| dc.description.abstract | According to the experimental principle of thermal probe method, the research adopted the finite element analysis (ABAQUS), it carried on the numerical simulation with rational analysis condition and appropriate materal parameters. Through the comparison with theoretical solution, verify the accuracy and suitability of numerical model. Then, some factors of thermal probe method are investigated, including the relative size of the specimen, clearance, type of thermal grease, and inputting the voltage etc., and cooperate with the result of the experiment by Chang(2006) to inquire into the accurate value. Finally, it carried on parameter research and numerical simulation of non-isotropic rock, in order to take them into account for test subsequently.
The numerical result showed that the aspect ratio of the specimen up to 12.5, avoid the influence of boundary effect. If clearance increases, it will underestimate thermal conductivity of the specimen. According to the contour plot, the range of heat transfer will reduce obviously. So numerical result indicated that it need to pack the appropriate thermal grease. The respect of using thermal grease, it should be consider the thermal conductivity of the specimen, not pack too bad to influence the heat transmission. The value of inputting voltage will not influence the thermal conductivity of the specimen. The respect of parameter research showed that the specific heat or density of heat source material causes heavy influence on the range of 0~100 seconds in temperature rise curve. So it suggested to adopt the straight line section after 100 seconds to inquired into thermal conductivity. Under the same thermal resistivity, if the thickness of interface is thicker to pack higher thermal conductivity of grease, it will improve thermal conductivity of the specimen.
The numerical result of non-isotropic rock showed that the numerical simulation verifies two-phase layered rock can be equivalent to transversely isotropic rock. The discussion of transversely isotropic rock at anisotropic ratio, it can find that numerical solution well agreed with theoretical solution of Laplace’s equation. | en_US |