啞鈴型缺陷地面之介質量測電路分析與設計

以作者查詢圖書館館藏

、以作者查詢臺灣博碩士

、以作者查詢全國書目

、勘誤回報

、線上人數：13

、訪客IP：3.143.9.115

姓名

謝致軒(Sie ,Jhih -Syuan) 查詢紙本館藏

畢業系所

電機工程學系

論文名稱

啞鈴型缺陷地面之介質量測電路分析與設計
(Analysis and Design of Dielectric Measurement Technique Using Dumbbell-Shape DGS)

相關論文

★ 利用缺陷型接地結構之雙頻微型平面倒F天線設計	★ 應用於第三代行動電話之倒Ｆ天線設計
★ 使用寄生元件之平面式倒F型雙頻天線設計	★ 利用寄生元件之平面式倒 F 型三頻天線設計
★ 無線通訊之三頻天線設計	★ 無線通訊之雙頻與三頻槽孔型天線設計
★ 應用於智慧型行動裝置之LTE/WWAN多頻單極天線設計	★ 應用於行動手持裝置之LTE/WWAN天線設計
★ 利用背腔式槽孔線結構之多頻段天線設計	★ 利用缺陷地面共振電路之介質量測技術
★ 應用於藍芽與全球衛星定位系統之電抗性負載型雙頻槽孔天線	★ 帶通圓形極化頻率選擇面之設計
★ 雙頻圓極化微波極化器設計	★ 利用微小共振電路之多頻段天線設計
★ 應用於X-band平面吸波器之薄型負載電路設計	★ 應用於X-band平面吸波器之阻抗倒轉器設計

檔案

[Endnote RIS 格式]

[Bibtex 格式]

[相關文章]

[文章引用]

[完整記錄]

[館藏目錄]

至系統瀏覽論文 ( 永不開放)

摘要(中)

本論文建立了一套對於啞鈴型缺陷地面結構感測器新的分析與設計方法。在過去的文獻中僅提出在量測上低誤差之感測器但缺乏完整的設計方法。因此本研究利用統計方法歸納資料庫中導磁係數與介電系數量測低誤差的感測器。歸納分析結果發現除了感測器的等效電容和等效電感會造成導磁係數與介電系數的誤差外，不同待測物厚度也會影響量測結果。因此本研究先首自厚度0.4 mm之待測物資料庫中取出數組表現最佳的感測器，再從中找出誤差與厚度相關性較低的感測器。藉此取得量測更為精準之低誤差的感測器。

摘要(英)

A new analysis and design method for dumbbell-shape DGS sensor is proposed in this thesis. The dumbbell-shape DGS sensor with low measurement error has been proposed in the past study. However, it is still required more complete design procedure. In this study, the sensors in database are generalized by statistical method based on low measurement error in permittivity and permeability. The result shows that not only the equivalent capacitance and
the equivalent inductance would cause error to these two values, the thickness about different DUT would also do. According to the result in the thesis, several sensors which perform better are selected from DUT database with 0.4 mm in thicknesses. Then among these sensors which have low relevance in thickness are selected which give better accuracy in measurement.

關鍵字(中)

★ 介質量測

關鍵字(英)

論文目次

目錄
摘要 i
Abstract ii
致謝 iii
圖目錄 v
表目錄 viii
第一章序論 1
1.1 研究動機 1
1.2 文獻回顧 2
1.3章節介紹 3
第二章啞鈴型缺陷地面結構感測器模擬與分析 4
2.1 啞鈴型缺陷地面結構感測器分析與特性 4
2.1.1 等效電路與加待測物等效電路之分析 5
2.1.2量測待測物之特性 8
2.2 啞鈴型缺陷地面結構感測器先前規劃 13
2.2.1 感測器頻率量測範圍的決定 13
2.2.2依賴程度之統計方法 14
2.2.3不同依賴程度下對電容電感以及導磁係數介電係數誤差之計算 16
第三章啞鈴型缺陷地面結構感測器設計 18
3.1簡介 18
3.2不同待測物厚度與依賴程度的關係 18
3.3 不同感測器電容電感值與依賴程度的關係 33
3.4 依賴程度與導磁係數與介電係數誤差之關係 39
3.5結論 48
第四章感測器實作與量測 49
4.1 啞鈴型缺陷地面結構感測器實作與量測 49
4.2 反演程序 52
4.3 結論 68
第五章總結 69
參考文獻 70

參考文獻

[1]W. Xi, W. R. Tinga, W. A. G. Voss, and B. Q. Tian, “New results for coaxial re-entrant cavity with partially dielectric filled gap,” IEEE Trans. Microw. Theory Tech., vol. 40, no. 4, pp. 747–753, Apr. 1992.
[2]M. D. Janezic, E. F. Kuester, and J. Baker-Jarvis, “Broadband complex permittivity measurements of dielectric substrates using a split-cylinder resonator,” in Proc. IEEE MTT-S Int. Microw. Symp. Dig., Fort Worth, TX, Jun. 2004, pp. 1817–1820.
[3]K. M. C. Branch, J. Morsey, and A. C. Cangellaris, “Physically consistent transmission line models for high-speed interconnects in lossy dielectrics,” IEEE Trans. Adv. Packag., vol. 25, no. 2, pp. 129–135, Aug. 1990.
[4]R. Djordjevic´ and R. M. Biljic´, “Wideband frequency-domain characterization of FR-4 and time-domain causality,” IEEE Trans. Electromagn.Compat., vol. 43, no. 4, pp. 662–667, Nov. 2001.
[5]J. Baker-Jarvis and E. J. Vanzura, “Improved technique for determining complex permittivity with the transmission/reflection method,” IEEE Trans. Microw. Theory Tech., vol. 38, no. 8, pp. 1096–1103, Aug. 1990.
[6]K. Staebell, M. Noffke, and D. Misra, “On the in situ probe method for measuring the permittivity of materials at microwave frequencies,” in Proc. IEEE. Instr. Meas. Technol. Conf., 1990, pp. 28–31.
[7]S. B. Kumar, U. Raveendranath, P. Mohanan, and K. T. Mathew, “A simple free-space method for measuring the complex permittivity of single and compound dielectric materials,” Microw. Opt. Technol. Lett., vol. 26, no. 2, pp. 117–119, Jul. 2000.
[8]P. K. Singh et al., “High frequency measurement of dielectric thin films,” in Proc. IEEE MTT-S Int. Microw. Symp. Dig., San Diego, CA, May 1994, pp. 1457–1460.
[9]W. Williamson, III et al., “High frequency dielectric properties of thin film PZT capacitors,” Integrated Ferroelectronics, vol. 10, pp. 335–342, 1995.
[10]R. Voelker, G. Lei, G. Pan, and B. Gilbert, “Determination of complex permittivity of low-loss dielectrics,” IEEE Trans. Microw. TheoryTech., vol. 45, no. 10, pp. 1995–1960, Oct. 1997.
[11]W.B. Weir, “Automatic measurement of complex dielectric constant and permeability at microwave frequencies,” Proceedings of the IEEE, vol. 62, pp. 33-36, Jan. 1974.
[12]Chao-Hsiung Tseng,and Tah-Hsiung Chu, “Measurement of frequency-dependent equivalent width of substrate integrated waveguide,” IEEE Trans. Microw. TheoryTech., vol. 54, no. 4, pp. 1431–1437, Apr. 2006.
[13]K.-P. Lätti, M. Kettunen, Juha-Pekka Ström, and P. Silventoinen, “A review of microstrip T-resonator method in determining the dielectric properties of printed circuit board materials,” IEEE Trans. Instr. Meas., vol. 56, no. 5, pp. 1845-1850, Oct. 2007.
[14]楊安凱，「利用缺陷地面共振電路之介質量測技術」，國立中央大學，碩士論文，民國一百年.
[15]D. Ahn, J. S. Park, C. S. Kim, J. Kim, Y. Qian, and T. Itoh, “A design of the low-pass filter using the novel microstrip defected ground structure, ” IEEE Trans. Microw. Theory Theory Tech., vol. 49, no 1, pp. 86-93, Jan. 2001.
[16]David K. Cheng，Field and Wave Electromagnetics ，Springer-Verlag，New York，2003.
[17] http://www.esss.com.br/events/ansys2010/pdf/22_6_1150.pdf
[18]http://www.rogerscorp.com/
[19]http://www.kinsten.com.tw/

指導教授

丘增杰(Chiu, Tsen-Chieh)

審核日期

2013-7-25

推文