| DC 欄位 |
值 |
語言 |
| DC.contributor | 光電科學與工程學系 | zh_TW |
| DC.creator | 許博勝 | zh_TW |
| DC.creator | Po-sheng Hsu | en_US |
| dc.date.accessioned | 2008-1-3T07:39:07Z | |
| dc.date.available | 2008-1-3T07:39:07Z | |
| dc.date.issued | 2008 | |
| dc.identifier.uri | http://ir.lib.ncu.edu.tw:88/thesis/view_etd.asp?URN=942206066 | |
| dc.contributor.department | 光電科學與工程學系 | zh_TW |
| DC.description | 國立中央大學 | zh_TW |
| DC.description | National Central University | en_US |
| dc.description.abstract | 本研究主要是利用Visual Basic(VB)編輯電腦控制介面程式，依照所需進行雷射針灸之時間、頻率、波長進行設定，由CCD Camera取得針灸影像後，經由Visual Basic(VB)編輯而成的影像辨識系統，辨識即將進行雷射針灸的穴道點，使用RS232傳輸控制Data到Microchip PIC單晶片控制盒，單晶片控制盒依接收到之不同訊號分別控制X-Y Table上的兩顆步進馬達進行定位。定位完成後，再由電腦的Visual Basic介面控制雷射針灸的時間、頻率、與波長，進行整個雷射針灸的過程。 | zh_TW |
| dc.description.abstract | This research mainly uses Visual Basic (VB) to compile the computer’s control interface program, according to the time, frequency and wavelength that the laser acupuncture procedure requires. Started from getting an acupuncture image from the CCD Camera, then uses the image recognition system compiled by VB to recognize the points of the undergoing laser acupuncture treatment, and then uses RS232 to transform the data to microcontroller system, according to different signals this system can control two step motors on the X-Y table to direct points. In the end, uses computer’s control interface program to procedure the laser acupuncture treatment. | en_US |
| DC.subject | 雷射針灸 | zh_TW |
| DC.subject | 影像辨識系統 | zh_TW |
| DC.subject | 單晶片 | zh_TW |
| DC.subject | 步進馬達 | zh_TW |
| DC.subject | step motors | en_US |
| DC.subject | microcontroller | en_US |
| DC.subject | image recognition system | en_US |
| DC.subject | Laser acupuncture | en_US |
| DC.title | 雷射針灸與穴道點自動定位系統 | zh_TW |
| dc.language.iso | zh-TW | zh-TW |
| DC.type | 博碩士論文 | zh_TW |
| DC.type | thesis | en_US |
| DC.publisher | National Central University | en_US |