多孔介質指形流實驗

以作者查詢圖書館館藏

、以作者查詢臺灣博碩士

、以作者查詢全國書目

、勘誤回報

、線上人數：251

、訪客IP：3.149.27.33

姓名

張奐文(Huan-wen Chang) 查詢紙本館藏

畢業系所

機械工程學系

論文名稱

多孔介質指形流實驗

相關論文

★ 溫度調變對二元合金固液介面形態穩定的影響	★ 濃度調變對二元合金固液介面形態穩定的影響
★ 圓錐平板型生物反應器週期性流場研究	★ 圓錐平板型生物反應器二次週期流場研究
★ 圓錐平板型生物反應器脈動式流場研究	★ 濃度調變對單向固化形態穩定的影響
★ 圓錐平板型生物反應器脈動式二次流場研究	★ 模擬注流式生物反應器之流場及細胞生長
★ 週期式圓錐平板裝置之設計與量測	★ 模擬注流式生物反應器之細胞培養研究
★ 軟骨細胞在組織工程支架之培養研究	★ 細胞在組織工程支架之生長與遷移
★ 冷電漿沉積類鑽碳膜之製程模擬分析	★ 格狀自動機探討組織工程細胞體外培養研究
★ 細胞在注流式生物反應器之生長研究	★ 週期式圓錐平板裝置之流場分析

檔案

[Endnote RIS 格式]

[Bibtex 格式]

[相關文章]

[文章引用]

[完整記錄]

[館藏目錄]

[檢視]

[下載]

本電子論文使用權限為同意立即開放。
已達開放權限電子全文僅授權使用者為學術研究之目的，進行個人非營利性質之檢索、閱讀、列印。
請遵守中華民國著作權法之相關規定，切勿任意重製、散佈、改作、轉貼、播送，以免觸法。

摘要(中)

本文以適用於徑向流動的修正毛細數來分析流動不穩定現象。利用不同顆粒直徑釔鋯球構成多孔介質，進行矽油與空氣在不同孔徑的二維Hele-Shaw多孔介質中相互推動的實驗。藉由改變顆粒直徑與注入流率來觀察流動過程，並透過壓力計量測不同注入流量對應的壓力與時間關係。本實驗觀察到三種流動型態：穩定移動、毛細指形與黏性指形。
由矽油（大黏度）推動空氣（小黏度）的實驗結果可以發現，矽油皆穩定的往出口端移動，矽油與空氣介面為維持平整的穩定移動的流動過程，且對於不同注入流量，此特性的結果一致。
由空氣（小黏度）推動矽油（大黏度）的實驗結果可以發現，提升修正毛細數可使毛細指形轉變為黏性指形。在相同注入流量條件，較小顆粒直徑構成的多孔介質結構對應的修正毛細數較高，故較容易隨著流量的增加而產生指形轉換。

摘要(英)

This research presents the modified capillary number for determining the fingering instability in radial flow. Experiments were conducted using the silicon oil and air pushing each other in the two dimensional Hele-Shaw porous media of different pore sizes. Two kinds of zirconia particles with different average diameters of 1 mm and 0.1 mm respectively were used to form different pore sizes. The processes of flow were recorded by a CCD camera and the pressures of the pushing fluid were monitored by installing a pressure sensor at the fluid inlet for different particle sizes and injection rates.
Results showed that three flow regimes could be identified from the experiments: stable displacement, capillary finger and viscous finger. In the case of silicon oil (large viscosity) pushing air (small viscosity), silicon oil was continuously moving towards the outlet. The silicon oil and the air maintained a stable and smooth interface during the entire flow course at different injection rates and pore sizes. Oppositely when air (small viscosity) was used to push silicon oil (large viscosity), two flow types were observed, which could be referred to as the capillary fingering and the viscous fingering flows. The capillary fingers dominated by the capillary pressure transited into the viscous fingers dominated by the viscous force as the modified capillary numbers were increased. The small pore size corresponded to a higher modified capillary number in the same injection rates, so the fingering transition occurred more easily for the small pore size than the big one.

關鍵字(中)

★ 多孔介質
★ 指形不穩定
★ 毛細壓力
★ 黏性效應

關鍵字(英)

論文目次

摘要 i
Abstract ii
目錄 iii
表目錄 v
圖目錄 vi
符號說明 viii
第一章緒論 1
1-1 二氧化碳封存 1
1-2 文獻回顧 3
1-2-1 純流體指形不穩定現象 3
1-2-2 多孔介質指形不穩定現象 4
1-3 研究目的 6
第二章實驗方法 10
2-1 注入與被排移流體實驗系統系統 10
2-1-1 測試段 10
2-1-2 注射泵 10
2-1-3 影像觀測裝置 10
2-1-4 實驗流體 11
2-2 量測設備 11
2-2-1 壓力量測 11
2-2-2 資料擷取系統 12
2-3 實驗步驟 12
2-3-1 矽油推動空氣實驗 12
2-3-2 空氣推動矽油實驗 13
第三章結果與討論 17
3-1 矽油推動空氣實驗 17
3-1-1 實驗結果 17
3-1-2 推估滲透度k值 18
3-2 空氣推動矽油實驗 19
3-2-1 修正毛細數(Modify capillary number) 19
3-2-2 實驗結果 20
第四章結論與未來展望 57
參考文獻 58

參考文獻

Furuberg, L., Måløy, K. J. and Feder, J., 1996, "Intermittent behavior in slow drainage," Physical Review E, Vol. 53, pp. 966- 977.
Garcia, J. E. and Pruess, K., 2008, "Flow instabilities during injection of CO2 into saline aquifers." Lawrence Berkeley National Laboratory.
Hill, S., 1952, "Channeling in Packed Colums, " Chemical Engineering Science, Vol. 1, pp.247- 253.
Holtzman, R., Szulczewski, M. L. and Juanes, R., 2012, "Capillary fracturing in granular media, " Physical review letters, Vol. 108, pp. 264504.
IPCC, 2005：IPCC Special report on carbon dioxide capture and storage.
IEA, 2008：CO2 Capture and Storage-A Key carbon abatement option.
Lenormand, R., Touboul, E. and Zarcone, C., 1988, "Numerical models and experiments on immiscible displacements in porous media," Journal of fluid mechanics, Vol. 189, pp. 165- 187.
Løvoll, G., Méheust, Y., Toussaint, R., Schmittbuhl, J. and Måløy, K. J., 2004, "Growth activity during fingering in a porous Hele-Shaw cell," Physical Review E, Vol. 70, pp. 026301.
Løvoll, G., Jankov, M., Måløy, K. J., Toussaint, R., Schmittbuhl, J., Schäfer, G. and Méheust, Y., 2011, "Influence of viscous fingering on dynamic saturation–pressure curves in porous media," Transport in porous media, Vol. 86, pp. 305- 324.
Måløy, K. J., Furuberg, L., Feder, J. and Toussaint, R., 1992, "Dynamics of slow drainage in porous media," Physical review letters, Vol. 68, pp. 2161- 2164.
Nordbotten, J. M., Celia, M. A. and Bachu, S., 2005, "Injection and storage of CO2 in deep saline aquifers: Analytical solution for CO2 plume evolution during injection," Transport in Porous media, Vol. 58, pp. 339- 360.
Paterson, L., 1981, "Radial fingering in a Hele Shaw cell," Journal of Fluid Mechanics, Vol. 113, pp. 513- 529.
Pruess, K. and Garcia, J., 2002, "Multiphase flow dynamics during CO2 disposal into saline aquifers," Environmental Geology, Vol. 42, pp. 282- 295.
Saffman, P. G. and Taylor, G., 1958, "The penetration of a fluid into a porous medium or Hele-Shaw cell containing a more viscous liquid," Proceedings of the Royal Society of London. Series A. Mathematical and Physical Sciences, Vol. 245, pp. 312- 329.
Stokes, J. P., Weitz, D. A., Gollub, J. P., Dougherty, A., Robbins, M. O., Chaikin, P. M. and Lindsay, H. M., 1986, "Interfacial stability of immiscible displacement in a porous medium," Physical review letters, Vol. 57, pp. 1718- 1721.
Zimmerman, R.W., 2002, "Fluid Flow in Porous Media," MSc in Petroleum Engineering - Imperial College London, London.
吳榮章，2008，減碳話題─談二氧化碳地下封存，台北市政府主計處廉政電子報，第22期，第1-3頁。

指導教授

鍾志昂(Chih-Ang Chung)

審核日期

2014-8-27

推文