光碟機之動態研究與適應性尋軌誤差改善

以作者查詢圖書館館藏

、以作者查詢臺灣博碩士

、以作者查詢全國書目

、勘誤回報

、線上人數：79

、訪客IP：18.224.73.157

姓名

吳敏德(Min-Der Wu) 查詢紙本館藏

畢業系所

機械工程學系

論文名稱

光碟機之動態研究與適應性尋軌誤差改善
(Dynamic Investigation and Adaptive Tracking Error Improvement of an Optical Disk Drive)

相關論文

★ TFT-LCD前框卡勾設計之衝擊模擬分析與驗證研究	★ TFT-LCD 導光板衝擊模擬分析及驗證研究
★ 數位機上盒掉落模擬分析及驗證研究	★ 旋轉機械狀態監測-以傳動系統測試平台為例
★ 發射室空腔模態分析在噪音控制之應用暨結構聲輻射效能探討	★ 時頻分析於機械動態訊號之應用
★ VKF階次追蹤之探討與應用	★ 火箭發射多通道主動噪音控制暨三種線上鑑別方式
★ TFT-LCD衝擊模擬分析及驗證研究	★ TFT-LCD掉落模擬分析及驗證研究
★ TFT-LCD螢幕掉落破壞分析驗證與包裝系統設計	★ 主動式火箭發射噪音控制使用可變因子演算法
★ 醫學/動態訊號處理於ECG之應用	★ 具新型菲涅爾透鏡之超音波微噴墨器分析與設計
★ 醫用近紅外光光電量測系統之設計與驗証	★ 車用DVD光碟機之適應性聚焦伺服控制實現與應用

檔案

[Endnote RIS 格式]

[Bibtex 格式]

[相關文章]

[文章引用]

[完整記錄]

[館藏目錄]

至系統瀏覽論文 ( 永不開放)

摘要(中)

在提昇光碟機儲存密度及減少存取時間的趨勢下，負責承載碟片的主軸馬達將以極高倍速運轉，在高倍速運轉下的碟片容易激發出振動，其中碟片不平衡所引致之偏心振動在高倍速下更是明顯。
本研究以時頻圖來探討不同轉速下旋轉碟片的動態特性，由實驗結果之時頻圖可清楚看出碟片的偏心及與碟片自然頻率的調變現象，光碟機尋軌伺服為控制音圈馬達來移動讀寫頭，在碟片上的各資料軌讀取資料。如何在高倍速及旋轉碟片偏心所產生的干擾下，降低讀寫頭尋軌誤差並提昇其性能，研究中以適應性前饋干擾消除有效地抑制具有週期性的重複干擾，經由實驗結果顯示，具週期性的重複干擾在適應性前饋干擾消除下明顯地抑制了碟片偏心所產生的尋軌誤差。
攜帶方便，抽取容易是光碟機儲存資料最大的優點，在光碟片置入光碟機的同時，碟片偏心即已產生，當啓動光碟機後，碟片偏心所產生的不平衡，會增加讀寫頭的循尋誤差，希望本研究對消除碟片偏心所產生的循尋誤差能提供些許助益。

摘要(英)

The tracking servo of the optical disk drives is control a voice coil motor which moves a tracking actuator reaches to the data track for the pick up data. The disturbance influencing tracking error results from the eccentricity of the rotating disk in high speed. How to reduce the tracking error and improve tracking performance will be discussed. Adaptive feedforward cancellation (AFC) can effectively cancel the periodic disturbance. The experiment results show the AFC apparently eliminated the tracking error arising from the eccentricity of the rotating disk.

關鍵字(中)

★ 適應性尋軌誤差
★

關鍵字(英)

★ spectrogram
★ amplitude modulation
★ tracking error
★ tracking acturator
★ FXLMS
★ adaptive feedforward cancellation

論文目次

Abstract I
Contents II
List of Figures IV
List of Tables VI
Chapter 1 Introduction 1
1.1 Motivation 1
1.2 Literature Survey 2
1.3 Outline of the Thesis 4
Chapter 2 Theoretical Basis 5
2.1 Tracking Servo 5
2.1.1 Long Tracking 5
2.1.2 Short Tracking 6
2.2 Applied Signal Processing Techniques 6
2.2.1 Spectrogram 6
2.2.2 Amplitude Modulation 8
2.3 Adaptive Fliter 9
2.3.1 LMS Adaptive Filter 9
2.3.2 FXLMS Adaptive Filter 11
2.3.3 Adaptive Feedforward cancellation 12
2.4 AFC Tracking Control 14
2.5 System Identification 16
Chapter 3 Dynamic Characteristics of a Rotating Disk 20
3.1 Experimentation 20
3.2 Analysis and Discussion 21
3.3 Summary 26
Chapter 4 Adaptive Tracking Error Improvement 27
4.1 Experimental Setup 27
4.2 Experimental Circuit 29
4.3 BCB Control Interface and Parameters Setting 30
4.4 System Identification of the Actuator Model 32
4.5 Tracking Error Improvement 35
4.5.1 Simulation 35
4.5.2 Experimentation 38
4.6 Results and Discussion 41
Chapter 5 Conclusions 42
5.1 Concluding Remarks 42
5.2 Future Works 42
Bibliography 43

參考文獻

[Bodson et al. (1994)] M. Bodson, A. Sacks and P. Khosla, 1994, “Harmonic Generation in Adaptive Feedforward Cancellation Schemes,” IEEE Transactions Automatic Control, Vol. 39, No. 9, pp. 1939-1944.
[Hsia (1979)] T. C. Hsia, 1979, System Identification, Taipei: Lexington Books.
[Heo et al. (1999)] B. Heo and I. Y. Shen, 1999, “Taming Disk and Spindle Rocking by Damped Laminated Disks – An Experimental Study,” IEEE Transactions on Magnetics, Vol. 35, No. 5, pp. 2304-2306.
[Huang et al. (2002)] C. Huang, P. Chao and C. Sung, 2002, “An Intelligent Control Scheme for Enhancing Performance of the Automatic Ball-type Balancer Installed on High Speed Optical Disc Drives,” Proceedings of the 2002 IEEE International Symposium on Intelligent Control, pp. 19-24.
[Kempf et al. (1992)] C. Kempf, W. Messner, M. Tomizuka and R. Horowitz, 1992, “A Comparison of Four Discrete-Time Repetitive Control Systems,” Proceedings of the American Control Conference, pp. 2700-2704.
[Kuo et al. (1996)] S. M. Kuo and D. R. Morgan, 1996, Active Noise Control Systems, New York: Wiley.
[Kim et al. (1998)] S. Kim, G. Han and H. Son, 1998, “A Study of Characteristics of Disk Vibration and Rotating Airflow in Magneto Optical Disk Drives,” IEEE Transactions on Consumer Electronics, Vol. 44, No. 3, pp. 601-605.
[Lee et al. (1996)] J. Lee and W. Moorhem, 1996, “Analytical and Experimental Analysis of a Self-Compensating Dynamic Balancer in a Rotating Mechanism,” Journal of Dynamic Systems, Measurement, and Control, Vol. 118, pp. 468-475.
[Lee (1997)] H. S. Lee, 1997, “Implementation of Adaptive Feedforward Cancellation Algorithms for Pre-Embossed Rigid Magnetic Disks,” IEEE Transactions on Magnetics, Vol. 33, No. 3, pp. 2419-2423.
[Liu (1998)] 劉毓敏，1998，光盤機技術基礎教程，暨南師範大學，第一版。
[Liu et al. (1999)] C. Liu and W. Chen, 1999, “Signal Analysis of Focusing and Tracking Error for Optical Pick-up Head,” Master Thesis in Chinese, National Tsing Hua University.
[Lee et al. (2002)] S. Y. Lee, J. D. Kim and S. Kim, 2002, “Critical and Flutter Speeds of Optical Disks,“ Microsystem Technologies, Vol. 8, No. 2-3, pp. 206-211.
[Morgan (1980)] D. R. Morgan, 1980, “An Analysis of Multiple Correlation Cancellation Loops with a Filter in the Auxiliary Path,” IEEE Transactions on Acoustics, Speech and Signal Processing, ASSP-28, pp. 454-467.
[Oppenheim et al. (1989)] A. Oppenheim and R. Schafer, 1989, Discrete Time Signal Processing, 2th edition, Englewood Cliffs, NJ, Prentice-Hall.
[Onuki et al. (1998)] Y. Onuki, H. Ishioka and H. Yada, 1998, “Repeatable Runout Compensation for Disk Drives using Multi-loop Adaptive Feedforward Cancellation,” Proceedings of the 37th SICE Annual Conference, International Session Papers, pp. 1093-1098.
[Qian et al. (1996)] S. Qian and D. Chen, 1996, Time-Frequency Analysis - Methods and Applications, Upper Saddle River, NJ, Prentice-Hall.
[Sastry et al. (1989)] S. Sastry and M. Bodson, 1989, Adaptive Control: Stability, Convergence, and Robustness, Englewood Cliffs, NJ, Prentice-Hall.
[Sacks et al. (1995)] A. Sacks, M. Bodson and W. Messner, 1995, “Advanced Methods for Repeatable Runout Compensation,” IEEE Transactions on Magnetics, Vol. 31, No. 2, pp. 1031-1036.
[Widrow et al. (1975)] B. Widrow, J. R. Glover, J. M. McCool, J. Kaunitz, C. S. Williams, R. H. Hern, J. R. Zeidler, E. Dong and R. C. Goodlin, 1975, “Adaptive Noise Canceling: Principles and Applications,” Proceedings of the IEEE, Vol. 63, No. 12, pp. 1692-1716.
[Widrow et al. (1981)] B. Widrow, D. Shur and S. Shaffer, 1981, “On Adaptive Inverse Control,” Proceedings 15th Asilomar Conference, pp. 185-189.
[Widrow et al. (1985)] B. Widrow and S. D. Stearns, 1985, Adaptive Signal processing, Englewood Cliffs, NJ, Prentice-Hall.
[Weerasooriya et al. (1996)] S. Weerasooriya, J.L. Zhang and T.S. Low, 1996, “Efficient Implementation of Adaptive Feedforward Runout Cancellation in a Disk Drive,” IEEE Transactions on Magnetics, Vol. 32, No. 5, pp. 3920-3922.
[Zhang et al. (2000)] J. Zhang, R. Chen, G. Guo and T. Low, 2000, “Modified Adaptive Feedforward Runout Compensation for Dual-Stage Servo System,” IEEE Transactions on Magnetics, Vol. 36, No. 5, pp. 3581-3584.

指導教授

潘敏俊(Min-Chun Pan)

審核日期

2004-7-19

推文