Study on the turning characteristics of alumina-based ceramics

NCU Institutional Repository > 工學院 > 機械工程研究所 > 期刊論文 > Item 987654321/27082

請使用永久網址來引用或連結此文件: http://ir.lib.ncu.edu.tw/handle/987654321/27082

題名:	Study on the turning characteristics of alumina-based ceramics
作者:	Yan,BH;Huang,FY;Chow,HM
貢獻者:	機械工程學系
關鍵詞:	N/A
日期:	1995
上傳時間:	2010-06-29 18:07:16 (UTC+8)
出版者:	中央大學
摘要:	In this study, the machinability of advanced ceramics sintered at three different sintering temperatures is investigated. The results show that although pre-sintered (1300 degrees C/30 min) ceramics can be machined with both carbide tools and ceramic tools, the tools sustain significant levels of tool wear after a very short period of machining. The best overall performance is achieved by using the diamond tool; the latter also being found to be essentially the only tool which can be used to machine the fine-sintered (1500 degrees C/30 min) ceramics. In addition, it is found that when cutting ceramics with a coolant or using a sucker to suck the chip from out of tool face, results in more severe tool wear than does dry cutting. The effect is contrary to that normally expected and would appear to be largely due to the chip discharge not proceeding smoothly. However, when tool face near to the cutting edge is heated and sucked, the tool wear can be improved significantly.
關聯:	JOURNAL OF MATERIALS PROCESSING TECHNOLOGY
顯示於類別:	[機械工程研究所] 期刊論文

文件中的檔案:

檔案	描述	大小	格式	瀏覽次數
index.html		0Kb	HTML	589	檢視/開啟

在NCUIR中所有的資料項目都受到原著作權保護.

社群 sharing