中大機構典藏-NCU Institutional Repository-提供博碩士論文、考古題、期刊論文、研究計畫等下載:Item 987654321/8248
English  |  正體中文  |  简体中文  |  全文笔数/总笔数 : 78852/78852 (100%)
造访人次 : 38473187      在线人数 : 2512
RC Version 7.0 © Powered By DSPACE, MIT. Enhanced by NTU Library IR team.
搜寻范围 查询小技巧:
  • 您可在西文检索词汇前后加上"双引号",以获取较精准的检索结果
  • 若欲以作者姓名搜寻,建议至进阶搜寻限定作者字段,可获得较完整数据
  • 进阶搜寻


    jsp.display-item.identifier=請使用永久網址來引用或連結此文件: http://ir.lib.ncu.edu.tw/handle/987654321/8248


    题名: 智慧型天線在正交分頻分工系統上的效能分析;The performance analysis of smart antenna for OFDM systems
    作者: 林夜明;Yeh-Min Lin
    贡献者: 通訊工程研究所碩士在職專班
    关键词: 波束構成;智慧型天線;post-DFT;pre-DFT;beamforming;smart antenna
    日期: 2006-07-10
    上传时间: 2009-09-22 11:21:54 (UTC+8)
    出版者: 國立中央大學圖書館
    摘要: 利用多個簡單天線所排成的陣列來接收訊號,而藉不同的相位(phase)可以控制最大增益出現的方向,並藉由演算法來計算所接收的訊號,進而得到一權重以提高訊號對干擾雜訊功率比(SINR),以增加頻道容量,提高通訊品質及消除多重路徑效應。所謂pre-DFT beamformer(波束構成器)是將接收的時域(time domain)訊號做完波束構成的權重計算後,然後再將合成訊號送進DFT運算器,那麼這樣只需用到一個DFT運算器就可以達成,因此pre-DFT的運算複雜度較低;而post-DFT beamformer是將接收訊號先經過DFT運算器,然後再將頻域(frequency domain)訊號做波束構成的權重計算,這樣就會需要多個DFT運算器,所以post-DFT的運算複雜度較高,不過它會比pre-DFT有更好且穩定的效能,本篇論文將會針對post-DFT和pre-DFT波束構成器在OFDM系統上做一個效能的比較及分析說明。也利用三種演算法(MVDR?GSC和Eigenvector)來分析在DFT前或DFT後的效能,另外也比較所要訊號的路徑到達角度之間隔、多路徑數量及不同干擾訊號強度所影響的程度。 We use an antenna array to receive signals and control the direction of the maximum gain via different phase adjustment. The received signal is computed through beamforming algorithms which improve the SINR (Signal Interference Noise Ratio), increase the channel capacity, and enhance the quality of the communication. It also eliminates the effect of the multi-path through beamforing weights.In the pre-DFT beamformer, the received signal in the time domain is calculated by beamforming algorithms before DFT (Discrete Fourier Transform). Therefore, the complexity of computation will be lower because the DFT is only applied once.In the post-DFT beamformer, the processing of received signals is performed by beamforming algorithms after DFT. In this way, the complexity of post-DFT beamformer will be higher. However, its performance is much better than pre-DFT. In this thesis, we will analyze and compare post-DFT and pre-DFT beamformers for OFDM systems.We use three algorithms (MVDR, GSC, and Eigenvector) before DFT or after DFT, to analyze the performance. Finally, we will make the performance comparison with different angle of arrivals, numbers of multi-paths, and degree of interference signal strength.
    显示于类别:[通訊工程學系碩士在職專班 ] 博碩士論文

    文件中的档案:

    档案 大小格式浏览次数


    在NCUIR中所有的数据项都受到原著作权保护.

    社群 sharing

    ::: Copyright National Central University. | 國立中央大學圖書館版權所有 | 收藏本站 | 設為首頁 | 最佳瀏覽畫面: 1024*768 | 建站日期:8-24-2009 :::
    DSpace Software Copyright © 2002-2004  MIT &  Hewlett-Packard  /   Enhanced by   NTU Library IR team Copyright ©   - 隱私權政策聲明