參考文獻 |
[1] J. Miret, L. G. de Vicuna, M. Castilla, J. Matas, and J. M. Guerrero, “Design of an analog quasi-steady-state nonlinear current-mode controller for single-phase active power filter,” IEEE Trans. Industrial Electronics, vol. 56, no. 12, pp. 4872-4881, December 2009.
[2] P. Lohia, M. K. Mishra, K. Karthikeyan, and K. Vasudevan, “A minimally switched control algorithm for three-phase four-leg VSI topology to compensate unbalanced and nonlinear Load,” IEEE Trans. Power Electronics, vol. 23, no. 4, pp. 1935-1944, July 2008.
[3] P. Kanjiya, V. Khadkikar, and H. H. Zeineldin, “A noniterative optimized algorithm for shunt active power filter under distorted and unbalanced supply voltages,” IEEE Trans. Industrial Electronic, vol. 60, no. 12, pp. 5376-5390, December 2013.
[4] R. L. A. Ribeiro, C. C. Azevedo, and R. M. Sousa, “A robust adaptive control strategy of active power filters for power-factor correction, harmonic compensation, and balancing of nonlinear Loads,” IEEE Trans. Power Electronics, vol. 27, no. 2, pp. 718-730, February 2012.
[5] R. Garde, S. Casado, M. Santamaria, and M. Aguado, “Power quality and stability analysis during islanded mode operation in a microgrid based on master-slave configuration,” in Proc. 2015 Saudi Arabia Smart Grid (SASG) IEEE Conf., 2015, pp. 1-8.
[6] M. A. M. Radzi and N. A. Rahim, “Neural network and bandless hysteresis approach to control switched capacitor active power filter for reduction of harmonics,” IEEE Trans. Industrial Electronics, vol. 56, no. 5, pp. 1477-1484, May 2009.
[7] B. Kedjar and K. Al-Haddad, “DSP-based implementation of an LQR with integral action for a three-phase three-wire shunt active power filter,” IEEE Trans. Industrial Electronics, vol. 56, no. 8, pp. 2821-2828, August 2009.
[8] P. Acuna, L. Moran, M. Rivera, J. Dixon, and J. Rodriguez, “Improved active power filter performance for renewable power generation systems,” IEEE Trans. Power Electronics, vol. 29, no.2, pp. 687-694, February 2014.
[9] M. Cirrincione, M. Pucci, G. Vitale, and A. Miraoui, “Current harmonic compensation by a single-phase shunt active power filter controlled by adaptive neural filtering,” IEEE Trans. Industrial Electronics, vol. 56, no. 8, pp. 3128-3143, August 2009.
[10] M. Cirrincione, M. Pucci, G. Vitale, and A. Miraoui, “Types-1 and -2 fuzzy logic controllers-based shunt active filter Id-Iq control strategy with different fuzzy membership functions for power quality improvement using RTDS hardware,” IET Power Electronics, vol. 6, no. 4, pp. 818-833, February 2013.
[11] R. R. Pereira, C. H. da Silva, L. E. B. da Silva, G. Lambert-Torres, and J. O. P. Pinto, “New strategies for application of adaptive filters in active power filters,” IEEE Trans. Industrial Applications, vol. 47, no. 3, pp. 1136-1141, May-June 2001.
[12] M. A. Mulla, C. Rajagopalan, and A. Chowdhury, “Compensation of three-phase diode rectifier with capacitive filter working under unbalanced supply conditions using series hybrid active power filter,” IET Power Electronics, vol. 7, no. 6, pp. 1566-1577, June 2014.
[13] V. Khadkikar, “Enhancing electric power quality using UPQC: a comprehensive overview,” IEEE Trans. Power Electronics, vol. 29, no.2, pp. 2284-2297, May 2012.
[14] M. Cirrincione, M. Pucci, G. Vitale, and A. Miraoui, “Current harmonic compensation by a single-phase shunt active power filter controlled by adaptive neural filtering,” IEEE Trans. Industrial Electronics, vol. 56, no. 8, pp. 3128-3143, August 2009.
[15] H. Yi, F. Zhuo, Y. Zhang, Y. Li, W. Zhan, W. Chen, and J. Liu, “A source-current-detected shunt active power filter control scheme based on vector resonant controller,” IEEE Trans. Industrial Applications, vol. 50, no. 3, pp. 1953-1965, May-June 2010.
[16] Z. X. Zou, K. Zhou, Z. Wang, and M. Cheng, “Frequency-adaptive fractional-order repetitive control of shunt active power filters,” IEEE Trans. Industrial Electronics, vol. 62, no.3, pp. 1659-1688, March 2015.
[17] A. K. Panda and R. Patel, “Adaptive hysteresis and fuzzy logic controlled-based shunt active power filter resistant to shoot-through phenomenon,” IET Power Electronics, vol. 8, no. 10, pp. 1963-1977, September 2015.
[18] S. Rahmani, N. Mendalek, and K. Al-Haddad, “Experimental design of a nonlinear control technique for three-phase shunt active power filter,” IEEE Trans. Industrial Electronics, vol. 57, no. 10, pp. 3364-3375, October 2010.
[19] D. L. Raokhande, D. R. Patil, and U. Gudaru, “Performance of series-shunt power quality compensator under unbalanced & distorted loading conditions,” in Proc. Control Applications (CCA) IEEE Conf., 2013, pp. 1147-1152.
[20] M. Kesler, and E. Ozdemir, “Synchronous-reference-frame-based control method for UPQC under unbalanced and distorted load conditions” IEEE Trans. Industrial Electronics, vol. 58, no. 9, pp. 3967-3975, September. 2011.
[21] C. C. Tsai, H. C. Huang, and S. C. Lin, “Adaptive neural network control of a self-balancing two-wheeled scooter,” IEEE Trans. Industrial Electronics, vol. 57, no. 4, pp. 1420-1428, July 2009.
[22] S. Cong and Y. Liang, “PID-like neural network nonlinear adaptive control for uncertain multivariable motion control systems,” IEEE Trans. Industrial Electronics, vol. 56, no. 10, pp. 3872-3879, October 2009.
[23] F. J. Lin, I. F. Sun, K. J. Yang, and J. K. Chang, “Recurrent fuzzy neural cerebellar model articulation network fault-tolerant control of six-phase permanent magnet synchronous motor position servo drive,” IEEE Trans. Fuzzy Systems, vol. 24, no. 1, pp. 153-167, February 2016.
[24] X. Jin, D. Srinivasan, and R. L. Cheu, “Classification of freeway traffic patterns for incident detection using constructive probabilistic neural networks,” IEEE Trans. Neural Networks, vol. 12, no. 5, pp. 1173-1187, September 2001.
[25] S. J. Hart, R. E. Shaffer, S. L. Rose-Pehrsson, and J. R. McDonald, “Using physics-based modeler outputs to train probabilistic neural networks for unexploded ordnance (UXO) classification in magnetometry surveys,” IEEE Trans. Geoscience and Remote Sensing, vol. 39, no. 4, pp. 797-804, April 2001.
[26] F. J. Lin, Y. S. Huang, K. H. Tan, Z. H. Lu, and Y. R. Chang, “Intelligent-controlled doubly fed induction generator system using PFNN,” Neural Computing and Applications, vol. 22, no. 7, pp. 1695-1712, June 2013.
[27] M. Tripathy, R. P. Maheshwari, and H. K. Verma, “Power transformer differential protection based on optimal probabilistic neural network,” IEEE Trans. Power Delivery, vol. 25, no. 1, pp. 102-112, January 2010.
[28] F. J. Lin and K. H. Tan, “Squirrel-cage induction generator system using probabilistic fuzzy neural network for wind power applications,” in Proc. Fuzzy Systems (FUZZ-IEEE) IEEE Conf, 2015, pp. 1-8.
[29] F. J. Lin, M. S. Huang, P. Y. Yeh, H. C. Tsai, and C. H. Kuan, “DSP-based probabilistic fuzzy neural network control for li-ion battery charger,” IEEE Trans. Power Electronics, vol. 27, no. 8, pp. 3782-3794, August 2012.
[30] H. Y. Pan, C. H. Lee, F. K. Chang, and S. K. Chang, “Construction of 96 asymmetric type 2 fuzzy membership function and application in time series prediction,” in Proc. Machine Learning and Cybernetics IEEE Conf, 2007, pp.2024-2030.
[31] K. H. Cheng, C. F. Hsu, C. M. Lin, T. T. Lee, and C. Li, “Fuzzy neural sliding mode control for dc-dc converters using asymmetric gaussian membership functions,” IEEE Trans. Industrial Electronics, vol. 54, no. 3, pp.1528-1536, June 2007.
[32] F. J. Lin, C. K. Lu, T. H. Ke, B. H. Yang, and Y. R. Chang, “Reactive power control of three-phase grid-connected PV system during grid faults using Takagi–Sugeno–Kang probabilistic fuzzy neural network control,” IEEE Trans. Industrial Electronics, vol. 62, no. 9, pp. 5516-5528, September 2015.
[33] C. F. Juang and J. S. Chen, “A recurrent fuzzy-network-based inverse modeling method for a temperature system control,” IEEE Trans. Systems, Man, and Cybernetics: Systems, vol. 37, no. 3, pp. 410-417, May 2007.
[34] S. H. Park and S. I. Han, “Robust-tracking control for robot manipulator with deadzone and friction using backstepping and RFNN controller,” IET Control Theory & Applications, vol. 5, no. 12, pp. 1397-1417, August 2011.
[35] P. Campolucci, A. Uncini, F. Piazza, and B. D. Rao, “On-line learning algorithms for locally recurrent neural networks,” IEEE Trans. Neural Networks, vol. 10, no. 2, pp. 253-271, March 1999.
[36] K. H. Tan, “Squirrel-cage induction generator system using wavelet Petri fuzzy neural network control for wind power applications,” IEEE Trans. Power Electronics, vol. 31, no. 7, pp. 5242-5254, July 2016.
[37] R. Zurawski and M. Zhou, “Petri nets and industrial applications: a tutorial,” IEEE Tran. Industrial Electronics, vol. 41, no. 6, pp. 567 -583, December 1994.
[38] H. Huang and H. Kirchner, “Formal specification and verification of modular security policy based on colored Petri nets,” IEEE Trans. Dependable and Secure Computing, vol. 8, no. 6, pp. 852-865, November - December 2011.
[39] Y. Y. Du, L. Qi, and M. C. Zhou, “Analysis and application of logical Petri nets to e-commerce systems,” IEEE Trans. Systems, Man, and Cybernetics: System, vol. 44, no. 4, pp. 468-481, April 2014.
[40] T. Nishi and Y. Tanaka, “Petri net decomposition approach for dispatching and conflict-free routing of bidirectional automated guided vehicle systems,” IEEE Trans. Systems, Man, and Cybernetics - Part A: Systems and Humans, vol. 42, no. 2, pp. 1230-1243, September 2012.
[41] Y. Y. Du, C. J. Jiang, and M. C. Zhou, “A petri-net-based correctness analysis of internet stock trading systems,” IEEE Trans. Systems, Man, and Cybernetics, Part C (Applications and Reviews), vol. 38, no. 1, pp. 93-99, January 2008.
[42] Y. S. Huang, Y. S. Weng, and M. C. Zhou, “Modular design of urban traffic-light control systems based on synchronized timed Petri nets,” IEEE Trans. Intelligent Transportation Systems, vol. 15, no. 2, pp. 93-99, April 2014.
[43] H. X. Li and Z. Liu, “A probabilistic neural-fuzzy learning system for stochastic modeling,” IEEE Trans. Fuzzy Systems, vol. 16, no. 4, pp. 898-908, August 2008.
[44] TMS320F28335, TMS320F28334, TMS320F28332, TMS320F28235, TMS320F28234, TMS320F28232 Digital Signal Controllers (DSCs) Data Manual, Texas Instruments, Jun. 2007.
[45] IEEE Recommended Practice and Requirements for Harmonic Control in Electric Power Systems, IEEE Standards Association, 2014. |