博碩士論文 93333016 完整後設資料紀錄

DC 欄位 語言
DC.contributor機械工程學系在職專班zh_TW
DC.creator陳彥仲zh_TW
DC.creatorYen-Chung Chenen_US
dc.date.accessioned2006-7-6T07:39:07Z
dc.date.available2006-7-6T07:39:07Z
dc.date.issued2006
dc.identifier.urihttp://ir.lib.ncu.edu.tw:88/thesis/view_etd.asp?URN=93333016
dc.contributor.department機械工程學系在職專班zh_TW
DC.description國立中央大學zh_TW
DC.descriptionNational Central Universityen_US
dc.description.abstract本文的主要目的為探討液晶電視因喇叭聲壓激振的影響,而產生出的振動問題,並尋找解決方案。由於液晶電視的前框無法與液晶面板完全拘束,當喇叭聲壓激振而引起系統共振時,液晶電視的前框會與液晶面板碰撞而產生噪音問題。本文以LabVIEW為訊號擷取控制介面,以取得衝擊鎚與加速規在液晶電視前框各量測點的訊號,在經訊號轉換與運算後,可以得到各量測點的頻率響應。找出系統中發生最大頻率響應的位置,針對此位置進行結構的改良設計,使得系統的頻率響應能夠有效的降低,以降低液晶電視因喇叭聲壓的影響,所引發的噪音問題。zh_TW
dc.description.abstractThe main purpose of this thesis is to study the vibration problem of a TFT-LCD TV caused by the sound of the loudspeaker and to look for the solution for reducing the corresponding noise due to resonance. Since the TV bezel couldn’t be totally constrained with the TFT-LCD panel, it will collide with the TFT-LCD panel and emerge the vibration when the loudspeaker shakes. This thesis regards LabVIEW as the interface of signal analysis and signal processing to acquire the signal of the impact hammer and the accelerometer on every measure points of the TV bezel. By the signal processing of LabVIEW to acquire the frequency responses and find out the position where the maximum occurs. Finally, the design of TV was modified based on the measurement data. The frequency response of the TV set was improved and the associated noise was also reduced.en_US
DC.subject振動zh_TW
DC.subject噪音zh_TW
DC.subject結構改善zh_TW
DC.subjectstructural improvementen_US
DC.subjectnoiseen_US
DC.subjectvibrationen_US
DC.title液晶電視前框動態分析與結構改善zh_TW
dc.language.isozh-TWzh-TW
DC.titleDYNAMIC ANALYSIS AND STRUCTURAL IMPROVEMENT FOR THE BEZEL OF LCD TVen_US
DC.type博碩士論文zh_TW
DC.typethesisen_US
DC.publisherNational Central Universityen_US

若有論文相關問題,請聯絡國立中央大學圖書館推廣服務組 TEL:(03)422-7151轉57407,或E-mail聯絡  - 隱私權政策聲明