Improvement of wire electrical discharge machining efficiency in machining polycrystalline silicon with auxiliary-pulse voltage supply

NCU Institutional Repository > 工學院 > 機械工程學系 > 期刊論文 > Item 987654321/50241

jsp.display-item.identifier=請使用永久網址來引用或連結此文件: http://ir.lib.ncu.edu.tw/handle/987654321/50241

题名:	Improvement of wire electrical discharge machining efficiency in machining polycrystalline silicon with auxiliary-pulse voltage supply
作者:	Yu,PH;Lin,YX;Lee,HK;Mai,CC;Yan,BH
贡献者:	機械工程學系
关键词:	SINGLE-CRYSTAL SILICON;SURFACE-ROUGHNESS;SOLAR-CELLS;TECHNOLOGY;WEDM;EDM;MACHINABILITY;OPTIMIZATION;PARAMETERS;RESISTANCE
日期:	2011
上传时间:	2012-03-27 17:07:25 (UTC+8)
出版者:	國立中央大學
摘要:	This study proposes a novel pulse voltage configuration, auxiliary-pulse voltage, for wire electrical discharge machining (WEDM) of polycrystalline silicon (polysilicon) used in solar cell production. It is developed with the objectives of reducing material waste due to the large kerf loss as well as achieving greater efficiency and better quality compared with conventional machining approaches. Experimental results show that compared with conventional-pulse voltage supply, the auxiliary-pulse voltage mode can avoid delay in electrical discharge during pulse-on time. Enhanced frequency of effective discharge for machining would increase machining speed, which would in turn reduce machining groove width, and obtain better surface roughness. In addition, parameters of significant influence on machining characteristics were examined with the Taguchi method, and the optimal combination levels of machining parameters were determined. In sum, our findings reveal that WEDM with auxiliary-pulse voltage supply is an effective approach to machining polysilicon with good quality and high efficiency achieved.
關聯:	INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY
显示于类别:	[機械工程學系] 期刊論文

文件中的档案:

档案	描述	大小	格式	浏览次数
index.html		0Kb	HTML	502	检视/开启

在NCUIR中所有的数据项都受到原著作权保护.

社群 sharing

数据加载中.....