非晶矽射極異質雙載子電晶體與有機發光二極體的特性

以作者查詢圖書館館藏

、以作者查詢臺灣博碩士

、以作者查詢全國書目

、勘誤回報

、線上人數：32

、訪客IP：3.147.86.143

姓名

白豐榮(Fong-Jung Pai ) 查詢紙本館藏

畢業系所

電機工程研究所

論文名稱

非晶矽射極異質雙載子電晶體與有機發光二極體的特性
(Characteristics of a-Si:H Emitter HBT and Polymer LED)

相關論文

★ 金屬-半導體-金屬光偵測器的特性	★ 非晶質氮化矽氫基薄膜發光二極體與有機發光二極體的光電特性
★ 具非晶質n-i-p-n層之氧化多孔矽發光二極體的光電特性	★ 低漏電流與高崩潰電壓大面積矽偵測器製程之研究
★ 具自行對準凹陷電極1x4矽質金屬-半導體-金屬光偵測器陣列的特性	★ 吸光區累崩區分離的累崩光二極體
★ 蕭特基源/汲極接觸的反堆疊型非晶質矽化鍺薄膜電晶體	★ 矽晶圓上具有隔離氧化層非晶質薄膜發光二極體之光電特性
★ 具非晶異質接面及溝渠式電極之矽質金屬-半導體-金屬光偵測器的暗電流特性	★ 非晶矽/晶質矽異質接面矽基金屬-半導體-金屬光檢測器與具非晶質無機電子/電洞注入層高分子發光二極體之研究
★ 具非晶質矽合金類量子井極薄障層之高靈敏度平面矽基金屬–半導體–金屬光檢測器	★ 具蕭特基源/汲極的上閘極型非晶矽鍺與多晶矽薄膜電晶體
★ 大面積矽偵測器的製程改良與元件設計	★ 具組成梯度能隙非晶質矽合金電子注入層與電洞緩衝層的高分子發光二極體
★ 非晶質吸光區與累增區分離之類超晶格累崩光二極體	★ 具非晶質矽合金調變週期類超晶格薄膜複層之低暗電流高熱穩定度平面矽基金屬–半導體–金屬光檢測器

檔案

[Endnote RIS 格式]

[Bibtex 格式]

[相關文章]

[文章引用]

[完整記錄]

[館藏目錄]

[檢視]

[下載]

本電子論文使用權限為同意立即開放。
已達開放權限電子全文僅授權使用者為學術研究之目的，進行個人非營利性質之檢索、閱讀、列印。
請遵守中華民國著作權法之相關規定，切勿任意重製、散佈、改作、轉貼、播送，以免觸法。

摘要(中)

首要利用射極非晶矽的光能隙約為1.8 eV 及基極單晶矽的光能隙為1.12 eV會在射極及基極之間形成能帶不連續而製作非晶矽射極異質接面雙載子電晶體。欲使元件的操作速度提昇至GHz以上，基極的接面深度需越淺越好，但是此舉也會提高射極對基極的夾止電阻及基極本身的電阻，因而造成元件VBEon 電壓升高，增益值過高，集極與基極間易穿透及製程不易控制等缺點。本論文中把非晶矽射極及單晶矽基極高摻雜以提供足夠的QE、適當的QE/QB及10~60 kΩ的夾止電阻與基極本身的電阻，以獲得低製作成本的異質接面雙載子電晶體，並利用快速退火製程觀察非晶矽轉變成複晶矽時對元件特性的影響。
由於形成基極接面後的製程並無高溫製程，基極接面深度可控制在很淺的範圍，預期可以得到一低製作成本的高速元件。
本研究的另一主題是結合非晶質薄膜與有機聚合物發光材料研製有機發光二極體(PLED)。元件結構係以P-型非晶質矽膜(p-a-Si:H)取代傳統的聚合物電洞注入層，並以N-型非晶質鍺化矽碳膜(n-a-SiCGe:H)作為電子注入層。在N-型非晶質鍺化矽碳膜中含高成分鍺的PLED，其臨限電壓為14.3 V，而當電流密度為 300 mA/cm2時，發光亮度可達6450 cd/m2。

摘要(英)

In a-Si:H emitter heterojunction bipolar transistors (HBT's), a heavily phosphorous-doped n-a-si:H was used as a wide-bandgap emitter material. Since the optical gap of a-Si:H is about 1.8 eV and the bandgap of c-Si is 1.12eV, respectively, so a band-gap discontinuity could be formed between emitter and base. In a HBT the shallower the base junction depth is, the higher the device operation speed, the base resistance, and hence the device VBE, and current gain are. A shallow base junction also decrease the VCE breakdown voltage due to punch-through. Therefore, in this study, the a-Si:H emitter layer and p-type c-Si:H base region were highly doped to obtain sufficient QE , suitable QE/QB, and base resistance which was around 10~60 kΩ. The transition from n-a-Si:H to n-type poly-silicon emitter would be performed by the later used of rapid thermal annealing. The employed base junction depth could be shallow since there was no high temperature process after base junction was formed by using ion implantation. A low-cost , high-speed HBT which was compatible with conventional BJT process was expected.
Also, the EL (electroluminescence) characteristics of the polymer LEDs (PLEDs) having amorphous carrier injection layers had been investigated. The p-a-Si:H and n-a-SiCGe:H films were used as the hole and electron injection layers, respectively in these in these PLEDs to replace the conventional organic carrier injection layers. A peak brightness of 6450 cd/m2 at an injected cur

關鍵字(中)

★ 有機發光二極體
★ 異質接面電晶體
★ 非晶矽

關鍵字(英)

★ amorphous
★ HBT
★ oled

論文目次

摘要………………………………………………………………III
表目………………………………………………………………IV
圖目……………………………………………………………….V
第一章緒論……………………………………………………..1
第二章非晶矽射極異質接面雙載子電晶體…………………..3
第三章有機薄膜發光二極體…………………………………26
第四章結論……………………………………………………54
參考文獻……………………………………………………………55

參考文獻

[1] H. Kroemer, “Heterostructure Bipolar Transistors and Integrated Circuits,” Proc. IRE, 45, 1535 1957.
[2] S. M. Sze, Physics of Semiconductor Devices, 2nd ed., New York, 1981.
[3] M. Konagai and K. Takahashi, “GaAlAs-GaAs Heterojunction Transistors with High Injection Efficiency,” J. Appl. Phys., vol. 46, p. 2120, 1975.
[4] E. J. Zhu, “Non-crystalline Emitter Transistors, ” Acta Electron. Sinica, vol. 7, no. 1, pp. 77-82, 1979.
[5] T. Matsushita, N. oh-uchi, H. Hayashi, and H. Yamoto, ”A Silicon Hetrojunction Transistor,” Appl. Phys. Lett., vol. 35, pp. 549-550, 1979.
[6] M. Ghannam, J. Nijs, R. Dekeersmaecker, and R. Mertens, “A Silicon Bipolar Transistor with a Hydrogenated Amorphous Emitter,” in IEDM Tech. Dig., pp. 746-748, 1984.
[7] K. Sasaki, M. M. Rahman, and S. Furukawa, “ An Amorphous SiC:H Emitter Heterojunction Bipolar Transistor,” IEEE Electron Device Lett., vol. EDL-6, no. 6, pp. 311-312, 1985.
[8] M. Takagi, K. Nakayama, C. Tevada, and H. Kamioko, “ Improvement of Shallow Base Transistor Technology by Using a Doped Polysilicon Diffusion Sorce,” J. Japan. Soc. Appl. Phys., vol. 42, pp. 101-109, 1972.
[9] Y. S. Wang, c. K. Xiong, W. W. sheng, and E. J. Zhu, “Recent Advances in Hydrogenated Amorphous Silicon Emitters for Microwave Bipolar Transistors,” Research Progress SSE (in Chinese), vol. 9, no. 1, pp. 109~110, 189.
[10] J.H. Burroughes, D.D.C. Bradley, A.R. Brown, R.N. Marks, K. MacKay, R.H. Friend, P.L. Burn, and A.B. Holmes, “Light-Emitting Diodes Based on Conjugated Polymers,” Nature, 347, pp 539-541, Oct. 11, 1990.
[11] D. Braun and A. J. Heeger, ”Visible Light Emission from Semiconducting Polymer Diodes,” Appl. Phys. Lett., vol. 58, no. 18, pp. 1982-1984, May 6, 1991.
[12] H. H. Kim, R. G. Swartz, Y. Ota, T. K. Woodward, M. D. Feuer, and W. Wilson, “Prospects for Silicon Monolithic Opto-electronics with Polymer Light Emitting Diodes,” J. Lightwave Technol., this issue, pp. 21114-2121.
[13] E. J. Zhu et al., “A High Current Gain Si HBT with a Hydrogenated microcrystalline Si emitter,” in IEDM Tech. Dig., pp. 190-193. 1987
[14] Technology Modeling Associates, Inc., TMA MEDICI Two-Dimensional Device Simulation Program.
[15] R. Street, Hydrogenated Amorphous Silicon. Cambridge, UK: Cambridge Univ. Press, 1991.
[16] J. Kanicki, Amorphous and Microcrystalline Semiconductor Devices, Volume Π: Materials and Device. Boston, MA: Artech, 1992.
[17] C.Z. Wu, “Organic Thin-Film Light-Emitting Diodes─Techniques and Application in Flat-Display,” Electronics Information, vol.4, no.2, pp 4-12, 1996.
[18] Y. Yang, and A.J. Hegger, “Carrier Injection into Semiconducting Polymers: Fowler-Nordheim Field-Emission Tunneling,” Appl. Phys. Lett., 64, pp.1245, 1994.
[19] S. Karg, J.C. Scott, J.R. Salem, and M. Angelopoulos, “Increased Brightness and Lifetime of Polymer Light-Emitting Diodes with Polyaniline Anodes,” Synthetic Metals, 80, pp.111-117,1996.
[20] J. Tanc, Amorphous and Liquid Semiconductors, chap. 5, Plenum Press, pp. 175, 1974.

指導教授

洪志旺(Jyh-Wong Hong)

審核日期

2001-7-9

推文