博碩士論文 92226024 完整後設資料紀錄

DC 欄位 語言
DC.contributor光電科學與工程學系zh_TW
DC.creator蔡明倫zh_TW
DC.creatorMin-Lun Tsaien_US
dc.date.accessioned2005-7-19T07:39:07Z
dc.date.available2005-7-19T07:39:07Z
dc.date.issued2005
dc.identifier.urihttp://ir.lib.ncu.edu.tw:88/thesis/view_etd.asp?URN=92226024
dc.contributor.department光電科學與工程學系zh_TW
DC.description國立中央大學zh_TW
DC.descriptionNational Central Universityen_US
dc.description.abstract我們探討不同的鍍膜系統製程對於ITO薄膜的影響與差異。發現電子槍蒸鍍加上IAD使得膜層更加緻密,但仍不如磁控濺鍍。於濺鍍系統上鍍製ITO薄膜於PET基板上,並改變不同的實驗參數,可得到一最佳參數:氧流量3sccm,濺鍍功率500w,於可見光範圍平均穿透率80%,電阻約5*10-4。並進一步利用電漿的預處理或後處理,以及離子源輔助濺鍍等方法,觀察處理之後的影響,發現於紅外光波段的穿透率皆有下降,且折射率增加,表示膜層變得更加緻密。但消光係數卻提升,可能是缺陷的增加。zh_TW
dc.description.abstractWe research the influence and difference of ITO thin film coating with different coating system and coating condition. We found that coating with e-beam evaporation with IAD makes film denser, but the effect is not good as magnetron sputtering. Coating ITO thin film on PET with sputtering system and different coating parameter, we can get a bit set of parameter: Oxygen flow 3sccm, sputtering power 500w. With such coating parameter, we can have sample with average 80% transmittance at visible range and 5*10-4.Observing the samples coating by sputter with IAD and further plasma pre-treating or post-treating, we found that the average transmittance at IR range drops and refractive indices increases, indicating that the film become denser. However the extinction coefficient rises that may due to the increase of the defect.en_US
DC.subject氧化銦錫zh_TW
DC.subject電子槍蒸鍍zh_TW
DC.subject磁控濺鍍zh_TW
DC.subject離子助鍍zh_TW
DC.subject電漿zh_TW
DC.subjectmagnetron sputteren_US
DC.subjectITOen_US
DC.subjecte-beam evaporationen_US
DC.subjectIndium Tin Oxideen_US
DC.subjectplasmaen_US
DC.subjectIADen_US
DC.titleITO鍍膜於PET基板上之研究zh_TW
dc.language.isozh-TWzh-TW
DC.titleResearch of ITO films on PETen_US
DC.type博碩士論文zh_TW
DC.typethesisen_US
DC.publisherNational Central Universityen_US

若有論文相關問題,請聯絡國立中央大學圖書館推廣服務組 TEL:(03)422-7151轉57407,或E-mail聯絡  - 隱私權政策聲明