以LaFeO3/Black-TiO2行光催化反應以去除甲苯及異丙醇之可行性探討;Photocatalytic oxidation of toluene and isopropanol by LaFeO3/Black-TiO2

NCU Institutional Repository > 工學院 > 環境工程研究所 > 博碩士論文 > Item 987654321/78033

jsp.display-item.identifier=請使用永久網址來引用或連結此文件: http://ir.lib.ncu.edu.tw/handle/987654321/78033

题名:	以LaFeO3/Black-TiO2行光催化反應以去除甲苯及異丙醇之可行性探討;Photocatalytic oxidation of toluene and isopropanol by LaFeO3/Black-TiO2
作者:	李昀恩;Lee, Yun-En
贡献者:	環境工程研究所
关键词:	揮發性有機物;光催化;Perovskite-type光觸媒;Black-TiO2;可見光
日期:	2018-08-23
上传时间:	2018-08-31 15:09:23 (UTC+8)
出版者:	國立中央大學
摘要:	揮發性有機物(VOCs) 之來源非常廣泛，暴露於VOCs環境中會對人體健康及環境造成不利之影響，會產生如頭痛、噁心、頭暈、刺鼻及咳嗽等症狀，這些長存於生活環境中之VOCs，對人體及環境之危害不容忽視。本研究為利用溶膠凝膠法分別製備black-TiO2及LaFeO3 (LFO) perovskite光觸媒，並利用物理性混合以特定比例將LFO擔載於black-TiO2上，以製備LFO/black-TiO2。將自製之black-TiO2及LFO/black-TiO2與市售之TiO2進行甲苯及異丙醇之去除活性測試比較，並藉由XRD、EPR、UV-vis、XPS及PL等儀器針對三種觸媒進行物化特性之分析與比較，藉由操作參數了解最佳之操作參數。研究結果顯示black-TiO2以250W氙燈為光源於50 sccm的流率下，初始濃度為100 ppm之甲苯及異丙醇的轉化率分別達89% 及99%，且礦化率也分別達87%及96%，而LFO/black-TiO2及市售TiO2對甲苯之轉化率則分別為87%及43%；對異丙醇之轉化率則分別為90% 及60%，顯示black-TiO2有最好之光催化活性，後續實驗將TiO2、black-TiO2及LFO/black-TiO2作比較，並探討氧氣濃度、流量及水氣含量變化下，對甲苯及異丙醇轉化效率之影響，結果顯示三種觸媒對於參數變化之趨勢皆相同，氧氣含量上升轉化效率也隨之上升，因此氧氣含量與轉化效率呈正相關，而在流量及水氣含量變化方面，則隨參數增加而轉化效率隨之下降。整體而言，本研究結果顯示LFO/black-TiO2及black-TiO2可有效去除氣流中之甲苯及異丙醇，具有發展潛力。;Volatile organic compounds (VOCs) are important air pollutants emitted from industrial, domestic and natural sources. Toluene and isopropanol (IPA) are VOCs which are commonly used in industrial manufacture. Typical technologies including adsorption, absorption, and combustion have been employed to eliminate VOCs from gas streams. Recently, photocatalysis is regarded as a potential way for the removal of VOCs. TiO2 is the most common photocatalyst in the photocatalysis field and also the most likely to be applied in industrial scale, due to its non-toxicity, abundance and photo/chemical stability. However, TiO2 has some limits including it has fast recombination rate of electron-hole pair and only absorbs UV light. Therefore, in this study, removal of toluene and IPA were investigated using black-TiO2 catalyst. Black-TiO2 can absorb visible light and has more defects on the catalyst surface. In this study, we discuss the conversion rate of VOCs by black-TiO2. The results, indicate that 98% and 89% conversion rate can be achieved for IPA and toluene, respectively. As the oxygen content is increased, the conversion rate also increases. As flow rate and hydrogen concentrations are increased, the conversion rate decreases. The results indicate higher removal efficiencies can be achieved with black-TiO2 when compared with TiO2 and LFO/black-TiO2. Overall, the preliminary results indicate that black-TiO2 can enhance the performance of photocatalysis system for toluene and IPA removal.
显示于类别:	[環境工程研究所 ] 博碩士論文

文件中的档案:

档案	描述	大小	格式	浏览次数
index.html		0Kb	HTML	237	检视/开启

在NCUIR中所有的数据项都受到原著作权保护.

社群 sharing

数据加载中.....