MSC.Marc應用於板材壓延成型探討彈塑性界面之研究

NCU Institutional Repository > 工學院 > 機械工程研究所 > 博碩士論文 > Item 987654321/61705

jsp.display-item.identifier=請使用永久網址來引用或連結此文件: http://ir.lib.ncu.edu.tw/handle/987654321/61705

题名:	MSC.Marc應用於板材壓延成型探討彈塑性界面之研究
作者:	陳建諭;Chen,Chien-Yu
贡献者:	機械工程學系
关键词:	彈塑界面;壓延
日期:	2013-08-29
上传时间:	2013-10-08 15:29:02 (UTC+8)
出版者:	國立中央大學
摘要:	摘要所謂彈塑性界面，即板材壓延成形受輥輪擠壓產生塑性變形過程中彈性轉為塑性性質之交界面。就成形理論而言彈塑性界面即定義板材壓延成形塑性變形場區之邊界。利用塑性成形理論探討塑性變形區之邊界，通常在忽略彈性變形影響下以低階多項式近似之，且此邊界於壓延實務難以觀察獲得。因此本文藉由有限元素分析軟體MSC.Marc在考慮彈性變形之條件下，探討板材壓延成型在不同加工條件下的彈塑性界面變化，以期獲得較符合實際之塑性變形邊界，其中討論之加工參數有摩擦係數、壓縮率、周速比及輥徑比。 ABSTRACT The elastic-plastic boundary is known as the interface that the plate materials switch form elastic to plastic by the compression of rolling by rolls.For the forming theories, the elastic-plastic boundary define the area of the plastic deformation that caused by the rolling of the plate materials. The plastic deformation boundary discussed by theory of plastic forming usually ignores the effect of the elastic deformation and presented by the low order polynomials. It is also hard to be observed in practice of rolling. This research is subjected to the consideration of elastic deformation and focus on the change of the elastic-plastic boundary during the forming by the finite-element software, MSC. Marc. It is expected to get the practical model of the boundary of plastic deformation. The following parameters are discussed in this thesis: the friction coefficient, the ratio of reduction, the ratio of velocity and the ratio of roll radius.
显示于类别:	[機械工程研究所] 博碩士論文

文件中的档案:

档案	描述	大小	格式	浏览次数
index.html		0Kb	HTML	711	检视/开启

在NCUIR中所有的数据项都受到原著作权保护.

社群 sharing

数据加载中.....