姓名 |
陳建安(Jian-an Chen)
查詢紙本館藏 |
畢業系所 |
土木工程學系 |
論文名稱 |
廢棄電路板非金屬成分資源化於水泥混凝土之探討 (Waste printed circuit board non-metallic composition resources in the cement concrete)
|
相關論文 | |
檔案 |
[Endnote RIS 格式]
[Bibtex 格式]
[相關文章] [文章引用] [完整記錄] [館藏目錄] [檢視] [下載]- 本電子論文使用權限為同意立即開放。
- 已達開放權限電子全文僅授權使用者為學術研究之目的,進行個人非營利性質之檢索、閱讀、列印。
- 請遵守中華民國著作權法之相關規定,切勿任意重製、散佈、改作、轉貼、播送,以免觸法。
|
摘要(中) |
本研究係以廢棄印刷之電路板非金屬粉料(WPCB粉),進行相關資源化運用之研究,其資源化方向主要為在泡沫水泥砂漿及輕質粒料混凝土產品中,部分取代天然細粒料。
WPCB粉應用於泡沫水泥砂漿,其天然細粒料取代率若超過50%會對新拌性能產生影響,對硬固性能的影響則隨著WPCB粉取代率增加而下降,但在取代率達50%之後下降趨勢逐漸和緩。
WPCB粉應用於輕質粒料混凝土,在水灰比=0.6之條件下,其新拌性能在天然細料料取代率10%以內影響不大,若取代率超過10%則需要添加強塑劑,以改善工作性不佳的問題;強塑劑添加量至水泥粉體重量0.75% ,即可使輕質粒料混凝土接近控制組之工作性,但對於WPCB粉取代率30%以上之配比,即便添加強塑劑也無法改善工作性不佳的問題。
因添加WPCB粉對於泡沫水泥砂漿與輕質粒料混凝土之新拌工作性能會造成影響,故建議於泡沫水泥砂漿中之WPCB粉取代率不宜超過50%,而輕質粒料混凝土中則不宜超過25%。
|
摘要(英) |
In this study, (WPCB, which is short for) the non-metallic fractions of waste printed circuit board, is used as resource in related practices. The direction of the practices is focused on partial replacement of natural fine aggregates in the cellular mortar and the lightweight aggregate concrete products.
WPCB in the use of cellular mortar, if the replacement ratio of natural fine aggregates is over 50%, the property of new mixture will be effected. However, the effect on the property of robustness eases whilst the replacement ratio increases. The decreasing trend gradually moderates until after the ratio reaches 50%.
WPCB in the use of lightweight aggregate concrete, under the condition of water-cement ratio=0.6, the replacement ratio within 10% has no obvious effect on property of new mixture; however, if the replacement ratio rises over 10%, in order to improve the working performance, adding the superplasticizer is needed. As soon as the adding of superplasticizer reaches 0.75% of the weight of the concrete, the working performance of the lightweight aggregate concrete is close to the control group. To the composition of which the WPCB replacement ratio reaches above 30%, even the adding of superplasticizer does not help with improving the working performance.
Because adding WPCB affects the property of new mixture of cellular mortar and lightweight aggregate concrete, it is recommended that the replacement ratio of WPCB do not rise above 50% for cellular mortar, and 25% for lightweight aggregate concrete.
|
關鍵字(中) |
★ 輕質粒料混凝土 ★ 泡沫水泥砂漿 ★ 廢棄印刷電路板 ★ WPCB |
關鍵字(英) |
★ lightweight aggregate concrete ★ cellular mortar ★ waste printed circuit board ★ WPCB |
論文目次 |
目錄 I
圖目錄 IV
表目錄 X
第一章 緒論 1
1.1 研究動機 1
1.2研究內容與目的 1
第二章 文獻回顧 4
2.1 廢棄印刷電路板(Waste Printed Circuit Board;WPCB) 4
2.1.1 廢棄印刷電路板的來源、成分及產量 4
2.1.2 廢棄印刷電路板的處理途徑與資源化技術 5
2.2泡沫水泥砂漿 11
2.2.1泡沫水泥砂漿製作方法及應用 11
2.2.2 起泡劑種類以及基本性質 13
2.2.3 泡沫之穩定性 15
2.3 輕質粒料混凝土 18
2.3.1輕質粒料混凝土種類及應用 20
第三章 試驗規劃 22
3.1 實驗流程及參數 22
3.1.1 實驗流程 22
3.1.2 實驗參數 29
3.2 試驗材料 35
3.3 實驗設備與儀器 42
3.4 試驗項目及方法 47
3.4.1 WPCB粉之基本性質試驗 47
3.4.2 起泡劑性能相關試驗 49
3.4.3 WPCB粉製泡沫水泥砂漿及輕質粒料混凝土相關試驗 50
第四章 研究成果 56
4.1 廢棄印刷電路板非金屬廢料基本性質試驗 56
4.1.1 WPCB粉末外觀 56
4.1.2 試驗材料物性分析 57
4.1.3卜作嵐強度活性指數 60
4.1.4 成分含量分析 61
4.2 WPCB粉製成泡沫水泥砂漿之研究 62
4.2.1 起泡劑性能評估方法 63
4.2.2 泡沫水泥砂漿新拌性質 68
4.2.3 泡沫水泥砂漿硬固性質 79
4.3 WPCB粉製成輕質粒料混凝土之研究 95
4.3.1 WPCB粉製成輕質粒料混凝土之新拌性質探討 96
4.3.2 WPCB粉製成輕質粒料混凝土之工作性改善探討 98
第五章 結論與建議 100
5.1 結論 100
5.2 建議 103
參考文獻 104
|
參考文獻 |
1.經濟部工業局,「印刷電路板業資源化應用技術手冊」, 2009。
2.蘇彥賓,「事業廢棄物查核輔導案例-印刷電路板製造業」,工研院環安中心 ,2001。
3.鄭智和,「廢印刷電路板及邊料資源化技術」,工研院環安中心,廢棄物處理與資源化研究組,台灣環保產業專欄,第十六期,P8~9 ,2002。
4.行政院環保署,廢棄物管制中心 IWMS系統,http://waste1.epa.gov.tw/iwms/。
5.江奇成, 「廢印刷電路板粉料應用於低強度管線回填材料之研究」,東南科技大學營建科技系,2008。
6.江奇成、黃秀隆、黃兆龍,「廢PCB版中玻璃纖維應用於水泥基材之性質研究」,技師月刊,第51期,P. 97~102,2008。
7.侯正蘭,「PCB板廢粉料取代細粒料與飛灰對CLSM性質影響之研究」,東南科技大學防災科技研究所碩士論文,2007。
8.顏保儀,「PCB摻料應用於用於一般營建混凝土工程之研究」,國立台北科技大學土木與防災研究所碩士論文,2010。
9.黃錫泉,「樹脂粉替代細骨材對混凝土特性之研究」,國立海洋大學材料工程研究所碩士論文,2002。
10.林志賢, 「起泡劑特性及配比對泡沫混凝土工程性質影響之研究」,國立海洋大學河海工程學系碩士論文,2000。
11.曾漢東,「利用起泡技術拌製控制性低強度複合材料之研究」,
國立海洋大學河海工程學系碩士論文,2004。
12.內政部建築研究所籌備處專題研究計畫成果報告,「輕質混凝土在國內發展之研究」,1992。
13.閆振甲、何豔君,「泡沫混凝土實用生產技術」,中國,化學工業出版社,2006。
14.劉冠德「泡沫水泥材料微觀結構與其剪力行為之關係」,國立成功大學土木研究所,碩士論文,1995。
15.林玉茹「高相對密度泡沫水泥之熱學性質研究」,國立成功大學土木工程研究所,碩士論文,1998。
16. K.C. Brady and M.J. Greene, “Foamed Concrete: A review of materials, methods of production and applications”, the UK’’s Transport Research Laboratory, 1997.
17.G.R.A. Watts and K.C., “Brady assessment of the use of foamed concrete as backfill to retaining structures”, the UK’’s Transport Research Laboratory, 1999.
18.K.C. Brady, “An investigation into the properties of foamed concrete”, the UK’’s Transport Research Laboratory, 2000.
19.K.C. Brady, G.R.A. Watts and IVI R Jones,“Specification for foamed concrete”, the UK’’s Transport Research Laboratory, 2001.
20. L.J. Gibson and M.F. Ashby, “Cellular solids:structure & properties” , Pergamon press, Oxford, 1988.
21. T.P. Tonyan and L.J. Gibson, “Structure and mechanics of cement forms” , Journal of Material science, Vol.27, 1992.
22.趙承琛 編著,界面科學基礎,復文書局,1993。
23.刈米孝夫 原著,王鳳英 編繹,「界面活性劑的原理與應用」,高立圖書有限公司,1993。
24.劉新明、崔元臣,「界面聚合及其應用進展」,化學研究,第17 卷第1 期, p. 101-104, 2006。
25.曹恒光、連大成,「淺談微乳液」 , 物理雙月刊,第23卷第4期,2001。
26.廖明隆,「界面化學與界面活性劑」,文源書局, P. 1~26,二版,台北市,1994。
27.賴耿陽「界面活性劑應用實務」,復漢出版社,P. 85~90,一版,台南市,1999。
28.Helgesen, and K. Hakon, “The use of high performance lightweight aggregate concrete in Norwegian marine structures”, International Symposium on Structural Lightweight Aggregate Concrete, Norway, June 1995.
29.H.S. Wilson and M. Malhotra, “Development of high strength lightweight concrete for structural”, International Journal of Cement Composites and Lightweight Concrete, 1988.
30.林龍傑,「輕質骨材裏漿技術及應用於瀝青混凝土鋪面績效之研究」,國立台灣科技大學營建工程系碩士論文,2008。
31.王順元、蔡文博、劉得弘,「國內外輕質骨材混凝土之應用與介紹」,國立中興大學土木工程系,水利土木科技資訊季刊45期。
32.楊宗岳、陳豪吉、蔡文博,「台灣輕質骨材混凝土之發展與應用」,國立中興大學土木工程系,臺灣公路工程第36卷第3期。
|
指導教授 |
李釗(Chau Lee)
|
審核日期 |
2012-7-23 |
推文 |
facebook plurk twitter funp google live udn HD myshare reddit netvibes friend youpush delicious baidu
|
網路書籤 |
Google bookmarks del.icio.us hemidemi myshare
|