對稱式共面波導耦合線帶通濾波器

以作者查詢圖書館館藏

、以作者查詢臺灣博碩士

、以作者查詢全國書目

、勘誤回報

、線上人數：20

、訪客IP：3.133.12.172

姓名

高宗平(Tsung-Ping Kao) 查詢紙本館藏

畢業系所

通訊工程學系在職專班

論文名稱

對稱式共面波導耦合線帶通濾波器
(Symmetric CPW Coupled-Line Band-Pass Filters)

相關論文

★ 增強型異質結構高速移導率電晶體大信號模型之建立及其在微波放大器之應用	★ 空乏型暨增強型Metamorphic HEMT之製作與研究
★ 增強型與空乏型砷化鋁鎵/砷化銦鎵假晶格高電子遷移率電晶體: 元件特性、模型與電路應用	★ 氧化鋁基板上微波功率放大器之研製
★ 氧化鋁基板上積體化微波降頻器電路之研製	★ 順序特徵結構設計研究及其應用在特徵模子去耦合與最小特徵值靈敏度
★ 順序特徵結構設計研究及其應用在最大強健穩定度與最小迴授增益	★ LDMOS功率電晶體元件設計、特性分析及其模型之建立
★ CMOS無線通訊接收端模組之設計與實現	★ 積體化微波被動元件之研製與2.4GHz射頻電路設計
★ 異質結構高速移導率電晶體模擬、製作與大訊號模型之建立	★ 氧化鋁基板微波電路積體化之2.4 GHz接收端模組研製
★ 氧化鋁基板上積體化被動元件及其微波電路設計與研製	★ 二維至三維微波被動元件與射頻電路之設計與研製
★ CMOS射頻無線通訊發射端電路設計	★ 次微米金氧半場效電晶體高頻大訊號模型及應用於微波積體電路之研究

檔案

[Endnote RIS 格式]

[Bibtex 格式]

[相關文章]

[文章引用]

[完整記錄]

[館藏目錄]

[檢視]

[下載]

本電子論文使用權限為同意立即開放。
已達開放權限電子全文僅授權使用者為學術研究之目的，進行個人非營利性質之檢索、閱讀、列印。
請遵守中華民國著作權法之相關規定，切勿任意重製、散佈、改作、轉貼、播送，以免觸法。

摘要(中)

本論文針對對稱式共面波導耦合線帶通濾波器的理論、設計流程及實驗，做了詳細的研究。
此對稱架構，可視為傳統型四分之一波長電容電感耦合型帶通濾波器與帶磚型濾波器的結合。為了設計成對稱式結構，我們使用了非對稱的三線式共面波導耦合線來設計，因而不需要額外的磅線或空氣橋來抑制奇模態的產生，故在實現時製作簡單是其中一個優點。此外，由於採用四分之一波長共振機制，不但有電路面積縮小的優點，更因為電路佈局的關係，其產生的寄生效應可在濾波器的通帶兩側各置入一個傳輸零點，藉此改善通帶附近的止帶衰減，以期符合系統規格需要。
在論文中，我們針對不同的佈局方式作比較，對於末端短路耦合線中心線接地實現的問題，也利用佈局的方式解決。

摘要(英)

In this study, a class of symmetric CPW coupled-line bandpass filters is proposed. The proposed filters use the asymmetric three-line parallel-coupled CPW line and lump-element J- or K- inverters to realize symmetric CPW filter structures. Due to the symmetry, no bondwires or airbridges are required, which simplifies the fabrication process. The proposed filter structures are equivalent to quarter-wavelength resonator bandpass filters, such that they occupy only half the circuit area compared with the conventional ones, and the first spurious passbands of them occur at three times center frequency. In addition, by introducing the cross-coupling effect, two transmission zeros at the upper and lower stopbands can be created to further improve the selectivity. The working mechanisms of the proposed filters are described and design procedures are established in this thesis, so we can design the filter easily with the given specifications. Specifically, symmetrical CPW bandpass filters based on open-end and short-end parallel-coupled CPW line are designed and implemented, and the simulation results agree quite well with the measurement results.

關鍵字(中)

★ 共面波導
★ 濾波器

關鍵字(英)

★ CPW
★ filters

論文目次

第一章緒論 6
1.1 研究背景與動機 6
1.2 相關研究 9
1.3 論文架構 12
第二章濾波器基本理論 13
2.1 簡介 13
2.2 集總式濾波器 13
2.3 分散式濾波器 21
2.4 耦合線濾波器 33
第三章對稱式共面波導濾波器 38
3.1 簡介 38
3.2 等效電路 39
3.3 設計流程 44
3.4 特性分析 46
3.5 結論 52
第四章設計、製作與量測結果 53
4.1 簡介 53
4.2 非對稱式耦合線濾波器設計 54
4.3 對稱式末端開路耦合線濾波器設計 57
4.4 對稱式末端短路耦合線濾波器設計 64
4.5 結論 66
第五章結論 67
參考文獻 69

參考文獻

[1] C. P. Wen“Coplanar waveguide: A surface strip transmission line suitable for nonreciprocal gyromagnetic device application,＂ IEEE Transactions on Microwave Theory and Techniques, vol.17, pp.1087-1090, December 1969.
[2] M. Hourdart,“Coupled lines: Applications to broadband microwave integrated circuits,＂ in Proc. Sixth European Microwave Conference,pp.49-53, 1976.
[3] P. Holder,“X-band microwave integrated circuits using slotline and coplanar waveguide,＂ Radio Election. Eng, vol.48, pp.38-42, January 1978.
[4] M. Naghed, M. Rittweger and I. Wolff, “A new method for the calculation of the equivalent inductances of coplanar waveguide discontinuities,” IEEE MTT-S Int. Microwave Symp. Dig., 1991 pp.747-751.
[5] J. K. A. Everard and K. K. M . Cheng “High performance direct coupled bandpass filters on coplanar waveguide,” IEEE Trans. Microwave Theory Tech., vol. 41, pp.1568-1573, Sept. 1993.
[6]S. Uysal, “Copalanr waveguide edge-coupled bandpass filters with finite ground planes,” Electronics Letters, vol-30, No.22, pp. 1862-1863, Oct. 1994.
[7] F. L. Lin, C. W. Chiu, and R. B. Wu, “Coplanar waveguide bandpass filter a ribbon-of-brick-wall design,” IEEE Trans. Microwave Theory Tech., vol.47 pp.1589-1596, July 1995.
[8]F. Mernyei, I. Aoki, and H. Matsuura, “MMIC bandpass filter using parallel-coupled CPW lines,” Electronics Letters, vol-33, No.5, pp. 375-376,Feb. 1997.
[9] Hettak, K.; Dib, N.; Sheta, A.-F.; Toutain, S.; “A class of novel uniplanar series resonators and their implementation in original applications Microwave Theory and Techniques ,” IEEE Transactions on Volume 46, Issue 9, Sept. 1998 Page(s):1270 - 1276
[10] K. Hettak, N. Dib, A, Omar, G. Y. Delisle, M. Stubbs, and S. Toutain,“A useful new class of miniature CPW shunt stubs and its impact onmillimeter-wave integrated circuits,＂IEEE Transactions on Microwave and Techniques, vol.47, No.12, pp.2340-2349, December 1999.
[12] G. Matthaei, L. Young, and E. Jones, Microwave Filters, Impedance Matching Network, and Coupling Structures. Norwood, MA: Artech House,1980.
[13]David M. Pozar, “Microwave Engineering ,” Addison-Wesley Publishing Company, pp. 633-637, 1990.
[14] J.-S. Hong and M. J. Lancaster, Microstrip Filters for RF/Microwave Applications. New York: Wiley, 2001.
[15] M.B. Bazdar, A.R. Djordjevic, R.F. Harrington, and T.K. Sarkar, “Evaluation of quasi-static matrix parameters for multiconductor transmission lines using Galerkin's method,” IEEE Trans. Microwave Theory Tech., vol. MTT-42, July 1994, pp. 1223-1228.
[16] P.I. Richard,”Resistor-Transmission Line Circuits,” Proc.of the IRE, vol.36, pp.217-220, February 1948.
[17]Y.-S. Lin, C.-H. Wang, C.-H. Wu, and C. -H. Chen, “Novel compact parallel- coupled microstrip bandpass filter with lumped-element K-inverters,” IEEE Trans. Microwave Theory Tech., vol. 53, pp.2234-2238, July. 2005.
[18] Y.-S. Lin; M.-S. Hsu; C.-H. Wang; C.-H. Chen;”Millimeter-wave coplanar-waveguide parallel-coupled bandpass filters with lumped-element K-inverters” 2005 European Microwave Conference b Volume 2, 4-6 Oct. 2005 Page(s):4 pp.
[19] Yan, Y.-M.; Chang, Y.-T.; Wang, H.; Wu, R.-B.; Chen, C. -H., “Highly Selective Microstrip Bandpass Filters in Ka-Band,” European Microwave Conference, 2002. 32nd Oct. 2002 Page(s):1 – 4.
[20]許旻舜,”共面波導耦合線帶通濾波器”,國立台灣大學電信工程研究所碩士論文2004
[21]方國誌,”超寬頻共平面波導帶通濾波器之研製”,國立中央大學電機工程研究所碩士論文2006

指導教授

詹益仁(Y.J. Chan)

審核日期

2007-7-24

推文