螺旋式磨料流動研拋法應用於螺旋表面之研究

NCUIR > Engineering College > Executive Master of Mechanical Engineering > Electronic Thesis & Dissertation > Item 987654321/2634

Please use this identifier to cite or link to this item: http://ir.lib.ncu.edu.tw/handle/987654321/2634

Title:	螺旋式磨料流動研拋法應用於螺旋表面之研究
Authors:	陳占銘;Jan-ning Chen
Contributors:	機械工程研究所碩士在職專班
Keywords:	螺旋研拋;磨料流動加工;黏彈性磨料;Abrasive flow machining;Visco-elastic abrasive;Polishing
Date:	2007-07-20
Issue Date:	2009-09-21 11:52:41 (UTC+8)
Publisher:	國立中央大學圖書館
Abstract:	本研究是以磨料流動加工方法而利用螺桿試件旋轉來驅動黏彈性磨料，再進行對其試件表面的研磨拋光。實驗中，藉由控制加工時間、磨料粒徑、磨料濃度、主軸轉速等加工參數，探討對磨料黏度、表面粗糙度的影響，並找出最佳參數組合；同時亦觀察實驗後，各加工參數對工件表面形貌之影響。由實驗結果顯示，隨著加工時間的增加，磨料會呈現良好的流動性，此特性有利於螺旋研拋，使達成理想之表面研拋效果。而在選用微細磨粒與高濃度之磨料，配合適當的主軸轉速，可獲得最佳表面改善效果，有效地將工件之表面粗糙度由0.46μmRa 降至0.13μmRa，表面有微量的材料去除，而達到快速研拋效果。 The study presents the polishing of screw surface by abrasive flow machining, which is propelled by itself. In the experiment, the effects upon working temperature, abrasive viscosity and surface roughness are discussed by controlling machining time, particle size, abrasive concentration and the rotation speed of spindle. Also, the influence of these parameters on the polished surface is observed. Thus, the best parameter setting could be obtained. The result of the experiment shows that the liquidity of abrasive would rise with the increasing of machining time. This property is beneficial for fine spiral polishing to achieve an ideal polishing effect. The better polishing effect could be obtained by using 4μm particle size, 50% of abrasive concentration,5 minutes machining time and 2500 rpm of rotation speed. The surface roughness can be effectively reduced from Ra 0.46μm to Ra 0.13μm.
Appears in Collections:	[Executive Master of Mechanical Engineering] Electronic Thesis & Dissertation

Files in This Item:

File	Size	Format

社群 sharing

Loading...