 Motivation............................................1
1.2 Literature Survey.....................................3
1.3 Framework ............................................5
Chapter 2 SERVO CONTROL SYSTEM ...........................6
2.1 Optical Pick-up Head System ..........................7
2.2 Focusing Error Signal ................................8
2.3 Tracking Error Signal............................... 11
Chapter 3 THEORETICAL BASIS .............................14
3.1 Adaptive filtering ..................................14
3.2 Least-Mean-Square Adaptation Algorithm ..............16
3.3 FXLMS Adaptive Filtering ............................19
3.4 Robust Variable Step Size Algorithm..................21
3.5 Active Control Structure ............................23
3.5.1 Feedforward control structure......................23
3.5.2 Feedback control structure.........................23
3.5.3 Hybrid control structure...........................25
3.5.4 Modified hybrid control structure..................27
Chapter 4 EXPERIMENTAL RESULT............................30
4.1 Experiment Apparatus and Operation Interface.........30
4.1.1 Vibration platform.................................30
4.1.2 Adjustment circuit.................................31
4.1.3 DSP board and GUI .................................35
4.1.4 Instruments and Hardwares..........................37
4.2 System Identification of Actuators...................39
4.2.1 System identification of focusing actuator.........39
4.2.2 System identification of tracking actuator ........41
4.3 Validation of servo-system Improvement ..............42
4.3.1 Simulation ........................................43
4.3.2 Experimentation ...................................46
4.4 Discussion ..........................................59
Chapter 5 CONCLUSIONS ...................................60
5.1 Concluding Remarks...................................60
5.2 Future works ........................................60
BIBLIOGRAPHY.............................................61

參考文獻

BIBLIOGRAPHY
[Aboulnasr 1997] T. Aboulnasr and K. Mayyas, 1997, “A Robust Variable Step-Size LMS-type
Algorithm: Analysis and Simulation,” IEEE Transactions on Signal Processing, Vol. 45, No.3, pp. 631-639.
[Blu-ray Disk Association 2008] Blu-ray Disk Association, 2008, “What is Blu-Ray Disk,”
http://www.blu-raydisc.com/en/nlmp/Blu-rayGlobal.html
[Chen 2005] Y. D. Chen, C. C. Fuh and P. C. Tung, 2005, “Application of Voice Coil Motors in Active Dynamic Vibration Absorbers,” IEEE Transactions on Magnetics, Vol. 41, No. 3, pp.1149-1154.
[Chang 2006] K. Chang, I. Shim and G. Park 2006,“Adaptive Repetitive Control for an Eccentricity Compensation of Optical Disk Drivers,” IEEE Transaction on Consumer
Electronics, Vol. 52, No. 2, pp. 445-450.
[Chang 2007] C. H. Chang and T. S. Liu, 2007, “LQG Controller for Active Vibration Absorber in
Optical Disk Drive,” IEEE Transactions on Magnetics, Vol. 43, No. 2, pp. 799-801.
[Chen 2002] C. M. Chen, 2002, “Adaptive Focusing Control of DVD Driver System,” Master thesis in Chinese, National Tsing Hua University.
[Chien 2007] C. Chien, 2007, “Adaptive Hybrid Control for DVD Drivers in Vehicle System,”Master thesis in Chinese, National Central University.
[Chen 2006] J. S. Chen, L. C. Yao, J. H. Ho, C. Y. Chen, Y. P. Liu and S. H. Chang, 2006,“Toward the Application of A Mode-Switching Control Law on the Focus and Tracking
Control of An Optical Disk Drive,” National Science Council (NSC94-2213-E007-079).
[Heo 2002] J. W. Heo, J. Chung and J. M. Park, 2002, “Vibration and Noise Reduction of an Optical Disk by Using a Vibration Absorber,” IEEE Transactions on Consumer Electronics,Vol. 48, No. 4, pp. 863-873.
[Haykin 2002] S. Haykin, 2002, “Adaptive Filter Theory,” NJ, Prentice Hall
[Imagawa 2001] S. Imagawa, M. Suzuki, H. Ono and J. Ohya, 2001, “Actuator Control to Suppress Disturbances for 8cm DVD-RAM Video Camera Recorder,” IEEE Transactions on
Consumer Electronics, Vol. 47, No. 3, pp. 528-533.
[Kim 2007] J. Kim, K. S. Lim and S. Kim 2007, “Dynamic Eccentric Error Compensation for Track Dollowing Control of Optical Disk Driver,” IEEE International Symposium on Circuits and Systems, pp. 3808-3811.
[Kwong 1992] R. H. Kwong and E. W. Johnston, 1992, “A Variable Step Size LMS Algorithm,”IEEE Transaction on Signal Processing, Vol. 40, No. 7, pp. 1633-1642.
[Kuo 2003] S. M. Kuo, X. Kong and W. S. Gan, 2003, “Applications of Adaptive Feedback Active Noise Control System,” IEEE Transaction on Control System Technology, Vol. 11, No. 2, pp.216-220.
[Lee 2005] M. N. Lee and K. B. Jin 2005, “An Optimal Tracking Controller Design Based on the Estimation of Tracking Vibration Quantity,” IEEE Transaction on Consumer Electronics,Vol. 51, No. 2, pp. 478-483.
[Liu 2003] S. H. Liu, 2003, “Toward the Application of an Embedded DSP for Seek/Spindle Servo of Optical Disk Drive,” Master thesis in Chinese, National Tsing Hua University.
[Morgan 1980] D. R. Morgan, 1980, “An Analysis of Multiple Correlation Cancellation Loops with a Filter in the Auxiliary Path,” IEEE Transactions on Acoustics, Speech and Signal Processing, ASSP-28, pp. 454-467.
[Streeter 2004] A. D. Streeter, L. R. Ray and R. D. Collier, “Hybrid Feedforward-Feedback Active Noise Control,” Proceedings of the 2004 American Control Conference, pp. 2876-2881.
[Yang 2007] Y. P. Yang, 2007 and J. J. Liu, “Frequency Adaptive Control Technique for Periodic Runout and Wobble Cabcellation in Optical Disk Drivers,” Systemics, Cybernetics and Informatics, Vol. 4, Number 5, pp. 31-35.
[Young 2003] Y. L. Young, 2000, “The Analysis of Focusing and Tracking error signal for DVD drivers,” Master thesis in Chinese, National Tsing Hua University.
[Widrow 1975] B. Widrow, J. R. Glover, J. M. Mccool, J. Kaunitz, C. S. Williams, R. H. Hern, J. R.Zeidler, E. Dong and R. C. Goodlin, 1975, “Adaptive Noise Canceling: Principles and Applications,” Proceedings of the IEEE, Vol. 63, No. 12, pp. 1692-1716.
[Wu 2004] M. D. Wu, 2004, “Dynamic Investigation and Adaptive Tracking Error Improvement of an Optical Disc Drive,” Master thesis in Chinese, National Central University.
[Wei 2005] W. T. Wei, 2005, “Implementation and Application of Adaptive Focusing Control for DVD Drives in Vehicle Systems,” Master thesis in Chinese, National Central University.

指導教授

潘敏俊(Min-chun Pan)

審核日期

2009-5-5

推文