博碩士論文 93521056 完整後設資料紀錄

DC 欄位 語言
DC.contributor電機工程學系zh_TW
DC.creator邱景鴻zh_TW
DC.creatorChing-Hung Chiuen_US
dc.date.accessioned2006-7-17T07:39:07Z
dc.date.available2006-7-17T07:39:07Z
dc.date.issued2006
dc.identifier.urihttp://ir.lib.ncu.edu.tw:88/thesis/view_etd.asp?URN=93521056
dc.contributor.department電機工程學系zh_TW
DC.description國立中央大學zh_TW
DC.descriptionNational Central Universityen_US
dc.description.abstract本論文在於討論設計與實現射頻接收機前端之電路,如低雜訊放大器,混波器和壓控振盪器。 我們使用台積電0.18微米金氧半互補式 (CMOS) 製程來研製一個應用於K頻帶的增益可變式之低雜訊放大器。我們使用共平面波導 (CPW) 傳輸線做為匹配元件,以減低損耗性矽基板在高頻下的影響。在電路的高增益模式中,量測到的小訊號增益為8.1 dB,而雜訊指數為6 dB。本增益可變式之低雜訊放大器的增益可變範圍是7.2 dB。 在本論文中也呈現設計了一個應用於3到34 GHz的分散式汲極混波器。這個混波器電路是使用了0.15微米共源單閘極的假型高速電子移動電晶體 (PHEMT) 來組成的一個簡單分散式架構,並且其轉換損耗在3到34 GHz之間均優於6.7 dB。本分散式混波器實現了低功率消耗和高線性度於寬頻的應用上。 之後利用0.18微米CMOS製程技術來設計一個應用於26 GHz低相位雜訊且寬頻率調整範圍的PMOS交越耦合雙推式的壓控振盪器 (VCO)。電路中使用了一個只有PMOS的交越耦合對來降低相位雜訊,而其所量測到於二次諧波輸出端的相位雜訊在1 MHz位移時為-102.86 dBc/Hz。並且這個雙推式的VCO可達到14%的寬頻率調整範圍。另一個應用於50 GHz的雙推式VCO是使用了0.15微米PHEMT的製程技術所製作和使用一段λg/2長的微帶線共振器來達到雙推式振盪。這種類型的雙推式VCO擁有著簡單架構與良好特性的優點。由模擬結果,本VCO具有1.2 GHz的頻率調整範圍和在1 MHz位移時有-111.8 dBc/Hz的相位雜訊。zh_TW
dc.description.abstractThe thesis investigates the design and implementation of RF receiver front-end circuits, such as low noise amplifier, mixer, and voltage-controlled oscillator. A K-band variable-gain low noise amplifier (VGLNA) is designed and implemented using TSMC 0.18-μm CMOS technology. Coplanar waveguide (CPW) transmission lines are adopted as matching elements to reduce the effect of lossy silicon substrate at high frequency. In high-gain mode, the measured small signal gain of VGLNA is 8.1 dB and noise figure of 6 dB at 21.7 GHz. The gain control range of the VGLNA is 7.2 dB. A 3-34 GHz distributed drain mixer using CPW technology is demonstrated in this thesis. This MMIC mixer uses a simple distributed topology that is composed of common-source single-gate 0.15-μm PHEMT, and it shows a conversion loss of better than 6.7 dB from 3 to 34 GHz. This distributed mixer achieves low dc power consumption and high linearity for broadband applications. Afterward, the 26-GHz PMOS cross-coupled push-push VCO using 0.18-μm CMOS technology is design for low phase noise and wide tuning range. The PMOS-only cross-coupled pair is used to lower the phase noise, and the measured 2nd harmonic phase noise is -102.86 dBc/Hz at 1-MHz offset. The push-push VCO achieves a wide tuning range of 14%. Another 50-GHz push-push VCO uses 0.15-μm PHEMTs technology and the λg/2 microstrip line resonator to form a common resonator for push-push oscillation. This type of push-push VCO has the advantages of simple configuration and good performances. From simulated results, the VCO achieves the frequency tuning range of 1.2 GHz and the phase noise of -111.8 dBc/Hz at 1-MHz offset.en_US
DC.title應用於毫米波射頻接收機前端積體電路之研製zh_TW
dc.language.isozh-TWzh-TW
DC.titleDesign and Implementation of RF Receiver Front-end Integrated Circuits for Millimeter-wave Applicationsen_US
DC.type博碩士論文zh_TW
DC.typethesisen_US
DC.publisherNational Central Universityen_US

若有論文相關問題,請聯絡國立中央大學圖書館推廣服務組 TEL:(03)422-7151轉57407,或E-mail聯絡  - 隱私權政策聲明