博碩士論文 101356001 完整後設資料紀錄

DC 欄位 語言
DC.contributor環境工程研究所zh_TW
DC.creator陳伯全zh_TW
DC.creatorCHEN POCHUANen_US
dc.date.accessioned2014-7-24T07:39:07Z
dc.date.available2014-7-24T07:39:07Z
dc.date.issued2014
dc.identifier.urihttp://ir.lib.ncu.edu.tw:88/thesis/view_etd.asp?URN=101356001
dc.contributor.department環境工程研究所zh_TW
DC.description國立中央大學zh_TW
DC.descriptionNational Central Universityen_US
dc.description.abstract本研究主要將含有p-Nitrophenol之溶液,以O3結合UV及H2O2之高級氧化程序進行礦化處理,並以總有機碳(Total Organic Carbon; TOC)作為p-Nitrophenol之礦化效率指標。於不同高級氧化程序, p-Nitrophenol礦化效率排序為:UV/O3>UV/O3/H2O2>O3>O3/H2O2>UV/H2O2,最佳p-Nitrophenol礦化效率之高級氧化程序為UV/O3程序(78.1%)。 於UV/O3程序,實驗結果顯示隨著H2O2注入劑量之增加, p-Nitrophenol之礦化效率隨之減少。H2O2在UV/O3程序主要扮演 掠奪者之角色。於O3程序,控制H2O2注入劑量為0~31.60 mg/min,實驗結果顯示H2O2注入劑量3.95 mg/min時對p-Nitrophenol礦化提升之效率最為顯著,於UV/O3程序,分別控制反應過程之pH值為3.0~10.0,實驗結果顯示控制pH值時皆優於未控制pH值,其中pH值為10.0礦化效率最佳。另以初始反應濃度10~100 mg/L,實驗結果顯示隨著初始反應濃度增加,p-Nitrophenol礦化效率及轉化率隨之降低。 由實驗結果可觀察到UV/O3程序礦化p-Nitrophenol之過程並非單純之一階反應(First-order reaction),而是擬一階反應(Pseudo first-order reaction);擬一階反應常數(kobs)介於0.0032~0.0175 min-1之間,隨著H2O2注入劑量增加,擬一階反應常數(kobs)隨之降低;不同pH值之擬一階反應常數(kobs)介於0.0158~0.0291 min-1之間,控制pH值為10.0時具有最佳之反應速率;不同p-Nitrophenol初始反應濃度之擬一階反應常數(kobs)介於0.0134~0.0806 min-1之間。 zh_TW
dc.description.abstractThis present study aims to evaluate the performance of advanced oxidation processes that combines UV, O3 and H2O2 to mineralize p-Nitrophenol in aqueous solution. The concentration of total organic carbon (TOC) was selected as an efficiency index of p-Nitrophenol mineralization. For different advanced oxidation processes, the efficiency of p-Nitrophenol mineralization followed the sequence UV/O3>UV/O3/H2O2>O3>O3/H2O2>UV/H2O2. The UV/O3 process got the best 78.1% efficiency of p-Nitrophenol mineralization. For the UV/O3 process, the results indicated that as the concentration of H2O2 increased, the rate of p-Nitrophenol mineralization declined. In other words, H2O2 acted as a scavenger of hydroxide radical ( ). While for the O3 process, it indicated that the efficiency of p-Nitrophenol mineralization is optimal when H2O2 dosage is 3.95 mg/min among .0 to 31.60 mg/min. Also for the UV/O3 process, the mineralization efficiency is optimal when pH was fixed to be 10.0 than pH was fixed below 10.0 or when pH was not fixed in oxidation process. When initial p-Nitrophenol concentration was controlled as 10~100 mg/L and pH was controlled as 10.0, it indicated that the efficiency of p-Nitrophenol mineralization declined as the initial p-Nitrophenol concentration increased. Hence, the mineralization rate of highly concentrated p-Nitrophenol was lower. It is observed that process of p-Nitrophenol mineralized by UV/O3 is not just a simple first-order reaction but pseudo first-order reaction. The pseudo first-order rate constant (kobs) of different H2O2 dosage was calculated between 0.0032~0.0175 min-1. As the H2O2 increases, the reaction rate constant declined. The pseudo first-order rate constant (kobs) for pH among 3.0 to 10.0 was calculated to be between 0.0158~0.0291 min-1. Still, when pH was fixed to be10.0 the oxidation process got the best reaction rate constant. The pseudo first-order rate constant (kobs) for different initial p-Nitrophenol concentration was calculated between 0.0134~0.0806 min-1. en_US
DC.subject高級氧化zh_TW
DC.subject臭氧zh_TW
DC.subjectUVzh_TW
DC.subjectp-Nitrophenolzh_TW
DC.subject礦化效率zh_TW
DC.subjectAdvanced oxidationen_US
DC.subjectOzoneen_US
DC.subjectUVen_US
DC.subjectp-Nitrophenolen_US
DC.subjectMineralization efficiencyen_US
DC.title以高級氧化程序礦化水中對-硝基苯酚之研究zh_TW
dc.language.isozh-TWzh-TW
DC.titleUsing Advanced Oxidation Process to Mineralize p-Nitrophenol in Aqueous Solutionen_US
DC.type博碩士論文zh_TW
DC.typethesisen_US
DC.publisherNational Central Universityen_US

若有論文相關問題,請聯絡國立中央大學圖書館推廣服務組 TEL:(03)422-7151轉57407,或E-mail聯絡  - 隱私權政策聲明