半固態鎂合金流變特性之分析與研究

以作者查詢圖書館館藏

、以作者查詢臺灣博碩士

、以作者查詢全國書目

、勘誤回報

、線上人數：24

、訪客IP：18.227.190.231

姓名

廖俊忠(Jun-Zhong Liao) 查詢紙本館藏

畢業系所

機械工程學系

論文名稱

半固態鎂合金流變特性之分析與研究
(The research of the rheological of the semi-solid Mg alloy)

相關論文

★ 鋰鋁矽酸鹽之負熱膨脹陶瓷製程	★ 鋰鋁矽酸鹽摻鈦陶瓷之性質研究
★ 高功率LED之熱場模擬與結構分析	★ 干涉微影之曝光與顯影參數對週期性結構外型之影響
★ 週期性極化反轉鈮酸鋰之結構製作與研究	★ 圖案化藍寶石基板之濕式蝕刻
★ 高功率發光二極體於自然對流環境下之熱流場分析	★ 液珠撞擊熱板之飛濺行為現象分析
★ 柴式法生長氧化鋁單晶過程最佳化熱流場之分析	★ 柴式法生長氧化鋁單晶過程晶體內部輻射對於固液界面及熱應力之分析
★ 交流電發光二極體之接面溫度量測	★ 柴氏法生長單晶矽過程之氧雜質傳輸控制數值分析
★ 泡生法生長大尺寸氧化鋁單晶降溫過程中晶體熱場及熱應力分析	★ KY法生長大尺寸氧化鋁單晶之數值模擬分析
★ 外加水平式磁場柴氏法生長單晶矽之熱流場及氧雜質傳輸數值分析	★ 大尺寸LED晶片Efficiency Droop之光電熱效應研究

檔案

[Endnote RIS 格式]

[Bibtex 格式]

[相關文章]

[文章引用]

[完整記錄]

[館藏目錄]

[檢視]

[下載]

本電子論文使用權限為同意立即開放。
已達開放權限電子全文僅授權使用者為學術研究之目的，進行個人非營利性質之檢索、閱讀、列印。
請遵守中華民國著作權法之相關規定，切勿任意重製、散佈、改作、轉貼、播送，以免觸法。

摘要(中)

摘要
本研究的目的在於探討鎂合金AZ91D在半固態時的流變行為。實驗中，利用可在高溫下量測黏度的同心圓柱流變計為量測設備。由實驗結果發現，在穩態實驗中，視黏度會隨著攪拌時間的增長而漸漸變小，並在達到一個最小值後，又會隨著攪拌時間的增長而漸漸變大。而在等溫停留時間實驗中，不同的初始攪拌時間會對接下來的停留時間的視黏度有顯著的影響。在較短的初始攪拌時間時，視黏度會隨著停留時間的延長而漸漸變大；相反的，當給予較長的初始攪拌時間時，視黏度反而會隨著停留時間的延長而漸漸變小。
在暫態實驗中，當剪應變率驟升或驟降時，剪應力也會隨著驟升或驟降，且破裂時間會比回復時間短。而當固相分率比較大時，所對應的剪應力值也會變大，且破裂時間也會變長。且當末剪應變率驟升的幅度比較大時，其所相對應的剪應力值驟升的幅度也會隨著變大，且破裂時間將會縮短；相反的當末剪應變率驟升的幅度比較小時，其所相對應的剪應力值驟升的幅度也就比較小，且破裂時間將會拉長。

摘要(英)

Abstract
In this study, the rheological behavior of the semi-solid AZ91D magnesium alloy is researched by a high-temperature Couette type viscometer. The results show that the apparent viscosity of semi-solid AZ91D alloy decrease initially as the isothermal stirring time increase and achieve a minimum value and start increasing in steady state. And the different time of stirring before resting also affects striking on the apparent viscosity. The apparent viscosity was gradually increased as the resting time increased when the shorter stirring time. But the apparent viscosity gradually decreased as the resting time increased when the melt was isothermally stirred for the longer stirring time. And the solid fraction also has greatly influence the apparent viscosity. The apparent viscosity increases with increasing resting time as the higher solid fraction. And the apparent viscosity decreases with increasing resting time as the lower solid fraction. But it has not greatly influence the apparent viscosity when the very low solid fraction.
At transient experimentation, the breakdown time is then described for a shear-rate jump from a lower shear rate to a higher shear rate and the recovery time is described for a shear rate drop from a higher to a lower shear rate. In this study, the recovery time is found to be longer than the breakdown time and the breakdown time is found to be longer at the higher solid fraction. The breakdown time is also found to be shorter as the range of the final shear rate jumps is big.

關鍵字(中)

★ 流變

關鍵字(英)

★ Rheological

論文目次

目錄頁碼
中文摘要……………………………………………….…………………………….Ⅰ
英文摘要……………………………………………….…………………………….II
誌謝…………………………………..………………………………………………III
目錄…………………………………………………….………………………….…IV
圖表目錄………………………………………………………………..…..……..VI
符號說明…………………………………………………………………………....VIII
第一章導論………………………...……………………………………………...1
1.1 背景………………….……...………………………………………………….1
1.2 文獻回顧………………………………………………………………………...2
1.3 研究動機………………………………………………………………………...3
第二章理論基礎……………………………………………….…………………...4
2.1 半固態材料成形之原理…………………………………………………….....4
2.2 半固態材料的製造方法…………………………………………………...…..5
2.3 半固態材料成形技術之類型之流動特性………………………………….....7
2.4 半固態材料的流動特性…………………………………………………..…...9
2.5 固相分率對流動的影響………………………………………………..……..10
2.6 晶粒形狀對流動的影響…………………………………………………...….11
2.7 攪拌因素對流動的影響……………………………………………………....12
第三章實驗設備……………………………………………………………….....13
3.1 量測系統………………………………………………………………..……..13
3.2 測矩系統…………………………………………………………..…………..15
3.3 恆溫系統……………………………………………………………..………..15
3.4 實驗材料……………………………………………………………..………..16
第四章實驗方法…………..……………………………………………………...19
4.1 實驗一: 探討等溫連續攪拌時間對視黏度的影響…………………....…..19
4.2 實驗二: 探討在停留時間之前不同的攪拌時間對於視黏度的影響………..19
4.3 實驗三: 在停留時間之前控制初始的攪拌時間改變不同的固相分率對於視
黏度的影響………….….……….…….…………………………………...…...20
4.4 實驗四: 剪應變率的瞬間改變對鎂合金AZ91D 暫態行為的影
響………………………………………………………………………...…….....20
第五章結果與討論……………………………..…………………….……......20
5.1.1 不同減應變率於等溫連續攪拌時間對於視黏度的影響………….……...21
5.1.2 不同固相分率於等溫連續攪拌時間對於視黏度的影響………… ….…..21
5.2 在停留時間之前給予不同的初始攪拌時間對於視黏度的影響………......22
5.3 在停留時間之前控制初始的攪拌時間改變不同的固相分率對於視黏度的
影響………………………………………………………………………..……....23
5.4.1 剪應變率的瞬間改變對鎂合金AZ91D 暫態行為的影響.………………...24
5.4.2 固相分率對鎂合金AZ91D 暫態行為的影響……………………………....25
5.4.3 改變不同末剪應變率對於半固態鎂合金暫態行為的影響…………….….25
第六章結論………………………………..……………….……………………..26
參考文獻………………………………………………………………….………...28

參考文獻

參考文獻
1. S. A. Metz and M. C. Flemings, Trans. Am. Foundrymens’s Soc. 77 ,329 (1969)
2. M. C. Flemings, ‘‘Behavior of metal alloys in the semisolid state’’, MetallurgicalTransaction, 22. 957(1991)
3. D. B. Spencer, R. Mehrabian, and M. C. Flemings, ‘‘Rheological behavior of
Sn-15 Pct Pb in the crystallization range’’, Metallurgical Transaction, 3.
1925(1972)
4. Y. S. Yang, C. Y. Tsao, ‘‘Viscosity and structure variations of Al-Si alloy in the semi-solid state’’, Journal Materials Science, 32. 2087(1997)
5. K. Sukumaran, B. C. Pai, M. Chakraborty, ‘‘The effect of isothermal
mechanical stirring on an Al–Si alloy in the semisolid condition’’, Materials science and engineering A, 369. 275(2004)
6. D. Ghosh, R. Fan, and C. VanSchilt, ‘‘Thixotropic properties of semi-solid
magnesium alloy AZ91D and AM50’’, The 3rd Int’l Conf. on Semi Solid
Processing of Alloy and Composites(1994).
7. J. C. Gebelin, M Suery, and D. Favier, ‘‘Characterization of the Rheologicalbehavior in the semi-solid state of grain-refined AZ91D magnesium alloys’’,Materials science and engineering A, 272. 134(1999)
8. W. Mao, S. Yan, Z. Zhen, ‘‘Thixotropic properties of semi-solid AZ91D
magnesium alloy’’, Acta metallurgica sinica, 41. 191(2005)
9. H. A. Barnes, J. F. Hutton, and K. Walters, An Introduction to Rheology,
Eleservier(1989)
10. L. S. Turng, and K. K. Wang, ‘‘Rheological behavior and modeling of semi-solidSn-15%Pn alloy’’, Journal of materials science, 26. 2173(1991)
11. 賴耿陽, 非鐵金屬材料, 復漢出版社, 新竹, 174 (1998)
29
12. ASM, Magnesium Alloys, Metals handbook 9th Edition, 6. 425(1985)
13. P. A. Joly, and R. Mehrabian, ‘‘The rheology of a partially solid alloy’’, Journalof materials science, 11. 1393 (1976)
14. C. D. Yim, K. S. Shin, ‘‘Changes in microstructure and hardness of rheocastAZ91HP magnesium alloy with stirring conditions’’, Materials science andengineering A, 395. 226 (2005)
15. W. Mao, Z. Zhen, ‘‘Rheological behavior of semi-solid AZ91D alloy’’, J. Mater.Sci. Technol. 20. 580(2005)
16. C. C. Mao, J. C. Chen, H. Peng and M. L. Chang, ‘‘Steady-state rheologicalbehavior of semi-solid AZ91D magnesium alloy’’, journal of the chinese societyof mechanical engineers, 24. 385 (2003)
17. H. Peng, Ph. D. Dissertation, Cornell University (1995)
18. A. R. A. Mclelland, N. G. Henderson, H. V. Atkinson and D. H. Kirkwood ,
‘‘Anomalous rheological behaviour of semi-solid alloy slurries at low shear
rates’’, Materials Science and Engineering A, 232. 110(1997)
19. T. Y. Liu, H. V. Atkison, ‘‘Response of semi-solid Sn-15 Pct Pb to rapid
shear-rate changes’’, Metallurgical and Materials Transactions A, Vol.34A,
pp.409-417 (2003)
20. M. Modigell and J. Koke, ‘‘Time-Dependent rheological properties of semi-solidmetal alloys’’, Mechanics of Time-dependent Materials, 3. 15(1999)

指導教授

陳志臣(J. C. CHEN)

審核日期

2006-7-8

推文