 |
|
|
|
以作者查詢圖書館館藏 、以作者查詢臺灣博碩士 、以作者查詢全國書目 、勘誤回報 、線上人數：25 、訪客IP：3.138.134.221
姓名 鄒宇翔(Yu-Saing Tsou) 查詢紙本館藏 畢業系所 土木工程學系 論文名稱 橋梁碰撞實驗與效應研究 相關論文 檔案 [Endnote RIS 格式]
[相關文章]
[文章引用]
[完整記錄]
[館藏目錄]
[檢視]
- 本電子論文使用權限為同意立即開放。
- 已達開放權限電子全文僅授權使用者為學術研究之目的，進行個人非營利性質之檢索、閱讀、列印。
- 請遵守中華民國著作權法之相關規定，切勿任意重製、散佈、改作、轉貼、播送，以免觸法。
摘要(中) 本研究橋梁碰撞實驗為研究目標。在受震後橋梁因碰撞而造成之破壞，目前已有許多相關研究及其成果，然而以往的研究成果均水平橋梁為主，尚未有具坡度橋碰撞效應之研究。實際上，高架橋匝道、高架道路跨越橋、山區地形變化處之橋梁、橋面坡度變化大，甚可達10%。坡度對橋梁碰撞之效應及結構動力之反應，目前仍未有文獻可探討。因此本研究設計小型之具坡度鋼橋模型，進行振動台試驗，並利用SAP2000建立有限元素數值分析模型。試驗結果與數值分析結果相較，驗證模擬碰撞之有限元素分析模型之準確性，確認有限元素模型準確後，利用此分析模型假設碰撞彈簧勁度。結果顯示，地表振幅之增加，地表加速度增加，橋面板位移增加，碰撞力亦增加。碰撞彈簧勁度與碰撞力成正比關係，並隨碰撞力增加而增加之趨勢。每回合碰撞中有數次小碰撞現象，且小碰撞次數隨地表振幅加大而增加，但隨頻率增加而減少。
摘要(英) In this study, the bridge collision experiment as study target. In the failure of the bridge after the earthquake due to the collision caused many related research at present, and its results, however the previous research results are mainly horizontal bridge, no studies with collision effect slope bridge. In fact, the viaduct, viaduct across the ramp bridge, mountainous terrain change at the bridge, the bridge deck slope changes, even up to 10%. The effect of slope on the bridge collision reaction and structure of power, at present there is no literature study. Therefore this research design small with slope steel bridge model, the shaking table test, and use SAP2000 to establish the finite element numerical analysis model. Results compared with the results of numerical analysis, verify the finite element simulation analysis of the collision model accuracy, confirm the accurate finite element model, using this analysis model assumes that the impact spring stiffness. The results showed, increase the ground surface acceleration amplitude, increase, the deck displacement increase, the collision force is increased. Impact spring stiffness proportional to the collision force, collision force and with increasing trend. There are several small collision phenomenon in each round of collision, and the small collision frequency amplitude increases with the surface of the earth, but with the increase of frequency and reduce the.
關鍵字(中) ★ 具坡度橋
★ 碰撞彈簧勁度
★ 簡諧震波
★ 碰撞次數關鍵字(英) ★ inclined decks, impact spring stiffness, harmonic wave, the number of collisions 論文目次 圖目錄.................................................................................................................III
表目錄..............................................................................................................XXI
第一章 緒論......................................................................................................... 1
1.1 研究背景與動機.......................................................................................... 1
1.2 文獻回顧...................................................................................................... 2
1.2.1 碰撞理論與數值模型 ........................................................................... 3
1.2.2 碰撞實驗................................................................................................ 6
1.2.3 碰撞現象探討........................................................................................ 7
1.3 研究架構...................................................................................................... 9
第二章 理論分析............................................................................................. 11
2.1 前言............................................................................................................ 11
2.2 碰撞彈簧數值模型.................................................................................... 11
2.3 有限元素分析............................................................................................ 12
2.3.1 有限元素分析模型建置 ..................................................................... 12
2.3.2 有限元素分析方法.............................................................................. 13
第三章 橋梁碰撞模型振動台詴驗規劃......................................................... 17
3.1 前言............................................................................................................ 17
3.2 實驗模型詴體............................................................................................ 17
3-3 實驗測量儀器與配置 ............................................................................... 18
3-4 實驗詴體系統識別 ................................................................................... 18
3-5 輸入震波 ................................................................................................... 19
第四章 詴驗結果與討論................................................................................. 26
4.1 前言............................................................................................................ 26
4.2 橋梁模型詴驗結果與數值分析比較........................................................ 26
4.3 碰撞效應與碰撞彈簧勁度探討................................................................ 27
第五章 結論與建議......................................................................................... 55
5.1 結論............................................................................................................ 55
參考文獻............................................................................................................. 56
附錄 A................................................... 60參考文獻 [1] Kawashima, K. and Penzien, J (1979), ”Theoretical and Experimental Dynamic Behaviour of a Curved Model Bridge Structure,” Earthquake Engineering and Structural Dynamics, Vol. 7, pp.129-145.
[2] Stavros A. Anagnostopoulos (1988), ”Pounding of Buildings In Series During Earthquakes,” Earthquake Engineering and Structural Dynamics, Vol.16, pp.443-456.
[3] Jankowski,R. Wilde, K. and Fujino,Y. (1998), ”Pounding of Superstructure Segments in Isolated Elevated Bridge During Earthquakes,” Earthquake Engineering and Structural Dynamics, Vol.27, pp.487-502.
[4] Chau, K. T. and Wei, X. X. (2001), ”Pounding of Structures Modelled as Non-Linear Impacts of Two Oscillators,” Earthquake Engineering and Structural Dynamics, Vol.30, pp.633-651.
[5] Zhu, P., Abe, M. and Fujino, Y. (2002), ” Modelling Three-Dimensional Non-Linear Seismic Performance of Elevated Bridges With Emphasis on Pounding of Girders,” Earthquake Engineering and Structural Dynamics, Vol.31, pp.1891-1913.
[6] Muthukumar, S. (2003), ” A Contact Element Approach with Hysteresis Damping for the Analysis and Design of Pounding In Bridges,” PhD Thesis, Georgia Institute of Technology, U.S.A..
[7] DesRoche, R. and Muthukumar, S. (2003), ” Implications of Seismic Pounding on the Longitudinal Response of Multi-Span Bridges – an Analytical Perspective” Earthquake Engineering and Engineering Vibration, Vol.3, No.1, pp.1-9.
[8] Watanabe, G. and Kawashima, K. (2004), ”Numerical Simulation of Pounding of Bridge Decks,” 13th World Conference on Earthquake Engineering, Paper No. 884 (CD-ROM), Vancouver, B.C., Canada.
[9] Stavros A. Anagnostopoulos (2004), ”Equivalent Viscous Damping for Modeling Inelastic Impacts in Earthquake Pounding Problems,” Earthquake Engineering and Structural Dynamics.; Vol.33, pp.897-902.
[10] Zhu, P., Abe, M. and Fujino, Y. (2004), ”Parameters in Bridge Restrainer Design for Seismic Retrofit,” Earthquake Engineering and Structural Dynamics, Vol.33, pp.591-609.
[11] Jankowski, R. (2005), ”Non-Linear Viscoelastic Modelling of Earthquake-Induced Structure Pounding,” Earthquake Engineering and Structural Dynamics, Vol34, pp.595-611.
[12] Muthukumar, S. and DesRoches, R. (2005), ”Effect of Frame-Restoring Force Characteristics on the Pounding Response of Multiple-Frame Bridges,” Earthquake Spectra, Vol.21, No.4, pp.1113-1135.
[13] Muthukumar, S. and DesRoches, R. (2006), ”A Hertz Contact Model with Non-linear Damping for Pounding Simulation,” Earthquake Engineering and Structural Dynamic. Vol.35, pp.815-828
[14] Chau, K.T., Wei, X.X., Guo, X. and Shen, C.Y. (2003), “Experimental and Theoretical Simulations of Seismic Poundings between Two Adjacent Structures,” Earthquake Engineering and Structural Dynamics, Vol.32, pp.537-554.
[15] Guo, A.X., Li, Z.J., Li, H.I. and Ou, J.P. (2009), ”Experimental and Analytical Study on Pounding Reduction on Base-Isolated Highway Bridges using MR Dampers,” Earthquake Engineering and Structural Dynamics.
[16] 李忠獻、張勇、岳福青 (2007)，〝地震作用下隔震簡支梁碰撞反應的振動台試驗〞，地震工程與工程震動，第27卷，第2期。
[17] Saiidi, M., Maragakis, E. and Feng, S. (1996), ”Parameters in Bridge Restrainer Design for Seismic Retrofit,” Journal of Structural Engineering, ASCE, Vol.122, No.19, pp.61-68.
[18] Kawashima, K. and Shoji, G. (1999), ”Effectiveness of Rubber Type Restrainer to Mitigate Pounding Effect Between Adjacent Deck during an Strong Earthquake,” Journal of Structure Mechanics and Earthquake Engineering, JSCE, No.612/I-46, pp. 129-142.
[19] Kawashima, K. and Shoji, G. (2000), ”Effect of Restrainers to Mitigate Pounding Between Adjacent Decks Subjected to A Strong Ground Motion,” 12th World Conference on Earthquake Engineering, Paper No. 1435 (CD-ROM), Auckland, New Zealand.
[20] Jankowski, R., Wilde, K. and Fujino, Y. (1998) ”Pounding of Superstructure Segments in Isolated Elevated Bridge During Earthquakes,” Earthquake Engineering and Structural Dynamics., Vol27, pp.487-502.
[21] Ruangrassamee, A. and Kawashima, K. (2001), ”Relative Displacement Response Spectra with Pounding Effect,” Earthquake Engineering and Structural Dynamics., Vol30, pp.1511-1538.
[22] DesRochesand, R. and Muthukumar, S. (1998) ”Effect of Pounding and Restrainers on Seismic Response of Multiple-Frame Bridges,” Journal of Structural Engineering, pp.860-869.
[23] Matsumoto. T., Kawashima, K. and Watanabe, G. (2007), ”Seismic Response of 3-Span Bridge Considering the Effect of Failure of Bearings,” Journal of Structural Engineering, JSCE, Vol. 53A, pp. 503-512.
[24] 聶利英、李建中、胡世德、范立礎 (2004)，〝曲線橋梁非線性分析及抗震性能評估〞，同濟大學學報，第32卷，第10期。
[25] 李建中、范立礎 (2005)，〝非規則橋梁縱向地震反應及碰撞效應〞，土木工程學報，第32卷，第10期。
指導教授 李姿瑩(Tzu-Ying Lee) 審核日期 2015-1-30 推文 plurk
funp
live
udn
HD
myshare
netvibes
friend
youpush
delicious
baidu
網路書籤 Google bookmarks
del.icio.us
hemidemi
facebook
twitter
google
reddit