||With the advance of Bluetooth wireless technology, built-in Bluetooth module products are increasing and Wireless Local Area Network are prevalent in recent years, it occurs the channels increasingly crowded in ISM 2.4G unlicensed band, so the quality or performance of Bluetooth RF transceiver is particularly important to reduce the effect. Bluetooth specifications defined a set of test conditions and parameter for Bluetooth radio standard, such as transmitter/ receiver’s signal output, co-channel interference, adjacent channel interference, Bit Error Rate performance, etc., to ensure the validity of Bluetooth design and quality certification. In this thesis, we propose an integrated test architecture and method which contains the main Bluetooth testers, spectrum analyzers, signal generators, multipath switch controller and software. By this proposed method, we can through the back-end software to control diverse configurations in original test case without replacing any connection settings of equipment in test environment and achieve automatic measurement and analysis of test result. Finally, we utilize one sample module to verify the experimental system and obtained the test results under multi-configurations, then analyze the accuracy and stability of integrated system.|
|| Bluetooth SIG, “http://www.bluetooth.com”.|
 Bluetooth SIG, Specification of the Bluetooth System v2.0+ EDR/v2.1 + EDR/3.0 + HS, Core System Package, Volume 2, Part A, 21 April 2009
 Kwok Y., Lau V. ,“Bluetooth WPAN”, Wireless Internet and Mobile Computing Interoperability and Performance, Pages: 285 -307, 2007
 ROHDE & SCHWARZ, Bluetooth Basics at a Glance Application Note 1MA108
 Anritsu MT8852B Bluetooth Test Set Operation Manual and Remote Programming Manual, April 2010.
 Agilent Technologies, “Performing Bluetooth RF Measurements Today Application Note 1333”.
 R&S FSL Spectrum Analyzer Operating Manual, V12 1300.2519.12-12.
 Anritsu CW69167B Synthesized Signal Generator Operation Manual
 K. Shuaib, M. Boulmalf, F. Sallabi, A. Lakas, “Performance analysis co-existence of IEEE 802.11g with Bluetooth”, Wireless and Optical Communications Networks, 2005. WOCN 2005. Second IFIP International Conference on, Pages: 40 – 44, 2005
 J.I.N. Hipolito, N.C. Arballo, J.A. Michel-Macarty, E.J. Garcia,"Bluetooth Performance Analysi s in Wireless Personal Area Networks", Electronics Robotics and Automotive Mechanics , 2009. CERMA ’’09, Pages: 38 – 43, 2009
 G. Betta, D. Capriglione, L. Ferrigno, and G. Miele., “Influence of Wi-Fi computer interfaces on RF measurement systems”, Virtual Environments, Human-Computer Interfaces and Measurement Systems, 2007. VECIMS 2007. IEEE Symposium, Pages: 99 – 104, 2007
 N. Golmie, R. E. VanDyck , A. Soltanian, A. Tonnerre, O. Rebala, “Interference Evaluation of Bluetooth and IEEE 802.11b Systems” National Institute of Standards and Technology , Page(s): 931 – 934, 2004.
 Wolfgang A., Orlenius C., Kildal P.-S., “Measuring Output Power of Bluetooth Devices in a Reverberation Chamber”, 2003 Antennas and Propagation Society International Symposium, Pages: 735 - 738 vol.4, 2003.