博碩士論文 89322109 詳細資訊


姓名 高啟洲(Chi-Jou Kao)  查詢紙本館藏   畢業系所 土木工程學系
論文名稱 非韌性鋼筋混凝土梁柱內接頭補強之研究
(Retrofitting of Non-Ductile Reinforced Concrete Interior Beam-Column Joints)
檔案 [Endnote RIS 格式]    [Bibtex 格式]    [檢視]  [下載]
  1. 本電子論文使用權限為同意立即開放。
  2. 已達開放權限電子全文僅授權使用者為學術研究之目的,進行個人非營利性質之檢索、閱讀、列印。
  3. 請遵守中華民國著作權法之相關規定,切勿任意重製、散佈、改作、轉貼、播送,以免觸法。

摘要(中) 本實驗主要在探討針對台灣典型之非韌性低強度梁柱內接頭採用混凝土擴柱補強及鋼板補強之可行性,並由不同補強工法造成補強後試體之勁度、韌性及接頭剪力衰減等情形之異同加以分析,比較其補強成效。
由實驗結果得知,就補強成效來說,混凝土擴柱補強工法對於梁柱內接頭勁度之提升明顯優於鋼板補強工法,且就同為混凝土擴柱補強工法而言,對於勁度之提升效率以增大擴柱面積方式較增加混凝土抗壓強度方式來得有效。
在韌性及消能行為之表現上,本研究之JI2混凝土擴柱補強工法及JI4鋼板補強工法皆能有效防止原型非韌性梁柱內接頭試體在梁塑鉸產生前即發生突然之接頭剪力破壞,且將原型非韌性內接頭試體之韌性分別提高31%及77%。但JI2混凝土補強試體及JI4鋼板補強試體之最後破壞模式皆為接頭剪力破壞,且韌性之提高並未達到補強目標。即最大載重韌性比未達到4,此點仍可做後續研究。
最後,根據對於接頭剪力強度衰減之討論,乃針對混凝土擴柱補強工法及鋼板補強工法分別提出補強建議方針,以供國內RC梁柱接頭補強之參考。
摘要(英) This experiment was mostly aimed at the feasibility of retrofitting non-ductile and low-strength interior beam-column joint by Concrete Jacketing and Steel Jacketing, and a discussion was made through the differences in stiffness, ductility, and joint shear degradation between benchmark and retrofitted specimen.
In the respect of ductility and energy absorption, JI2 Concrete Jacketing and JI4 Steel Jacketing schemes could both prevent benchmark from unexpected joint shear failure before beam plastic hinges developed and respectively upgraded its own ductility by 30% and 77%. However, both JI2 and JI4 specimen’s failure modes are joint shear failure at the end of the test, and their retrofitted ductility did not reach 4, which is the target of our retrofitting scheme. Therefore, further research is needed.
Finally, according to the discussed behavior of joint shear degradation, we provided beam-column joint retrofitting scheme recommendations, which can be referenced for further research on beam-column joint retrofitting in Taiwan.
關鍵字(中) ★ 鋼筋混凝土
★ 梁柱接頭
★ 補強
關鍵字(英) ★ Reinforced Concrete
★ Retrofit
★ Joint
論文目次 目錄
中文摘要
英文摘要
誌謝
目錄
表索引
圖索引
第一章 緒論
1.1 研究動機
1.2 研究目的與範圍
第二章 文獻回顧
2.1美國ACI318-99規範之梁柱接頭設計
2.2軟化壓拉桿模型之剪力強度評估
2.3 Hakuto之剪力衰減模式
2.4典型早期梁柱接頭缺失
2.5梁柱接頭補強
第三章 實驗規劃與執行
3.1試體規劃
3.2材料試驗
3.3試體設計
3.3.1 JI1原型試體
3.3.2 JI2高強度混凝土擴柱補強試體
3.3.3 JI3普通強度混凝土擴柱補強試體
3.3.4 JI4鋼板補強試體
3.4試體製作
3.5實驗設置
3.5.1梁柱接頭試驗
3.5.2位移量測系統
3.6實驗數據整理
第四章 試驗結果
4.1 JI1原型試體分析
4.1.1 JI1載重-位移關係
4.1.2 JI1接頭剪力變形及梁主筋應力
4.2 JI2高強度混凝土擴柱補強試體分析
4.2.1 JI2載重-位移關係
4.2.2 JI2接頭剪力變形及梁主筋應力
4.3 JI3普通強度混凝土擴柱補強試體分析
4.3.1 JI3載重-位移關係
4.3.2 JI3接頭剪力變形及梁主筋應力
4.4 JI4鋼板補強試體分析
4.4.1 JI4載重-位移關係
4.4.2 JI4接頭剪力變形及梁主筋應力
第五章 分析與討論
5.1初始勁度及最大載重延展比
5.2韌性與消能行為
5.3試體破壞模式與裂縫寬度
5.4接頭剪力衰減
第六章 結論與建議
6.1結論
6.2建議
符號說明
參考文獻


附錄A(各試體接頭剪力強度評估計算)
附錄B(各試體理論標稱載重計算)
附錄C(JI2、JI4補強試體接頭剪力強度評估之修正計算)
參考文獻 參考文獻
[1] ACI Committee 318, “Building Code Requirements for Structural Concrete (ACI 318-99) and Commentary (ACI 318R-99),” American Concrete Institute, Farmington Hills, 1999.
[2] 李宏仁,「鋼筋混凝土耐震梁柱接頭剪力強度之研究」,博士論文,國立台灣科技大學營建工程技術研究所,台北,2000。
[3] Shigeru Hakuto, ”Retrofitting of Reinforced Concrete Moment Resisting Frames,” Research Report, Department of Civil Engineering, University of Canterbury, Christchurch, New Zealand, August, 1995.
[4] 呂宜峰,「高強度混凝土梁柱接頭耐震剪力強度衰減之研究」,碩士論文,國立台灣科技大學營建工程技術研究所,台北,2001。
[5] Priestley, M.J.N., Seible, F.,and Calvi, G. M., ” Seismic Design of Reinforced Concrete and Masonry Buildings,” John Wiley & Son, Inc, 1996.
[6] 李日暉,「高強度混凝土梁柱接頭剪力行為之研究」,碩士論文,國立中央大學土木工程研究所,1998。
[7] Blakeley, R.W.G., Megget, L.M, Priestley, M.J.N., ”Seismic Performance of Two Full Size Reinforced Concrete Beam-Column Joint Units,” Bulletin of New Zealand National Society for Earthquake, Vol.8,No.1 ,pp.38-69, March, 1985.
[8] 施明祥,鄭錦銅,董瀚友,「RC結構梁柱接頭補強成效驗證」,國立高雄第一科技大學八十九學年度研究成果研討會論文集,民國90年7月30日。
[9] Sergio M. Alcocer, James O. Jirsa, ”Strength of Reinforced Concrete Frame Connections Rehabilitated By Jacketing,” ACI Structural Journal, Title no. 90-S26, May-June 1993.
[10] A. Ghobarah; A. Said, ”Seismic Rehabilitation of Beam-Column Joints Using FRP Laminates,”Journal of Earthquake Engineering, Vol. 5, No.1, pp. 113-129, 2001.
[11] A. Ghobarah, T. S. Aziz, Aahraf Biddah, ”Rehabilitation of Reinforced Concrete Frame Connections Using Corrugated Steel Jacking,”ACI Structural Journal, Title no. 94-S26, May-June, 1997.
[12] Ashraf Biddah, A.Ghobarah, Tarek S. Aziz, ”Upgrading of Nonductile Reinforced Concrete Frame Connections,” Journal of Structural Engineering, Vol. 123, No.8, August, 1997.
[13] Park, R., “Seismic Assessment and Retrofit of Concrete Structures-United States and New Zealand Developments,” Proceedings of Technology Conference of New Zealand Concrete Society, Wairakei, 1992, pp18-25.
[14] 黄世建,王國州,李宏仁,「鋼筋混凝土梁柱接頭之耐震設計與補強策略」,研討會論文手稿,國立台灣科技大學,民國90年10月4日。
[15] Aizhen, ”Seismic Assessment and Retrofit of Pre-1970s Reinforced Concrete Frame Structures,” Research Report, Department of Civil Engineering, University of Canterbury, Christchurch, New Zealand, Jan., 2002.
[16] Yung Chin Wang, ”Retrofit of Reinforced Concrete Members Using Advanced Composite Materials,” Research Report, Department of Civil Engineering, University of Canterbury, Christchurch, New Zealand, Feb., 2000.
[17] Joseph M., Bracci, Sashi K. Kunnath, Andrei M. Reinhorn, ”Seismic Performance and Retrofit Evaluation of Reinforced Concrete Structures,” Journal of Structural Engineering, Jan. 1997.
[18] A. G. Tsonos, ”Lateral Load Response of Strengthened Reinforced Concrete Beam to Column Joints,” ACI Structural Journal, Jan.-Feb. 1999.
[19] Hitoshi Shiohara, ”New Model For Shear Failure of RC Interior Beam-Column Connections,” Journal of Structural Engineering, Feb., 2001.
[20] G. Parra-Montesinos, James K. Wight, “Modeling Shear Behavior of Hybrid RCS Beam-Column Connections,” Journal of Structural Engineering, Jan. 2001.
[21] A. Beres, R. N. White, P. Gergely, ”Seismic Behavior of Reinforced Concrete Frame Structures with Nonductile Details,” Technical Report, National Center For Earthquake Engineering Research, State University of New York, Buffalo.
[22] Thomas T. C. Hsu, “Unified Theory of Reinforced Concrete,” Department of Civil Engineering, University of Houston, Houston, Texas.
[23] R. Park, T. Pauley, “Reinforced Concrete Structures,” Department of Civil Engineering, University of Canterbury, Christchurch, New Zealand.
[24] 楊政達,「非韌性鋼筋混凝土梁柱外接頭補強之研究」,碩士論文初稿,國立中央大學土木工程學研究所,2002。
[25] Shyh-Jiann Hwang, Hung-Jen Lee, ”Strength Prediction For Discontinuity Regions by Softened Strut-And-Tie Model,” ASCE File No.ST/2001/022767, November, 2001, 1st Revised Manuscript.
[26] 李宏仁,王國州,黄世建,「鋼筋混凝土外部梁柱接頭耐震設計與配筋細則之研究」,第六屆結構工程研討會論文編號G13。
[27] ACI-ASCE Committee 352, ”Recommendations for Design of Beam-Column Joints in Monolithic Reinforced Concrete Structures,” ACI Journal, Proceedings, Vol. 82, No. 3, May-June 1985, PP. 266-283.
指導教授 王勇智(Yung-Chin Wang) 審核日期 2002-7-11
推文 facebook   plurk   twitter   funp   google   live   udn   HD   myshare   reddit   netvibes   friend   youpush   delicious   baidu   

若有論文相關問題,請聯絡國立中央大學圖書館推廣服務組 TEL:(03)422-7151轉57407,或E-mail聯絡