具正交相位輸出之低電壓操作同步複製延遲電路;A Low Supply Voltage Synchronous Mirror Delay with Quadrature Phase Output

NCU Institutional Repository > 資訊電機學院 > 電機工程研究所 > 博碩士論文 > Item 987654321/54543

jsp.display-item.identifier=請使用永久網址來引用或連結此文件: http://ir.lib.ncu.edu.tw/handle/987654321/54543

题名:	具正交相位輸出之低電壓操作同步複製延遲電路;A Low Supply Voltage Synchronous Mirror Delay with Quadrature Phase Output
作者:	許智勛;Hsu,Chih-hsun
贡献者:	電機工程研究所
关键词:	低電壓;多相位輸出;同步複製延遲電路;時脈同步電路;multiphase;clock synchronous circuit;synchronous mirror delay;low voltage
日期:	2012-07-23
上传时间:	2012-09-11 18:53:30 (UTC+8)
出版者:	國立中央大學
摘要:	摘要本論文提出一個具正交相位時脈輸出之低電壓操作同步複製延遲電路晶片設計。此電路將在前3 個週期執行粗調動作，爾後的8 個週期完成細微調整，藉由兩階段的調整達到時脈同步的功能。細微調整可以進一步降低同步時脈的靜態相位誤差，並且採用環形動態調整機制，能夠讓時脈在同步後，仍能保有動態追鎖的校正功能。另外，透過兩階段邊緣偵測器與正交可調延遲電路，重複利用延遲量測電路，提供了一個與同步時脈訊號相差了90 度相位的正交相位輸出，建立一組I/Q 通道。本電路將可適用於低電壓時脈同步與資料傳送的應用，如生醫訊號感測系統。因其採全數位低電壓操作進行設計，並將可適用於單晶片系統設計。本論文之同步複製延遲電路使用TSMC 90 nm 1P9M CMOS 製程實現晶片，電路操作電壓為0.5 V，其操作頻率範圍可從220 MHz 到570 MHz，同步時脈間之相位誤差≦100.5 ps，正交同步時脈間之相位誤差≦144.4 ps。在操作頻率為570 MHz 時，功率消耗為1.95 mW。而內部時脈輸出訊號之最大峰對峰值時間抖動量為31.78 ps (1.81%)，方均根抖動量為3.99 ps，正交相位輸出訊號之最大峰對峰值時間抖動量為34.67 ps(1.97 %)，方均根抖動量為4.48 ps。整體晶片面積為517 × 594 um2，核心電路的面積為188 × 171 um2。AbstractA low supply voltage synchronous mirror delay circuit with quadrature phaseclock output is proposed. The coarse tune operation of this clock synchronous circuitis accomplished in five cycles, and then the fine tune operation is also accomplishedin following eight cycles. Therefore, the clock signal is synchronized by the two stepoperations. The fine tune operation not only can reduce the static clock phase errorbut also can dynamic calibrate the synchronized clock by using a ring circuit. The twostep edge detector and the quadrature variable delay line are use in the proposedSMD to generate a quadrature phase output, which is lagging from the synchronousinternal clock with a 90° phase shift. The quadrature phase output is useful for lowvoltage clock synchronous and data transmission application, like biomedical signalsensor network. The proposed SMD is using the all-digital circuit design and operatingat low supply voltage, thus it is suitable for system-on-chip (SoC) systems application.The experimental chip was fabricated by TSMC 90 nm 1P9M CMOS process.The chip is operating at 0.5 V supply voltage. The static phase error betweensynchronous clocks is less than 100.5 ps, furthermore the static phase error betweenquadrature clocks is less than 144.4 ps. The measurement results show that theoperation range is from 220 MHz to 570 MHz, and the power consumption is 1.95 mWat 570 MHz. The peak-to-peak jitter and RMS jitter of internal clock are 31.78 ps and3.99 ps at 570 MHz, respectively. The peak-to-peak jitter and RMS jitter of quadratureinternal clock are 34.67 ps and 4.48 ps at 570 MHz, respectively. The whole chip areais 517 × 594 um2, and the core area is 188 × 171 um2.
显示于类别:	[電機工程研究所] 博碩士論文

文件中的档案:

档案	描述	大小	格式	浏览次数
index.html		0Kb	HTML	431	检视/开启

在NCUIR中所有的数据项都受到原著作权保护.

社群 sharing

数据加载中.....