English  |  正體中文  |  简体中文  |  全文筆數/總筆數 : 80990/80990 (100%)
造訪人次 : 41625424      線上人數 : 1962
RC Version 7.0 © Powered By DSPACE, MIT. Enhanced by NTU Library IR team.
搜尋範圍 查詢小技巧:
  • 您可在西文檢索詞彙前後加上"雙引號",以獲取較精準的檢索結果
  • 若欲以作者姓名搜尋,建議至進階搜尋限定作者欄位,可獲得較完整資料
  • 進階搜尋


    請使用永久網址來引用或連結此文件: http://ir.lib.ncu.edu.tw/handle/987654321/84264


    題名: 整合蕭特基p型氮化鎵閘極二極體與加強型p型氮化鎵閘極高電子遷移率電晶體之新型電晶體;A New Transistor by Integrating Schottky P-GaN Gate Diode and P-GaN Gate AlGaN/GaN HEMT
    作者: 賴育辰;Lai, Yu-Chen
    貢獻者: 電機工程學系
    關鍵詞: 氮化鎵;p型氮化鎵;高電子遷移率電晶體;二極體;GaN;p-GaN;HEMT;Diode
    日期: 2020-08-24
    上傳時間: 2020-09-02 18:34:37 (UTC+8)
    出版者: 國立中央大學
    摘要: 相較於單一HEMT,SPGD-HEMT擁有較低的閘極漏電流,在VGS = 10 V、VDS = 0 V時降低約10倍。在轉換特性與輸出特性方面,SPGD-HEMT之臨界電壓VTH提升了約0.1 V,同時保持了差不多的汲極電流與導通電阻。反向導通能力方面,在ID = 1 mA/mm、VGS = -4 V時反向導通電壓降低了約2.3 V,可降低元件閘極關閉時的反向導通損耗。在電容特性方面,SPGD-HEMT在輸入電容、輸出電容、逆向轉換電容皆明顯的降低,減少元件在切換時的損耗。動態切換方面,隨著汲極關閉電壓增加時,SPGD-HEMT之動態導通電阻增加幅度較低,顯示其在高壓切換時更具優勢。元件之崩潰電壓在基板浮接時HEMT為929 V,SPGD-HEMT為1209 V,提升約280 V。在閘極崩潰量測方面,在閘極施加一定電壓(VGS = 10, 11 V),HEMT之閘極崩潰時間約為32 s與473 s,但在相同條件下,SPGD-HEMT能持續6000 s而沒有發生閘極崩潰。;Comparing with the conventional HEMT, the SPGD-HEMT has smaller gate leakage, which has decreased about 10 times at VGS = 10 V, VDS = 0 V. In terms of transfer characteristic and output characteristic, the SPGD-HEMT a larger VTH, while keeping the similar drain current and RON. The SPGD-HEMT also shows better reverse conduction capability. The reverse turn on voltage of SPGD-HEMT is decreased by 2.3 V at ID = 1 mA/mm, VGS = -4 V, which means that SPGD-HEMT has less reverse conduction loss. In C-V measurement, the Ciss and Crss of the SPGD-HEMT are significantly decreased due to the SPGD connected to the gate of HEMT. In dynamic switching measurement, with the increase of VDS.OFF, the SPGD-HEMT shows less increase in the dynamic RON, showing the advantage in high voltage switching. With substrate floating, the device breakdown voltage of HEMT is 929 V, while the device breakdown voltage of the SPGD-HEMT is increased to 1209 V. In gate breakdown measurement, the gate of the device is constantly stressed (VGS = 10, 11 V). The conventional HEMT has the gate breakdown time of 32 s and 473 s, while the SPGD-HEMT does not show gate breakdown under the same gate stress even the gate stress time is over 6000 s.
    顯示於類別:[電機工程研究所] 博碩士論文

    文件中的檔案:

    檔案 描述 大小格式瀏覽次數
    index.html0KbHTML150檢視/開啟


    在NCUIR中所有的資料項目都受到原著作權保護.

    社群 sharing

    ::: Copyright National Central University. | 國立中央大學圖書館版權所有 | 收藏本站 | 設為首頁 | 最佳瀏覽畫面: 1024*768 | 建站日期:8-24-2009 :::
    DSpace Software Copyright © 2002-2004  MIT &  Hewlett-Packard  /   Enhanced by   NTU Library IR team Copyright ©   - 隱私權政策聲明