ELECTRICAL-DISCHARGE MACHINING CHARACTERISTICS OF CONDUCTIVE ALUMINA-BASED CERAMICS

NCU Institutional Repository > 工學院 > 機械工程研究所 > 期刊論文 > Item 987654321/27098

jsp.display-item.identifier=請使用永久網址來引用或連結此文件: https://ir.lib.ncu.edu.tw/handle/987654321/27098

题名:	ELECTRICAL-DISCHARGE MACHINING CHARACTERISTICS OF CONDUCTIVE ALUMINA-BASED CERAMICS
作者:	YAN,BH;TSAI,DC
贡献者:	機械工程學系
关键词:	N/A
日期:	1994
上传时间:	2010-06-29 18:07:41 (UTC+8)
出版者:	中央大學
摘要:	In order to reveal the electrical discharge machining characteristics of electrical conductive alumina based ceramics, a series of EDM tests are carried out. The following main results are obtained. (1) The surface roughness of ceramics machined with negative polarity is larger than that with positive polarity. (2) When machining ceramics with small current, compared with positive polarity, the material removal rate of negative polarity is larger and the electrode wear ratio is smaller. But when machining with large current, the relation is reversed. (3) When machining with short pulse and negative polarity, the recast layer is thinner and almost no crack is observed because of the impact force caused between the workpiece and electrode is larger than positive polarity. (4) Compared with normal EDM, material removal rate machined with orbital motion of an electrode is higher, but the surface roughness and the electrode wear ratio are worse. But when the orbital distance of an electrode increases, the surface roughness and the electrode wear ratio are improved remarkably.
關聯:	JOURNAL OF THE JAPAN INSTITUTE OF METALS
显示于类别:	[機械工程研究所] 期刊論文

文件中的档案:

档案	描述	大小	格式	浏览次数
index.html		0Kb	HTML	473	检视/开启

在NCUIR中所有的数据项都受到原著作权保护.

社群 sharing