博碩士論文 91523031 詳細資訊




以作者查詢圖書館館藏 以作者查詢臺灣博碩士 以作者查詢全國書目 勘誤回報 、線上人數:6 、訪客IP:54.91.4.56
姓名 羅文信(Wu- Shin LO)  查詢紙本館藏   畢業系所 通訊工程學系
論文名稱 剖風儀之關鍵零組件-相移器之研製
(Key component of wind profiler-the develop of phase shifter)
相關論文
★ 利用缺陷型接地結構之雙頻微型平面倒F天線設計★ 應用於第三代行動電話之倒F天線設計
★ 使用寄生元件之平面式倒F型雙頻天線設計★ 利用寄生元件之平面式倒 F 型三頻天線設計
★ 無線通訊之三頻天線設計★ 無線通訊之雙頻與三頻槽孔型天線設計
★ 應用於智慧型行動裝置之LTE/WWAN多頻單極天線設計★ 應用於行動手持裝置之LTE/WWAN天線設計
★ 利用背腔式槽孔線結構之多頻段天線設計★ 利用缺陷地面共振電路之介質量測技術
★ 應用於藍芽與全球衛星定位系統之電抗性負載型雙頻槽孔天線★ 帶通圓形極化頻率選擇面之設計
★ 啞鈴型缺陷地面之介質量測電路分析與設計★ 雙頻圓極化微波極化器設計
★ 利用微小共振電路之多頻段天線設計★ 應用於X-band平面吸波器之薄型負載電路設計
檔案 [Endnote RIS 格式]    [Bibtex 格式]    [相關文章]   [文章引用]   [完整記錄]   [館藏目錄]   [檢視]  [下載]
  1. 本電子論文使用權限為同意立即開放。
  2. 已達開放權限電子全文僅授權使用者為學術研究之目的,進行個人非營利性質之檢索、閱讀、列印。
  3. 請遵守中華民國著作權法之相關規定,切勿任意重製、散佈、改作、轉貼、播送,以免觸法。

摘要(中) 本論文主要是針對一維光子能隙(Photonic Bandgap簡稱PBG)結構能縮小尺寸的特性,來設計所需相位的延遲線,進而研製出相移器。相移器為剖風儀天線陣列提供相位移轉的重要關鍵零組件,主要的設計概念,在於首先設計所需相位的延遲線,接著配合高頻開關的切換,選擇所需相位的路徑。
PBG所以能縮小尺寸的原因主要為電路結構中等效的電感提供了慢波效應(slow wave effect),由於這個慢波效應,使得PBG的電氣長度會比一般傳輸線長,因此在同樣電氣長度下,PBG的物理長度就會比一般傳輸線短,這樣就會使得所製作的相位偏移器整體的面積就會比較小。 文中將會探討PBG電路所可以設計的參數,並整理出這些參數的規則,利用這些規則來盡量縮小電路的尺寸且達到符合所需要的相位。
摘要(英) In the thesis, a design concept for the phase shifter using photonic bandgap(PBG)structure is proposed. PBG possesses a slow-wave characteristic caused by the equivalent inductive components. Due to the slow-wave effect, the electrical length of the PBG is increased. Therefore, the physical length of transmission lines can be shortened by inserting PBG while the original electrical length remains the same.
Sensitivity analysis is conducted on many design arguments of PBG. Based on the analysis, simple design rule of phase-delayed line using PBG is proposed. At the end, a 3 bits phase shifter is realized and verified by measurement in the thesis.
關鍵字(中) ★ 相移器
★ 延遲線
★ 一維光子能隙
關鍵字(英) ★ phase shifter
★ delay line
★ PBG
論文目次 目 錄
摘要(中文)………………………………………………………………………I
摘要(英文)………………………………………………………………………II
致謝………………………………………………………………………………III
目錄………………………………………………………………………………IV
第一章 緒論…………………………………………………………………1
1.1 簡介與研究動機………………………………………………………1
1.2 內容概要…………………………………………………………………4
第二章 Photonic Bandgap結構電路設計之延遲線…………………5
2.1 簡介………………………………………………………………………5
2.2 Matlab程式模擬一維PBG電路及實現…………………………7
2.2.1 ABCD矩陣與S參數……………………………………………7
2.2.2 Matlab程式模擬…………………………………………………12
2.2.3實現PBG電路架構與模型………………………………………14
2.2.4等效串接電感的模擬與驗證……………………………………16
2.2.5最後PBG結構的實現電路………………………………………20
2.3 通帶慢波效應的分析………………………………………………21
2.3.1單元網路間的傳輸線距離d對slow wave factor的影響………24
2.3.2單元網路加載個數對slow wave factor的影響…………………35
2.3.3加載單元網路之電感值大小對slow wave factor的影響………40
2.3.4結語………………………………………………………………44
2.4 延遲線的實現…………………………………………………46
第三章 相移器的設計……………………………………………………51
3.1 簡介……………………………………………………………………51
3.2 相移器的基本原理與架構…………………………………………52
3.2.1基本原理…………………………………………………………52
3.2.2相移器架構………………………………………………………54
3.3 相移器的實現…………………………………………………………56
第四章 結論…………………………………………………………………61
參考文獻…………………………………………………………………………62
參考文獻 參考文獻
[1] T. Y. Yun and K. Chang, “Uniplanar One-dimension photonic bandgapstructures and resonators,” IEEE Trans. Microwave Theory Tech. vol. 49, pp. 549-553, Mar. 2001.
[2] D. M. Pozar, Microwave Engineering, Addison Wesley, 1990.
[3] M. Born and E. Wolf, with contributions by A. B. Bhatia ... et al.,
Principles of optics: electromagnetic theory of propagation, interference
and diffraction of light, Oxford /Pergamon Press New York, 1980.
[4] R.N. Simons, Coplanar Waveguide Circuit, Components, and systems,
John Wiley & Sons Ltd., 2000.
[5] J.S. Foresi, et al., “Photonic-bandgap microcavities in optical waveguides,”
Nature, vol. 390, pp. 143-145, 1997.
[6] T. Y. Yun and K. Chang, “One-dimension photonic bandgap resonators and varactor turned resonators,” in IEEE MTT-S Int. Microwave Symp. Dig. , pp. 1629-1632, Anaheim, CA, June 1999.
[7] J. S. Lim, C.S. Kim, Y.T. Lee, D. Ahn, amd S. Nam, “A spiral-sharped
defected ground structure for coplanar waveguide, ” IEEE Microwave and
Wireless Compon. Lett., vol.12, Sept. 2002.
[8] V. Radisic, Y. Qian, R. Coccioli, and T. Itoh, “Novel 2-D photonic bandgap structure for microstrip lines,” IEEE Microwave Guided Wave Lett., vol. 8, pp. 69–71, Feb. 1998.
[9] T. Kim and C. Seo, “A novel photonic bandgap structure for Low-pass filter of wide stopband,” IEEE Microwave and Guided Wave Lett., vol.10, pp.13-15, Jan. 2000.
[10] I. Rumsey, P. M. Melinda, and P. K. Kelly, “Photonic bandgap structures used as filters in microstrip circuits,” IEEE Microwave Guided Wave Lett., vol.8, pp. 336–338, Oct. 1998.
[11] J. Yoon and C. Seo, “ Improvement of broadband feedforward
amplifier using photonic bandgap,” IEEE Microwave and Wireless Compon.
Lett., vol.11, No.11, Nov. 2001.
[12] Yu Ji, Steve Yao and Lute Maleki,” High-Q whispering gallery mode resonator filter with photonic bandgap spurious mode suppression,” IEEE/EIA International Frequency Control Symp.and Exhibition 2000.
[13] F. R. Yang, K. P. Ma, Y. Qian, T. Itoh, ”A uniplanar compact photonic-
bandgap(UC-PBG)structure and its applicationa for microwave circuits,”
IEEE Trans. Microwave Theory Tech., vol.47, No.8, Aug.1999.
[14] F. R. Yang, Y. Qian, T. Itoh, “A novel uniplanar compact PBG structure
for filter and mixer applications,” IEEE MTT-S Int. Microwave Symp.Dig , pp. 919-922, 1999.
[15] F. R. Yang, Y. Qian, T. Itoh, ”Characteristics of microstrip lines on a
uniplanar compact PBG ground plane,”1998 Asia Pacific Microwave
Conf. Dig., pp. 589-592, Dec. 1998
[16] Q.Xue, K.M. Shum, and C.H.Chan, ”Novel 1-D microstrip PBG cells,”
IEEE Microwave Guided Wave Lett., vol.10,pp.403-405,Oct.2000.
[17] Y. Q. Fu, G. H. Zhang, and N. C. Yuan, ”A novel PBG coplanar waveguide, ”IEEE Microwave and Wireless Compon. Lett., vol.11,No.11, Nov. 2001
[18] R. E. Collin, Foundations for Microwave Engineering, NewYork: Mc-Graw-Hill, 1966.
[19] V. Radisic, Y. Qian, T. Itoh, ”Novel architectures for high efficiency amplifier for wireless applications,” IEEE Trans. On Microwave Theory and Tech. vol. 46, No.11, pp.1901-1909, Nov. 1998.
[20] C. K. Wu, H. S. Wu, and C. K. C. Tzuang. “Electric-magnatic-electric slow-
wave microstrip line and bandpass filter of compress size,” IEEE Trans. On Microwave Theory and Tech.vol.50, No.8, Aug. 2002.
[21] IE3D User’s Manual 2000, release7, Zeland.
指導教授 丘增杰(Tsen-Chieh Chiu) 審核日期 2004-6-29
推文 facebook   plurk   twitter   funp   google   live   udn   HD   myshare   reddit   netvibes   friend   youpush   delicious   baidu   
網路書籤 Google bookmarks   del.icio.us   hemidemi   myshare   

若有論文相關問題,請聯絡國立中央大學圖書館推廣服務組 TEL:(03)422-7151轉57407,或E-mail聯絡  - 隱私權政策聲明